Carrier 7C-SE-C72X-X Hoja de datos

For more information, contact your local Carrier Controls Expert

INTRODUCTION

The Multi Sensor possesses a high precision Occupancy, CO2, temperature, and humidity sensor

that is pre-calibrated from the factory. The Multi-Sensor is easily mounted on a wall the grommet

provided. The Multi-Sensor can be daisy-chained using the proprietary 1-wire protocol to

communicate with a master node device such as a SmartNode.

PACKAGE CONTENTS

•Multi-Sensor

•Mounting accessories

•Sensor Bus cable 30ft in length

SPECIFICATIONS

Power

3-wire interface powered at 3.3V with a

maximum current limit of 30mA

Accuracy

Temperature (typical +/- 1°F (0.5°C),

Humidity (typical +/- 2% RH),

Occupancy @ 8ft height, 100 deg cone angle,

CO2 +/- 75 ppm at 400 ~ 10000 ppm

Protection

Protection: IP 20, NEMA Type 1

Pollution grade: 2

Certification: ROHS

Communication

Sensor bus for daisy-chained sensor

communication

Long Term Drift

Humidity < 0.25%RH/yr

Temperature <0.03 0C/yr

Mounting

Firmly on the Wall/Ceiling. A torque not

exceeding 0.2Nm is to be used to fix the

device.

Operating temperature

Operating Environment: 32°F to 122°F

Storage temperature

14°F to 158 °F

MULTI SENSOR (7C-SE-C72X-X)

INSTALLATION QUICK START GUIDE

Scan this QR

code to get a

more detailed

version of the

Installation

Guide

For more information, contact your local Carrier Controls Expert

MOUNTING

1. Drill a hole of dia 25mm (1”) and mount the Multi Sensor grommet (Figure 1)

using a toggle

bolt grommet. Make sure the level lines on the gromet are parallel to the floor.

Figure 1

2. Connect the Sensor Bus cable through the grommet/grommet screw mounting to the

Multi Sensor. Refer to Figures 2 to connect the wire to the multi-sensor.

Figure 2

3. To mount the Multi Sensor on the grommet (Screw held or Toggle held), lock the top

portion of the Multi Sensor in the lock clips and push the bottom portion of the device to

lock it in place.

Figure 3 Figure 4

For more information, contact your local Carrier Controls Expert

4. To remove the device from the installed location, use a simple tool with a dia of less than 1/8”

(3mm) and push it upwards to release the locking clip on the grommet. While doing so, pull

the Multi Sensor away from the grommet mount.

Figure 5 Figure 6

CARRIER CLIMAVISION TECHNICAL SUPPORT

Installation and servicing of Control Systems can be hazardous due to electrical

components. Only trained and qualified service personnel should install, repair or service

control system components.

For more information on wiring, commissioning, or usage of the ClimaVision product line,

please refer to any documentation provided with the job. If no documentation was provided

with the job, please use the ClimaVision Help Center (support.climavision.com) where you

can find application specific wiring schematics and helpful user guides and videos or scan

the QR code here:

If you need help beyond that, please reach out to your local Carrier distributor for support.

Scan this QR code to

get a more detailed

version of the

Installation Guide

Otros manuales de Sensor de seguridad de Carrier

Carrier

Carrier NSB-NO2-V-BB Manual de usuario

Carrier

Carrier 7C-SE-C1X-DT Manual de usuario

Carrier

Carrier Graviner Mk6 Guía de configuración

Carrier

Carrier KIDDE 60WLDR-W Manual de usuario

Carrier

Carrier Graviner Mk7 Guía de configuración

Carrier

Carrier NSB-LDT4-PS-BB Guía

Carrier

Carrier DET-TRONICS Dual Spectrum PM-5MPX Manual de usuario

Carrier

Carrier Graviner Mk6 Manual de usuario

Carrier

Carrier Aritech 6933AMP Instrucciones de montaje

Carrier

Carrier BN Series Manual de usuario

Carrier

Carrier HyperSense 7C-HS-C1W-X Manual de usuario

Carrier

Carrier 7C-SE-C68 Series Manual de usuario

Carrier

Carrier ARITECH VE1012PI Instrucciones de montaje

Carrier

Carrier Graviner Mk7 Manual de usuario

Carrier

Carrier SPS Manual de usuario

Manuales populares de Sensor de seguridad de otras marcas

THORLABS

THORLABS PDA10JT Manual de usuario

Waeco

Waeco UV-DETECT Manual de usuario

Intermatic

Intermatic IOS-DSIMF Manual de usuario

urmet domus

urmet domus 1083 Manual de usuario

Siemens

Siemens AZL66 Series Manual de usuario

BTI

BTI Profiline Multi Finder Manual de usuario

Challenger

Challenger SL01 Manual de usuario

DMP Electronics

DMP Electronics 1122INT Manual de usuario

Rielta

Rielta Ladoga MK-RK Manual de usuario

Mirion Technologies

Mirion Technologies ACCURAD PRD Manual de usuario

Bosch

Bosch DS835 Manual de usuario

DBI SALA

DBI SALA EZ Stop Manual del operador

Lamptime

Lamptime ST05C Manual de usuario

Ubiquiti

Ubiquiti MFI-MSC Manual de usuario

Subsite

Subsite 910R Instrucciones de instalación

Satel

Satel OPAL Pro Manual de usuario

Aleph

Aleph XC-1XTEU Manual de usuario

Pima

Pima LARIS QUAD Manual de usuario