C-me Matrix K Manual de usuario

Version 1.0

Matrix K

User's Manual

Matrix K User's Manual

FCC INFORMATION (U.S.A)

1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!

This product, when installed as indicated in the instructions contained in this manual, meets

FCC requirements. Modications not expressly approved by CME may void your authority,

granted by the FCC, to use the product.

2. IMPORTANT: When connecting this product to accessories and/or another product use only

high quality shielded cables. Cable(s) supplied with this product MUST be used. Follow all

installation instructions. Failure to follow instructions could void your FCC authorization to

use this product in the USA.

3. NOTE: This product has been tested and found to comply with the limits for a Class B

Digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential environment. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used according to the instructions found in the users manual, may cause interference harmful

to the operation of other electronic devices. Compliance with FCC regulations does not

guarantee that interference will not occur in all installations. If this product is found to be the

source of interference, which can be determined by turning the unit “OFF” and “ON”, please

try to eliminate the problems by using one of the following measures:

Relocate either this product or the device that is being affected by the interference.

Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install

AC line lter(s).

In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is

300 ohm ribbon lead, change the lead-in to co-axial type cable.

If these corrective measures do not produce satisfactory results, please contact the local

retailer authorized to distribute this type of product. If you cannot locate the appropriate retailer,

please contact CME.

The above statements apply ONLY to those products distributed in the USA.

Matrix K User's Manual

PRECAUTIONS

IMPORTANT

Always follow the basic precautions listed below to avoid the possibility of serious injury or

even death from electrical shock, damages, re or other hazards. These precautions include, but

are not limited to, the follows:

1. Read and understand all the instructions.

2. Always follow the instructions on the device.

3. Before cleaning the instrument, always remove the electric plug from the outlet as well as

the USB or IEEE 1394 cable. When cleaning, use a soft and dry cloth. Do not use gasoline,

alcohol, acetone, turps or any other organic solutions; do not use liquid cleaner, spray cleaner

or too wet cloth.

4. Do not use the device near water or moisture, such as bathtub, washbasin, washing pool in the

kitchen or similar places.

5. Do not place the device in an unstable position where it might accidentally fall over.

6. Do not jam sinks or holes of the device; those sinks of holes are used for air circulation to

prevent the device from overheating. Do not place the device near heat sink or any places

with poor air circulation.

7. Do not place anything on the power cord. Make sure the power cord is set on a safe place, so

nobody will step on it and no body will trip over it.

8. Do not overload the outlet and the AC cable to avoid re or electrical shock.

9. Do not insert anything in the device, which may cause re or electrical shock. Do not splash

any kind of liquid to the device.

10. Do not disassemble the device in case of accidental electrical shock.

11. Always take the device to a qualied service center in need of repair. You will cause yourself

in danger if you open or remove the cover, and improper assembly may cause electrical shock

in the future use.

12. Unplug all the connectors and take the device to a qualied service center if anything in the

below listed happens:

A. The power cord or connector get hurt or worn out.

B. Any liquid get in the device.

C. The device gets rain or water splash.

D. The device dose not work properly after following all the instructions regarding to the

trouble-shootings.

E. The device falls down or gets broken.

F. The device functions poorly.

13. Do not use the device when thundering; otherwise the thundering may cause long-distance

electrical shock.

14. Do not use the device when there is a gas leak nearby.

Keep this manual in safe place

Matrix K User's Manual 3

CAUTION:

Setting up

Do not connect the device when thundering.

Do not set up the cord or outlet to a moist place, except for that the outlet is specially

designed for moist places.

When the power cord is connected to the AC outlet, do not touch the naked part of the cord

or the connector.

Always follow the instructions carefully when setting up the device.

WARNING:

Do not expose the device to rain or moisture, to avoid re or electrical shock.

Other precautions:

Keep the device away from electrical interface sources, such as uorescent light and electrical

motors.

Keep the device away from dust, heat and vibration.

Do not expose the device to sunlight.

Do not place heavy objects on the device, do not place containers with liquid on the device.

Do not touch the connectors with wet hands.

Central Music Co. is not responsible for any damage or data loss caused by improper

operation to the device.

All the pictures and the LED display in the manual are used for demonstration; they may be

different from the real device.

Trademarks:

CME and Matrix K are the registered trademarks of Central Music Co. All the other

trademarks belong to their respective owners.

Matrix K User's Manual

Matrix K User's Manual 5

Contents

FCC INFORMATION (U.S.A) ................................................................ 1

Precautions .......................................................................................... 2

Introduction ......................................................................................... 6

Conguration ....................................................................................... 7

Front Panel ................................................................................................................ 7

Rear Panel of Matrix K FW ........................................................................................ 8

Rear Panel of Matrix K USB ...................................................................................... 9

Connection examples ....................................................................... 10

Connection examples of front panel ........................................................................ 10

Connection examples of rear panel ......................................................................... 10

Signal ow chart (block diagram) .................................................... 11

Driver Installation and Removal ....................................................... 12

Driver Installation ..................................................................................................... 12

Driver Removal ........................................................................................................ 12

Control and Setting ........................................................................... 14

Control Panel of Matrix K FW ........................................................... 17

Synchronisation tag ................................................................................................. 17

Settings tag .............................................................................................................. 17

Examples of Matrix-X usage ............................................................. 18

Stand-alone Mode .................................................................................................. 18

Connecting to a synthesizer or electric piano for live performance ................ 18

Listen to music ................................................................................................ 18

Practice or play Electrical Guitar / Bass along with music .............................. 18

Vocal Practice and Karaoke ............................................................................ 19

Working together with computer ......................................................................... 20

Recording from the Line In ............................................................................. 20

Recording from a microphone ........................................................................ 20

Recording an Electric guitar (or bass) ............................................................ 20

Matrix-X setting chart ....................................................................... 21

Specications ................................................................................... 22

System requirements ....................................................................... 22

Matrix K FW technical information .................................................. 24

Matrix K USB technical information ................................................ 25

Matrix K User's Manual

Introduction

The Matrix K is a small, multi-function, professional audio system, which integrates a

microphone pre-amplier with +48V phantom power, a Direct Box for connecting a guitar or

bass, a 3-channel dual bus stereo mixer and dual headphone amplifiers. The unique dual bus

design makes Matrix K the best choice for use with a computer based hard-disk recording system

or when you want to add a microphone to a digital instrument with line in and line outs. For

example, use the Matrix K with a synthesizer with a sampling function or to add vocals to a

digital piano with line inputs and outputs.

After connecting Matrix K to your computer, your new music-making system will include

many practical and convenient functions. Matrix K features not only inputs and outputs for

transmitting signal to/from computer but also two headphone outputs with volume control

knob for different monitoring needs. Matrix K also features different connectors such as Line

In, Monitor Output, gain adjustable Mic In and Guitar In to satisfy all of your music-making

needs. In addition, the Line In of Matrix K can receive un-balanced signals and convert into

balanced signals. Furthermore, Matrix K provides +48V phantom power to support professional

microphones.

Matrix K is bus powered when it connects with computer via IEEE 1394 port (Matrix K FW)

or USB port (Matrix K USB). It works with full functions without any other extra power adaptor

is needed.

Hardware Direct Monitor is another advantage for Matrix K users. Signals from the Line

In, Mic In or Guitar In can be sent to the headphone outputs or monitor speakers directly by

pressing the Direct Monitor button. Un-pressing the button will route those signals to the

computer and then out through Matrix K back to the headphone output or monitor speakers. This

is a convenient function to compare the sound before and after processing and recording on the

computer.

Besides working with computer, Matrix K can be used as a stand-alone device to add a

microphone or guitar to a keyboard that has a line in and out. Simply connect the audio matrix

and you can easily add a microphone or guitar to a digital piano with speakers or increase in the

number of headphone outputs.

Matrix K is a unique utility mixer that ts many different audio applications because of its

exible and powerful design. It’s especially useful in a small computer recording environment.

You’ll nd that Matrix K will come in handy for many different situations and that it’s quality

and cost performance is outstanding.

Matrix K User's Manual 7

Congurations

Front Panel

Matrix K front panel has all of the input gain and output volume control knobs, and the

switches for direct monitor, phantom power and guitar signal. Below is the detail of Matrix K

front panel.

1. XLR / TS combo connector

You can connect a microphone or electrical guitar here. The XLR input is balanced and

provides 48V phantom power (by pressing the “48V On / Off” button). It is suitable for

professional condenser microphones. The ¼” connector is un-balanced and is suitable for

dynamic coiled microphone and electric guitar or bass.

2. Mic / Guitar In

Adjusts the gain of the signal from the combo connector.

3. In Peak

After activating “Direct Monitor” function. A red LED ashes when the input signal level is

near distortion indicating it would be better to lower the input gain.

4. In Level

After activating “Direct Monitor” function. A blue LED will light up and ash if signal is

available at the input channel.

5. Stereo In Vol.

Adjusts the volume level of the Stereo In.

6. Line Out vol.

Adjusts the volume level of Line Out.

7. Head Phone Vol.

Adjusts the volume level of Head Phone 1 and Head Phone 2.

8. Head Phone 1

The rst headphone output connector (stereo).

Matrix K User's Manual

9. Phantom power LED

This LED will light up when phantom power supply is turned on and is providing power to

XLR input.

10. 48V On / Off

Switches the phantom power on or off. Turn phantom power on by pressing the button.

11. Guitar On / Off

Pressing this button will activate the TS connector of the combo connector to receive external

signals.

12. Direct Monitor

Switches the direct monitor function On or Off. Pressing this button down, all of the input

signals will be sent to Head Phone 1 / 2 and Line Out directly. If you are using recording software

to record, you should un-press this button to avoid latency while monitoring.

13. Power LED

This LED will light up when it is turned on.

Rear Panel of Matrix K FW

The main input and output connectors are in rear panel of Matrix-X.

14. Power Input

Plug the bundled power adapter here for supplying power to the Matrix K. To avoid voiding

your warranty, only use the power adapter supplied for use with Matrix K.

15. Power On

Power switch. It just switches the power while using power adaptor. The power from IEEE

1394 or USB bus is not been controlled.

16. Line Out

Signal monitor output connectors, the left channel is on the top, the right channel is on the

bottom. Both of the two connectors are balanced 1/4” TRS jacks.

17. Head Phone 2

The second headphone output connector (1/8”, stereo).

Tabla de contenidos

Otros manuales de Sistema estéreo de C-me

C-me

C-me Matrix X Manual de usuario

Manuales populares de Sistema estéreo de otras marcas

LG CM3330B Manual de usuario

Sony

Sony SS-CEP50 Manual de usuario

Cetacea Sound

Cetacea Sound CVS-II Manual de usuario

Aiwa

Aiwa XR-H66MD Manual de usuario

Denon

Denon UCD-250 Manual de usuario

Sanyo

Sanyo DC-MX41i Manual de usuario

Sharp

Sharp CD-ES600V Manual de usuario

Exibel

Exibel BDX600-UK Manual de usuario

Sanyo

Sanyo DC-F320 Manual de usuario

Philips

Philips FWM583X Manual de usuario

Sharp

Sharp CD-C462 Manual de usuario

Onkyo

Onkyo CBX 300 - CD / MP3 Clock Radio Manual de usuario

Aiwa

Aiwa XR-EM70 Manual de usuario

Cyrus

Cyrus Lyric Manual de usuario

Philips

Philips MCM159/98 Manual de usuario

Philips/Magnavox

Philips/Magnavox Magnavox FW 62C Manual de usuario

RCA

RCA RS3965SB Manual de usuario

Sharp

Sharp XL-UH240 Manual de usuario