CEECO WPL-531-X Manual de usuario

WPL-531-X-SPK1.07-ISSUE4.0

SERVICE MANUAL

FOR

MODEL WPL-531-X

HANDS FREE EMERGENCY

WEATHERPROOF TELEPHONE

EQUIPPED WITH SPK1.07 FIRMWARE

Serving the Telephone Industry Since 1930

Communication Equipment 519 W South Park Street

& Engineering Company Okeechobee, FL 34972

Voice: 863-357-0798

Fax: 863-357-0006

ISSUE 4.0

CEECO

Communication Equipment & Engineering Company

PROPRIETARY

IMPORTANT INFORMATION

FOR

CUSTOMER

Please fill in before you continue.

The following information is necessary when calling CEECO for assistance.

MODEL NUMBER MODEL WPL-531-X EQUIPPED WITH

SPK1.07 FIRMWARE.

SERIAL NUMBER

DATE MANUFACTURED

LOCATION INSTALLED

For us to better serve you, please have this information available when calling for

technical support.

CEECO

Communication Equipment & Engineering Company

519 W South Park Street

Okeechobee, FL 34972

863-357-0798- telephone

863-357-0006- facsimile

[email protected]

www.ceeco.net

ISSUE 4.0

CEECO

Communication Equipment & Engineering Company

PROPRIETARY

TABLE OF CONTENTS

SECTION PAGE

1.0 INTRODUCTION................................................................................................... 4

2.0 GENERAL............................................................................................................... 4

3.0 PROGRAMMING .................................................................................................. 5

PROGRAMMING CONTINUED................................................................................... 6

PROGRAMMING CONTINUED................................................................................... 7

4.0 OPERATION .......................................................................................................... 7

5.0 RECOMMENDED TOOLS AND TEST EQUIPMENT .................................... 7

6.0 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS ..................... 8

7.0 TESTING................................................................................................................. 9

7.0 SPECIFICATIONS............................................................................................... 10

9.0 PARTS LIST ......................................................................................................... 11

10.0 REPAIR AND RETURN INFORMATION....................................................... 12

11.0 WARRANTY POLICY ........................................................................................ 13

12.0 DIAGRAM............................................................................................................. 14

ISSUE 4.0

CEECO

Communication Equipment & Engineering Company

PROPRIETARY

1.0 INTRODUCTION

The practices in this manual provide installation and maintenance information for the

CEECO Model WPL-531-X Hands free Weatherproof Telephone with SPK1.07

firmware.

The information in this manual is subject to change without notification.

For information not included in this manual, please call or write:

CEECO

Customer Service

519 W South Park Street

Okeechobee, FL 34972

863-357-0798- telephone

863-357-0006- facsimile

[email protected]

www.ceeco.net

2.0 GENERAL

2.1 The CEECO Model WPL-531-X Hands free Weatherproof telephone is a

sturdy, vandal resistant, stainless steel weatherproof speakerphone. Instead

of a hookswitch and handset, the WPL-531-X has a Press to start/Press to

stop button for initiation and termination of phone calls. This Emergency

button is provided for automatic ring down applications. Manual volume

controls for the microphone and speaker are provided inside the phone.

2.2 Incoming calls may be allowed or blocked depending on the

programming.

2.3 Programming is accomplished via the DTMF keypad.

ISSUE 4.0

CEECO

Communication Equipment & Engineering Company

PROPRIETARY

3.0 PROGRAMMING

3.1 Remove the front stainless steel panel by loosening the four security

screws with a security tool (sold separately) and remove them. Remove

the panel and attached telephone assembly.

3.2 Connect the telephone to a working telephone line or a DTMF test set.

3.2 Locate the pair of blue mini-jumpers located near the edge of the printed

circuit board. Move them to the “ON” or innermost position, as depicted

on the last page of this manual.

3.3 Locate the programming keypad, which is either mounted on the back

panel or provided on the side.

3.4 Each programming location is accessed by dialing the "#" sign and the two

digit code, which corresponds to that location. The only valid program

locations for this phone is : #00. The previous contents of the location are

automatically erased when the location code is dialed.

3.5 Location "00" is the telephone option location. By entering a number of 1-

9 into each of the 10 digits, the phone is customized for the particular

installation.

3.6 Press the “CALL & HANGUP” and wait to hear dial tone

3.7 Using the keypad, enter #00 followed by ten digits, as selected on the next

page..

NOTE:

THIS EQUIPMENT IS TELEPHONE LINE POWERED.DURING PROGRAMMING THE CENTRAL

OFFICE OR PBX MAY RESPOND TO THE PROGRAMMING CODES WITH VARIOUS BUSY TONE,

REORDER TONE,RECORDINGS,ETC.THESE TONES AND RECORDINGS WILL HAVE NO

EFFECT ON THE PROGRAMMING.PLEASE IGNORE THEM.

ISSUE 4.0

CEECO

Communication Equipment & Engineering Company

PROPRIETARY

PROGRAMMING CONTINUED

LOCATION #00

Digit 1:

Always 0 for this model.

Digit 2:

0 No incoming calls allowed. (Default)

1 Incoming calls allowed.

Digit 3:

Always 0 for this model

Digit 4:

0 No time-out disconnect

1-9 Minutes time-out disconnect

Digit 5:

Always 1 for this model

Digit 6:

Always 0 for this model.

Digit 7:

Always 1 for this model

Digit 8:

Always 0 for this model

Digit 9:

Always 0 for this model

Digit 10:

00 No wink detect.

1-9 Length of the wink detect.

(1=50ms incremental to 450 ms. 5 is recommended).

•Be sure to enter your selections below for future reference.

#00= 0 __ 0 __ 1 0 1 0 0 5

DIGITS: 1 2 3 4 5 6 7 8 9 10

ISSUE 4.0

CEECO

Communication Equipment & Engineering Company

PROPRIETARY

PROGRAMMING CONTINUED

3.8 When you are finished programming, press the “CALL & HANGUP”

button to hang up the phone. Return the two green mini-jumpers to the

“OFF” or outermost position, as depicted on the last page of this manual.

Secure the telephone assembly in the housing. The phone is now ready for

use.

4.0 OPERATION

To make a call, press the "EMER/CALL" button located on the front of the

phone. Wait to hear dial tone. The LED (if provided) will illuminate red at this

time. After the call is complete, press the "EMER/CALL" button on the front of

the panel again to hang up the phone. If the user does not press the button on the

front of the panel when he or she is finished using the phone, then the phone will

hang up after detecting a wink (open switch interval) or the timer times out.

5.0 RECOMMENDED TOOLS AND TEST EQUIPMENT

DTMF Test Set

Volt/Ohm Meter

CEECO Security Tool, 301-064

ISSUE 4.0

CEECO

Communication Equipment & Engineering Company

PROPRIETARY

6.0 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS

6.1 Using a 301-064 security tool (sold separately), loosen and remove the

security screws.

6.2 The security tool is for a standard 5/32" button head screw generally used

on the framework of the phone booths.

6.3 Separate the faceplate assembly from the weatherproof housing by pulling

the faceplate forward.

6.4 Run the inside station wire into the enclosure and terminate on the RJ11C

terminal block inside.

6.5 The use of a gas tube station protector is recommended. The station

ground should not exceed 50 ohms.

6.6 Plug the modular line cord from the faceplate assembly into the RJ11C

terminal block.

6.7 Dress the telephone line cord and AC cable away from the security screws

and seat the faceplate into the weatherproof housing.

6.8 Secure the cover assembly by tightening the security screws.

*****WARNING*****

A. Never install telephone wiring during a lightning storm.

B. The telephone must be grounded in accordance with local and

national electric codes.

C. Never install telephone jacks in wet locations unless the jack is

specifically designed for wet locations.

D. Never touch uninsulated telephone wires or terminals unless the

telephone line has been disconnected at the network interface.

E. Use caution when installing or modifying telephone lines.

ISSUE 4.0

CEECO

Communication Equipment & Engineering Company

PROPRIETARY

7.0 TESTING

Action: Connect the phone to the line.

Press the "EMER/CALL" button.

Reaction: Phone goes off-hook.

Action: The called party answers

Reaction: A normal speakerphone conversation is allowed.

Action: Finish the conversation.

Press the "EMER/CALL" button, or wait until

time out occurs.

Reaction: The call is terminated.

ISSUE 4.0

CEECO

Communication Equipment & Engineering Company

PROPRIETARY

7.0 SPECIFICATIONS

INPUT POWER: C.O. Line powered

110\120vAC for optional strobe light

LOOP CURRENT: 23mA minimum 80 mA maximum

IMPEDANCE: 600 ohms

SIGNALING: Manual on-off hook

OUTPUT: -4.0dbm to -6.0dbm

ENVIRONMENTAL: Temperature 0o C to 50o C

Humidity 20%-90%

PROGRAMMING: Via DTMF keypad.

MEMORY RETENTION: Lithium Battery - Long life

WEIGHT: 21 Pounds

DIMENSIONS: 9.20" Wide x 20.20" High x 7.30" Deep

MOUNTING: 4 Holes spaced 8"x 5 7/8" x 13/32" dia.

TYPE JACK: RJ11C

UL LISTED NO.: 6OF5

Tabla de contenidos

Otros manuales de Teléfono de CEECO

CEECO

CEECO SSP 361-D Manual de usuario

CEECO

CEECO SSW-321-Xr1 Manual de usuario

CEECO

CEECO SSP-371-D Manual de usuario

CEECO

CEECO WPP-531-D-ADA-STROBE Manual de usuario

CEECO

CEECO Charge-A-Call BLC-303-1 Manual de usuario

CEECO

CEECO SSW-321-F-IVC-C-M Manual de usuario

CEECO

CEECO SSW-323-F Manual de usuario

CEECO

CEECO 403-F Manual de usuario

CEECO

CEECO SSW-321-X Manual de usuario

CEECO

CEECO WPP-331-F Manual de usuario

CEECO

CEECO SSP-369-FE Manual de usuario

CEECO

CEECO SSW-321-D Manual de usuario

CEECO

CEECO BLC-303-F Manual de usuario

CEECO

CEECO SSW-521-X-ADA Manual de usuario

CEECO

CEECO SSP-350-X-145 Manual de usuario

CEECO

CEECO HOB-313-DD-48 Manual de usuario

CEECO

CEECO SSP-561-D Manual de usuario

CEECO

CEECO SSP-571-D Manual de usuario

CEECO

CEECO WPP-530-D Manual de usuario

CEECO

CEECO WPP-531-FD Manual de usuario

CEECO

CEECO MHW-341-D Manual de usuario

CEECO

CEECO SSP-599-F Manual de usuario

CEECO

CEECO SSP-350-X Manual de usuario

CEECO

CEECO WPP-333-D Manual de usuario

Manuales populares de Teléfono de otras marcas

GE 2-9480 Manual de usuario

Geemarc

Geemarc PHOTOPHONE 155 Manual de usuario

D-Link

D-Link DWR-720/PW Manual de usuario

Interquartz

Interquartz Gemini IQ333 Manual de usuario

SSS Siedle

SSS Siedle HT 840-0 Manual de usuario

Motorola

Motorola TITANIUM Manual de usuario

Panasonic

Panasonic ICX Manual de usuario

LG H870DS Manual de usuario

Samsung

Samsung GT-I9500 Manual de usuario

AT&T

AT&T Trimline 205 Manual de usuario

Selta

Selta zenyth 600 Manual de usuario

Doro

Doro AFTI 20 Manual de usuario

UNIQCELL

UNIQCELL A1 Manual de usuario

Panasonic

Panasonic KX Series Manual de usuario

Jabra

Jabra SP5050 - Bluetooth hands-free Speakerphone Manual de usuario

BT Decor 425 Manual de usuario

NEC

NEC SV8500 Manual de usuario

Teledex

Teledex PEARL Manual de usuario