S1500
High efficiency wide input voltage
PFC programmable Power supply
90V~2 5VAC input
10V~25VDC output
0Amps 1500W max.
www.chargery.com
page
4
total
8
Press DEC or INC b ttons alternate different items, and press STOP SET to q it the set p men .
Note:
All parameters will be remembered by the S1500 till next change.
After increase set p voltage, if act al voltage doesn’t increase, please enter into program set p
men , and then increase the maximal c rrent limitation.
After increase maximal c rrent imitation, if act al c rrent limitation doesn’t increase, please
increase set p voltage val e.
Yo can set p all parameters on power on and power off stat s at any time. Voltage can be set p
press DEC or INC b tton directly, b t other items m st be enter into the set p men and then
change it.
At any time yo can press the STOP SET b tton t rn off the power s pply, S1500 will work in idle
mode to save power cons mption till disconnect the S1500 to the AC o tlet. Generally yo needn’t
disconnect S1500F from AC o tlet, beca se the S1500 cons me nder 1W power at idle mode.
When yo need power yo r load s ch as charger etc. what yo do is press the START ENTER b tton
Set p the maximal o tp t c rrent, range from 5A~60A, step
1A, defa lt 60A. The maximal c rrent can protect yo r
charger or loads from damaging.
Max c rrent
---> 60A
Set p the Temperat re nit,
℃or ℉,
defa lt
℃
.
Temp. Unit
--->
℃
Set p the working mode of fan, Options: Long life, Normal
and Low noise. Long Life means the fan will start at lower
temp. to extend the nit life. Low Noise means the fan start
at higher temp. it will ca se a low noise at light load. Normal
is defa lt set p, the fan start at middle temp. level.
Fan Mode
---> Normal
The beeper so nds for each b tton press to confirm yo r
action. A beeper so nds at vario s times d ring operation to
alert the ser to mode changes. These so nds can be ON or
OFF.
Key Beeper
--->
ON
This men sets the back-light time of LCD screen backlight.
Options: 1MIN, 5MIN, 10MIN, 20MIN and Always on,
default 5MIN. At defa lt 5min, LCD back-light will be off to
save the power, press any button can turn on the back-light.
