CDA FW422 Guía de inicio rápido
www.cda.eu
FW422
Integrated In Column
Larder Fridge
Installation, use and maintenance
2
Contents:
3 Important information
5 Important safety warnings
6 Before first use
7 Setting the temperature
7 Guidance on use
8 Care and cleaning
9 Defrosting the fridge
10 Changing the light bulb
11 Troubleshooting
13 Installation
14 Electrical information
3
Important
The CDA Group Ltd cannot be held responsible for injuries or losses
caused by incorrect use or installation of this product. Please note that
CDA reserve the right to invalidate the guarantee supplied with this
product following incorrect installation or misuse of the appliance.
This appliance is not designed to be used by people (including
children) with reduced physical, sensorial or mental capacity, or
who lack experience or knowledge about it, unless they have had
supervision or instructions on how to use the appliance by someone
who is responsible for their safety.
Under no circumstances should any external covers be removed for
servicing or maintenance except by suitably qualified personnel.
Appliance information:
Please enter the details on the appliance rating plate below for
reference, to assist CDA Customer Care in the event of a fault with
your appliance and to register your appliance for guarantee purposes.
Appliance Model
Serial Number
CE Declarations of Conformity:
This appliance meets the requirements of all applicable EU directives
with the corresponding harmonised standards which provide for CE
marking.
4
This appliance has been manufactured to the strictest standards and
complies with all applicable legislation, including Electrical safety (LVD)
and Electromagnetic interference compatibility (EMC). Parts intended
to come into contact with food conform to 1935/2004/EC.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH EU DIRECTIVE 2012/19/EU.
At the end of its working life, the product must not be disposed of as
urban waste. It must be taken to a special local authority dierentiated
waste collection centre or to a dealer providing this service.
Disposing of a household appliance separately avoids possible
negative consequences for the environment and health deriving from
inappropriate disposal and enables the constituent materials to be
recovered to obtain significant savings in energy and resources. As a
reminder of the need to dispose of household appliances separately,
the product is marked with a crossed-out wheeled dustbin.
5
Important
Never store inflammable or explosive items and strong corrosive
acids or alkalis in the appliance.
This is a household appliance, which is produced in accordance with
the national standard. It is intended for food storage only, not for
storage of blood, medicine and biological products.
To prevent risk of fire, keep the appliance away from petrol or any
other inflammables.
To prevent risk of electromagnetic interference or other accidents,
do not place a microwave oven on top of the refrigerator or use any
electric appliance inside the refrigerator.
Do not allow children to play with or near the appliance.
The internal surface of the fridge compartment is very cold when the
appliance is running. Do not touch the surface especially with wet
hands.
Do not splash water onto the appliance. Keep it away from places of
high humidity that may have adverse eect on the electric insulation
performance.
Please remove the door, door seal and shelves before disposal of the
old appliance and put them away in a safe place to prevent children
from being entrapped.
6
Before first use
You must allow the fridge to settle for at least twenty four hours
prior to switching the power on.
It is recommended that you clean the interior of the appliance prior to
first use, using a solution of bicarbonate of soda and warm water and
then thoroughly drying the interior.
The fridge may have an odour to it at first use. This will disappear as
the appliance cools.
Please note:
The appliance will work continuously until it comes down to the
correct temperature.
If the appliance is switched o, you should allow five minutes
before switching it on again to prevent unnecessary damage to the
compressor.
This fridge cools your food by making the inside back of the cavity
cold. It is normal for frost to build up on this surface; it then dissipates
and drains through a small drain at the bottom, where it evaporates
harmlessly. The presence of frosting at the back is not a malfunction
of the fridge.
7
Setting the temperature
You must allow the fridge to settle for at least twenty four hours
prior to switching the power on.
To adjust the temperature turn the thermostat control knob clockwise
(from o) to the required level. The temperature becomes colder the
higher the number on the control.
When the thermostat is set to 0 the cooling system is switched o.
We recommend initially setting the temperature control in mid range
for the first 24 hours then adjusting the temperature up or down from
this point as your personal preference.
Use
Fridge
• Never put liquids in the refrigerator uncovered.
• Never put hot foods in the refrigerator. Warm food should be
allowed to cool to room temperature before being put into the
refrigerator.
• Nothing should rest against the rear wall of the refrigerator, as this
will cause frost and possible condensation problems which will be
dicult to remove.
• Make sure food is clean and any extra water is wiped away before
putting into the fridge.
• Wrap or cover food before putting into the fridge. This will help
prevent the loss of moisture, keep food fresh and avoid unpleasant
odours.
• Sort foods prior to storing. Any foods to be used soon should be
8
stored at the front of the shelf to prevent deterioration caused by
the door being open for prolonged periods.
• Do not overfill the fridge. There should be sucient space between
the foods to allow the cool air to circulate.
• Thawing frozen foods in the fridge compartment will help to keep
the temperature low and save energy.
• Only open the door for as long as is necessary. Leaving the
door open for long periods will aect the temperature inside the
appliance and waste energy.
• Ensure all compartments are fully closed after use.
Care and cleaning
Always disconnect the appliance from the power supply before
any cleaning or maintenance.
The fridge sections should be cleaned using a solution of bicarbonate
of soda and lukewarm water. Do not use abrasive products or
detergents. After washing, rinse and dry thoroughly.
Clean the shelves and balconies separately by hand with soap and
water. Do not put them in the dishwasher.
The water drain hole at the back of the fridge compartment and
the evaporating tray should be cleaned periodically to prevent the
defrosted water from collecting inside the fridge compartment. The
drain plug can be used to clean the drain hole.
Once cleaning is complete, then reconnect the power.
9
• Keep the door gasket (seal) clean. If damaged, the gasket should be
replaced.
• If the appliance is not used for prolonged periods of time, unplug
and clean the appliance. The door should be left slightly open to
prevent the formation of mildew and smell.
Defrosting the fridge
The fridge is self-defrosting. Any water created will run out of the
fridge through the channel at the back of the fridge provided it is not
blocked or iced over.
It is important to keep the channel clear at all times. The defrosted
water is collected in the evaporating tray at the back of the appliance.
Use the supplied drain plug to clean the drain hole (Fig. 1).
Fig. 1
10
Changing the light bulb
If your fridge has a halogen bulb:
• Disconnect the appliance from the power.
• Carefully remove the light cover by pushing in the lever at the back
of the cover, and then pulling the cover down.
• Unscrew the old light bulb to remove it and replace with a new bulb
(not more than 15W). Be careful as the bulb may be hot. Always wear
adequate protection for your hands. Please note that you can fit a
15W LED bulb if you prefer.
• Replace the light cover and reconnect the power after five minutes’
delay as explained on page 3.
If your fridge has LED lighting:
• Disconnect the appliance from the power.
• Carefully remove the screw from the light cover. Then, remove the
cover by simply pulling it firmly away from the housing. Do not worry
if the housing moves slightly - reinserting the screw later will remedy
this.
• Unscrew the old light bulb to remove it and replace with a new LED
bulb (not more than 15W). Be careful as the bulb may be hot. Always
wear adequate protection for your hands.
• Replace the cover by replacing the cover lip nearest the thermostat
dial first and then slot the remaining lips in. Reinsert the screw and
tighten. Reconnect the power after five minutes’ delay as explained
on page 3.
Otros manuales para FW422
1
Tabla de contenidos
Otros manuales de Refrigerador de CDA
CDA
CDA PC51 Guía de inicio rápido
CDA
CDA FW925 Guía de inicio rápido
CDA
CDA FW552 Manual de referencia
CDA
CDA FF850 Manual de referencia
CDA
CDA FW522 Guía de inicio rápido
CDA
CDA PC50 Manual de referencia
CDA
CDA FW971 Guía de inicio rápido
CDA
CDA FF150 Manual de referencia
CDA
CDA FF820 Manual de referencia
CDA
CDA FW850 Manual de referencia
CDA
CDA PC44 Manual de referencia
CDA
CDA FW870 for Manual de referencia
CDA
CDA FW420 Manual de referencia
CDA
CDA FW320 Manual de referencia
CDA
CDA FW254/1 Guía del usuario
CDA
CDA fw852 Guía de seguridad
CDA
CDA FW950 for Manual de referencia
CDA
CDA CRI621 Guía del usuario
CDA
CDA PC52 Guía de inicio rápido
CDA
CDA FF120 Manual de referencia
