Chamiin I&C Handy700 Guía de solución de problemas

Portable Wireless

IrDA Printer

Instruction Handy700

Operation & Maintenance

Rev.2.0 – April 2003

Product Leadership • Training • Service • Reliability

WARRANTY

Chamjin I&C. warrants to Buyer that at the time of delivery this Product will be free from

defects in material and manufacture and will conform substantially to Chamjin I&C’s

applicable specifications. Chamjin I&C’s liability and Buyer’s remedy under this warranty are

limited to the repair or replacement, at Chamjin I&C’s option, of this Product or parts thereof

returned to Seller at the factory of manufacture and shown to Chamjin I&C’s reasonable

satisfaction to have been defective; provided that written notice of the defect shall have been

given by Buyer to Chamjin I&C. within six (6) months after the date of delivery of this

Product by Chamjin I&C.

Chamjin I&C. warrants to Buyer that it will convey good title to this Product. Chamjin I&C’s

liability and Buyer’s remedy under this warranty of title are limited to the removal of any title

defects or, at the election of Chamjin I&C, to the replacement of this Product or parts thereof

that are defective in title.

THE FOREGOING WARRANTIES ARE EXCLUSIVE AND ARE GIVEN AND ACCEPTED IN

LIEU OF (I) ANY AND ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING

WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND

FITNESS FOR A PARTICULAR PURPOSE: AND (II) ANY OBLIGATION, LIABILITY, RIGHT,

CLAIM OR REMEDY IN CONTRACT OR TORT, WHETHER OR NOT ARISING FROM

Chamjin I&C’S NEGLIGENCE, ACTUAL OR IMPLIED. The remedies of the Buyer shall be

limited to those provided herein to the exclusion of any and all other remedies including,

without limitation incidental or consequential damages. No agreement varying or extending

the foregoing warranties, remedies or this limitation will be binding upon Chamjin I&C.

unless in writing, signed by a duly authorized officer of Chamjin I&C.

Note:

The battery pack is considered a consumable item, and is excluded from the

terms of this warranty.

Instruction Handy700

www.chamjininc.com

Notice:

Product improvements and enhancements are continuous, therefore the specifications and

information contained in this document may change without notice.

Chamjin I&C. shall not be liable for errors contained herein or for incidental or consequential

damages in connection with the furnishing, performance, or use of this material.

No part of this document may be photocopied, reproduced, or translated to another language

without the prior written consent of Chamjin I&C.

Chamjin I&C is a registered trademark of Chamjin I&C.

All other trademarks, trade names, service marks and logos referenced

herein belong to their respective companies.

Contents

Description ....................................................................................... 1

General ....................................................................................................1

Features...................................................................................................1

Battery Charger / Power Supply ............................................................1

Belt Clip...................................................................................................1

Power Switch...........................................................................................2

Indicator LEDs ........................................................................................2

Pushbuttons.............................................................................................2

Connectors ...............................................................................................2

Sensors.....................................................................................................3

Technical Characteristics............................................................. 4

Operation .......................................................................................... 5

Precautions ..............................................................................................5

Self Test ...................................................................................................5

Set-Up Mode ............................................................................................6

Using the Printer ....................................................................................7

Maintenance..................................................................................... 8

Cleaning the Printer ...............................................................................8

Opening / Closing the Paper Cover ........................................................8

Cleaning the Print Head.........................................................................8

Installing the Paper ................................................................................9

Parts & Service.............................................................................. 10

Replacement Parts ................................................................................10

Sales / Service Centers..........................................................................10

IrDA Printer

Instruction Handy700

Contents

Notes:

IrDA Printer

Instruction Handy700

IrDA Printer

Description

General

Chamjin I&C’s portable wireless printer uses infrared technology to commu-

nicate with other Chamjin I&C instruments that are capable of transmitting

data using the Infrared Data Association (IrDA) standard.

The printer is designed around a patented easy-loading paper mecha-

nism, which consists of a main cavity into which a paper roll is dropped

for loading. The thermal print head is at the front of the cavity and a

rubber roller is attached to the lid of the mechanism. When the lid is

closed, the paper is pinched between the rubber roller and the print-head

to give a close alignment and a consistent pressure.

Features

•Small size

•Quiet and fast printing

•Direct line thermal printing

•One hour of continuous printing with a fully charged battery pack

•Easy loading paper

•Easy maintenance and head cleaning

•User setable printer parameters using external pushbuttons

•Self-test function

Battery Charger / Power Supply

The supplied AC adapter (either 120 or 230 VAC) can be used to either

charge the battery pack, or both charge the battery and run the printer

when the battery is partially discharged.

Important! The AC adapter cannot operate the printer with

the battery pack removed, or when the battery pack is com-

pletely discharged.

Belt Clip

If desired, the supplied belt clip and screws can be installed to allow the

printer to be attached to a vertical surface or carried on a belt.

Description

IrDA Printer

2 Instruction Handy700

Power Switch

Use the Power switch located on the left side of the printer to turn the

unit ON and OFF (see Figure 1).

Indicator LEDs

There are two LEDs on the front panel that provide the following infor-

mation about the printer’s status:

• Power (Green): The Power LED glows green when the printer is

turned ON.

•Battery (Red): The Battery LED glows yellow when the battery is being

charged. orange LED glows when the battery is fully charged, and turns

OFF when the AC adapter is disconnected.

• Error (Green): The Power LED flashes once-a-second when: 1) the

printer is out of paper, 2) when the paper cover is opened, or 3) when

the printing head temperature exceeds 140 °F (60 °C).

Pushbuttons

There are two pushbuttons located on the front panel that perform the

following functions:

• FEED: Momentarily press this button to advance the paper. Pressing and

holding down the button causes the paper to feed continuously. This button

is also used to start the printer’s self test (refer to Section Self Test).

• SEL: Press this button to enter the printer’s set-up mode (refer to

Section Set-Up Mode).

Connectors

Two connectors located on the right side of the printer provide the follow-

ing functions:

• Power: Connect the AC adapter to this connector to charge the battery

pack, or directly power the printer.

•RS-232C: Not used in conjunction with Chamjin I&C instruments.

Description

Instruction Handy700

IrDA Printer

Sensors

There are three sensors that perform the following functions:

• Paper Cover: When the paper cover is open the printer is disabled to

prevent damage to the print head. This condition is indicated by the

Power LED flashing.

• Paper Out: When the paper roll runs out, the printer is disabled to

prevent damage to the print head. This condition is indicated by the

Power LED flashing.

• IrDA: Located at the front of the printer, this sensor accepts the infra-

red signal from the instrument.

Figure 1. Component Locations and Functions

Description

O F F O N

P o w e r

S E L P u s h b u t t o n :

1 ) H o l d d o w n a n d t u r n p r i n t e r O N

t o e n t e r S e t - U p M o d e .

2 ) O n c e i n S e t - U p M o d e , p r e s s t o

c h a n g e p r i n t e r p a r a m e t e r .

F E E D P u s h b u t t o n :

1 ) i t h p r i n t e r a l r e a d y O N , p r e s s t o

a d v a n c e p a p e r .

2 ) i t h p r i n t e r i n i t s S e t - U p M o d e , p r e s s

t o c h a n g e v a l u e o f p r i n t e r p a r a m e t e r

a s c h o s e n b y t h e S E L b u t t o n .

3 ) H o l d d o w n a n d t u r n p r i n t e r O N

t o e n t e r S e f t - T e s t M o d e .

P o w e r / E r r o r ( G r e e n ) L E D :

1 ) G l o w s s t e a d y w h e n p r i n t e r i s

t u r n e d O N .

2 ) F l a s h e s w h e n p r i n t e r i s o u t o f p a p e r ;

w h e n p a p e r c o v e r i s o p e n ; o r w h e n

p r i n t h e a d t e m p . i s a b o v e 1 4 0 ° F .

B a t t e r y ( R e d ) L E D :

1 ) G l o w s s t e a d y w h e n b a t t e r y p a c k i s

b e i n g c h a r g e d .

2 ) F l a s h e s w h e n b a t t e r y i s f u l l y c h a r g e d .

I r D A S e n s o r

P o w e r C o n n e c t o r R S 2 3 2 C C o n n e c t o r

B a t t e r y C o v e r

P a p e r C o v e r

IrDA Printer

Instruction Handy700

Technical Characteristics

Printing Method.......................Direct thermal

Number of Columns.................32,48 columns, 384 dots/line

Character Size .........................0.06 x 0.12 in. (1.5 x 3.0 mm)

Line Pitch

.................................0.1 in (4.0 mm)

Paper Width

.............................2.25 in. (57.5 mm)

Interface

...................................IrDA and Serial (RS-232C)

International Characters ........U.S.A., France, U.K., Denmark I,

Sweden, Italy, Spain, Japan, Norway,

Denmark II, Korea

Buffer........................................7 kB

Baud Rate.................................300 – 11,5200 bps

Power Requirement .................12 V, 1.2A (with battery)

12 V, 3 A (without battery)

Battery Pack

............................Lit-ion,Ni-Mh, 7.2 V, 1800 mAh

Dimensions...............................3.6 x 5.5 x 2.0 in. (92 x 140 x 51 mm)

Technical Characteristics

Instruction Handy700

IrDA Printer

Operation

Precautions

To ensure the proper operation of the printer and prevent the possibility

of voiding the warranty, be sure to observe the following precautions:

•Avoid dirty or dusty locations, or those with excessive heat or humidity

•Choose a stable level or solid wall on which to mount the printer

•Use only the supplied power adapter to charge the battery pack

•Ensure that the AC adapter will be plugged into the correct source of

AC power

•Use only the supplied thermal paper or its replacement part

Self Test

The self-test mode checks the printer’s control circuit functions, setting

parameters, software version, and printer quality.

1. Before running the self test, make sure there is sufficient paper to

run the test (18" [46 cm]); the paper cover is closed; and that the

printer is switched OFF.

2. Press and hold down the FEED pushbutton; then switch ON the

printer to begin the test.

Note: The test can be aborted by switching OFF the printer.

3. The following typical information is printed, followed by the printer’s

complete character set:

Version : 1.1.6

Data bit : 8 bit

Parity : None

Baud rate : 9600 bps

Handshaking : DTR

Country : U.S.A.

Print mode : Text (upright)

Paper : Normal paper

Density : 100%

IrDA : IrDA-SIR

Buffer size : 7000Byte

Head volt : 7.1V

Head temp. : 31°C

Operation

IrDA Printer

6 Instruction Handy700

Set-Up Mode

The printer has been set up at the factory with the following default

parameters:

Baud rate : 9600 bps

Handshaking : DTR

Country : U.S.A.

Print mode : Text (upright)

Paper : Normal paper

IrDA : IrDA-SIR

If necessary, the default parameters can be changed as follows:

1. With the printer initially switched OFF, press and hold down the SEL

pushbutton; then switch the printer ON.

2. The printer now goes into its set-up mode and prints its current

parameter status. Observe that the green Power LED flashes to

indicate that the printer is in its set-up mode.

Note: If no pushbuttons are pressed within 15 seconds, the

set-up mode is automatically terminated without changing

the original parameters.

3. Baud rate is first parameter printed. Pressing the FEED button

causes the value of that parameter to change in the sequence shown

in the following table.

SEL Button FEED Button

Baud rate 300~115,200

Handshaking DTR, X-on/X-off

Country U.S.A., Korea, Cyrillic, Denmark2, Norway,

Japanese, Spain, Italy, Sweden, Denmark1,

U.K., Germany, France

Print mode Text(upright), Data(inverted)

Paper Normal paper, Reprint paper

Density 50 – 150% in 5% steps

IrDA Chamjin-Ir, IrDA-Sir, BHT-Ir(DENSO), EL-ME-Ir,HP

Operation

Tabla de contenidos

Otros manuales de Impresora de Chamiin I&C

Chamiin I&C

Chamiin I&C Handy700-BT Manual de instrucciones

Manuales populares de Impresora de otras marcas

Lexmark

Lexmark 1400 Series Manual

Canon

Canon i70 Series Manual de usuario

Evolis

Evolis Elypso Manual de usuario

Kyocera

Kyocera FS-9530DN Manual de usuario

Canon

Canon LASER SHOT LBP-1210 Manual de usuario

Samsung

Samsung BIXOLON SRP-350plusF Manual de usuario

Canon

Canon PIXMA PRO-1 Series Manual de usuario

Canon

Canon PIXMA G3560 Guía de configuración

Dell

Dell Color Laser Printer 2130cn Manual de usuario

Tektronix

Tektronix Phaser 840 Manual de usuario

Epson

Epson ET-7750 Instrucciones de funcionamiento

Canon

Canon CLBR 460ps Manual de usuario

Eltron

Eltron P210 Guide Manual de usuario

Ricoh

Ricoh MD-P1 Manual de usuario

Epson

Epson SC-F7100 series Manual de usuario

Epson

Epson Stylus C40UX Manual de usuario

Canon

Canon imagePASS-A2 Manual de usuario

Canon

Canon S820D Manual de usuario