Steam Generator Location
1, the steam generator should be fixed in the wall or on the floor firmly,
Select a location as near as practical to the shower room. Typical
locations include: closet, vanity cabinet, climate controlled attic or
basement. In the process of fixing, install the machine on a vertical
wall, release the two screws on the cover, move the cover and then fix
the machine using the holes on the top right and left. Signs should be
put in the obvious place and the generator should be put in the flexible
place for maintaining. Please refer to the figure 1 to fix.
2, do not install the machine outside, or the place where is wet, hot or
the place where is easy for being frozen or eroded. Do not install it
near paint, thinner, or gas. Install it in a dry and ventilation place.
3, the generator can only be installed horizontally.Up in the direction
indicated by the arrow. Otherwise, it is strictly forbidden to boot.
4, locate the steam bath generator within 32 feet of the shower room.The
standard length of the cable for connecting the control to the steam
generator is 32 feet. The steam generator and control must be located
accordingly.
5, do not install steam bath generator inside shower room.
6, do not install steam bath generators or pipes in an unheated attic
or any place where water may freeze.
7, do not install the steam bath generator near flammable or
corrosive materials or chemicals (such as gasoline, paint thinner,
etc.). Must avoid installation in areas with high chlorine
concentration (such as swimming pool room).
8, Provide a minimum of 12 inches at both ends and top of the steam
generator or as required for servicing.
