Bushnell Equinox 260228 Manual de usuario

InstructIon

manual Model #: 260228

Lit. #: 98-2043/03-13

2x28

NIGHT VISION

MONOCULAR

EQUINOX™

ENGLISH 310

FRANÇAIS 1118

ESPAÑOL 1926

DEUTSCH 2734

ITALIANO 3542

PORTUGUÊS 4350

Parts anD controls rEFErEncE

ENGLISH

Congratulations on the purchase of your Bushnell Equinox Night Vision Monocular. Bushnell Night Vision

products are comprised of high quality image intensier tubes and optics, which amplify existing light,

allowing you to see in conditions where light levels are too low for the unaided eye.

HOW NIGHT VISION WORKS

Bushnell night vision models with analog (“Gen 1”) technology collect and amplify existing light through

the objective lens, which is then focused on the image intensier. Inside the intensier, a photocathode is

“excited” by the light and converts the photon energy into electrons. These electrons accelerate across an

electrostatic eld inside the intensier and strike a phosphor screen (like a green monochrome TV screen)

which emits an image that you can see. It is the acceleration of electrons, which provides gain and enhances

the image. Your Equinox Night Vision model is categorized as a“Generation 1”type of night vision unit, and

is ideal for a variety of applications and recreational uses including: hunting, camping, boating/shing,

caving, paintball, stargazing, rescue/recovery, security surveillance and law enforcement.

INSTALLING THE BATTERY

ThisunitoperatesononeCR123lithiumbattery.Toinstall,removetheBatteryCompartmentCover(1)located

on the front of the unit by unscrewing it (counter-clockwise). Insert the battery into the compartment, with

the at (negative) end facing out towards the spring in the cover. Screw the Battery Compartment Cover

back in place (clockwise).

BASIC OPERATION

Make sure a fresh battery has been installed correctly, as described in“Installing the Battery”.

If you wish to test your Equinox Night Vision unit in a lighted area, be sure the objective lens cap (included,

not shown) is covering the Objective Lens (2) prior to pressing the ON Button (3). The objective lens cap has

a pinhole opening to admit a small amount of light for testing purposes. When testing or using the unit in

the dark, remove the objective lens cap and activate the unit by pushing the ON Button. The green Power

LED (4) indicates that the unit’s power is on. Always remember to turn the unit o when done. Do not store

this unit while the indicator is lit.

CAUTION:Thisunit canbeused inextremecoldweather.However,whenthe unitis broughtbackintoawarmenvironment,

you must wait approximately 5 hours before using the unit again. Damage may occur due to condensation that may have

accumulated on the internal circuitry of the unit.

USING THE INFRARED (IR) ILLUMINATOR

Your Equinox Night Vision oers a built-in Infrared Illuminator (5). This allows you to see even in complete

darkness where no ambient light source, such as moonlight, is available. To activate, simply press the IR

Button (6) located next to the ON Button. The red IR LED (7) indicates that the Illuminator is on. The IR

Illuminator beam features an adjustable coverage angle. To narrow the beam, turn the IR Illuminator Hood

(8) counterclockwise and pull forward. To make the beam wider, push the IR Illuminator Hood (8) back and

turn it clockwise.

FOCUSING

Direct the unit at an object at a distance of approximately 100 yards and rotate the Eyepiece Ring (9) to

give the best image quality for your eyesight. After making this adjustment, it should not be necessary to

change the setting of the eyepiece unless it is moved accidently. You will use just the Objective Lens Ring

(10) to focus on objects at dierent distances. Direct the unit at the subject to be viewed and adjust the nal

focus by rotating the Objective Lens Ring (10) until the image appears as sharp as possible.

TRIPOD/ACCESSORY MOUNTING

Your Equinox can be mounted on any tripod with a standard ¼” socket. A built-in accessory mounting rail

(11) enables the user to attach a laser (for aiming purposes) or other compatible accessories (not included).

TROUBLESHOOTING

Scope will not turn on.

Check that the batteries are installed properly. Replace the batteries with new ones. Check the battery contacts to ensure

it is clean and free of corrosion. Check that the power is in the“ON”position.

Image is not focused.

Adjust the focus on the Eyepiece (9). Adjust the Objective Lens (10). If still no improvement, clean the lenses; they may

be foggy or dusty.

Visibility decreases or disappears.

Bright light sources such as headlights may cause visibility to degrade or disappear completely. Turn the Power OFF (3)

and turn the scope away from the light source. The unit will restore itself in 1 or 2 minutes.

Conditions such as fog or extremely dark environments will decrease visibility.

Scope ashes.

The scope may ash when used in a bright environment. It may also ash during the rst few seconds of use in dark

environments.

Spots in the image

You may see spots in the image.These vary from unit to unit and are cosmetic blemishes inside the unit. These are normal

for Night Vision units and are NOT a defect.

CARE AND MAINTENANCE

Your Bushnell Night Vision unit was designed to provide many years of reliable service. To ensure that you get the most

enjoyment out of your Night Vision unit, always obey the following warning and precautions:

• This unit was designed to be self-contained. Do not open the body of the unit or otherwise attempt to service this

unit.

• Always store the unit in a dry, well-ventilated room.

• Remove the battery if the unit is to be stored for longer than 2 months.

• Keep the unit away from any heating and air conditioning vents or other heating units, direct sunlight, and

moisture.

• Avoid dropping or otherwise shocking the unit. Although designed for rugged outdoor use, this unit incorporates

a sophisticated optical system, which could be damaged in extreme cases of misuse.

WARNING: Do not point this unit toward any light source greater than lux such as car headlights, for an extended period

of time. This unit utilizes an internal ash protection system, which minimizes potential damage, but long-term exposure

to bright lights can damage the unit. Any such damage may void your warranty.

Note: failure to follow the cautions and warnings as stated in this

manual may damage the unit and void the manufacturer’s warranty.

*Maximum distance at which a human gure can be recognized under ideal viewing conditions; dened as clear conditions

(no fog, dust, etc.) under the light of 1/4 moon.

Class 1 LED product per IEC 60825-1/Nov 1993, appendix EN 60825-1A11/Oct1996

Magnication 2.0x

Objective Size 28mm

Vertical Resolution 36 lines/mm

Viewing Range (ft/m.)* 660 / 201

Field of View 112 ft @ 100 yds/37 m @ 100 m

Battery Type CR123 (1)

Operating Time Up to 20 Hours

Temperature Range -22º to 113º F

Water Resistance Rating IPX4

Dimensions (H x W x L) 53 x 82 x 153 mm

Weight (oz/g) 8.8 / 250

SPECIFICATIONS

Fcc notE

This equipment has been tested and found to comply with the limits for a Class B digital unit, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

•Reorientorrelocatethereceivingantenna.

•Increasetheseparationbetweentheequipmentandreceiver.

•Connecttheequipmentintoanoutletonacircuitdierentfromthattowhichthereceiverisconnected.

•Consultthedealeroranexperiencedradio/TVtechnicianforhelp.

Shielded interface cable must be used with the equipment in order to comply with the limits for a digital unit pursuant to Subpart B of Part

15 of FCC Rules.

Specications and designs are subject to change without any notice or obligation on the part of the manufacturer.

Disposal of Electric and Electronic Equipment

(Applicable in the EU and other European countries with separate collection systems)

This equipment contains electric and/or electronic parts and must therefore not be disposed of as normal household

waste. Instead, it should be disposed at the respective collection points for recycling provided by the communities. For

you, this is free of charge.

If the equipment contains exchangeable (rechargeable) batteries, these too must be removed before and, if necessary, in

turn be disposed of according to the relevant regulations (see also the respective comments in this unit’s instructions).

Further information about the subject is available at your community administration, your local waste collection

company, or in the store where you purchased this equipment.

ONE-Year LIMITED WARRANTY

Your Bushnell®product is warranted to be free of defects in materials and workmanship for one year after the date of

purchase. In the event of a defect under this warranty, we will, at our option, repair or replace the product, provided that

you return the product postage prepaid. This warranty does not cover damages caused by misuse, improper handling,

installation, or maintenance provided by someone other than a Bushnell Authorized Service Department.

Any return made under this warranty must be accompanied by the items listed below:

1) A check/money order in the amount of $10.00 to cover the cost of postage and handling

2) Name and address for product return

3) An explanation of the defect

4) Proof of Date Purchased

5) Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit, with return postage

prepaid to the address listed below:

IN U.S.A. Send To: IN CANADA Send To:

Bushnell Outdoor Products Bushnell Outdoor Products

Attn.: Repairs Attn.: Repairs

9200 Cody 25A East Pearce Street, Unit 1

Overland Park, Kansas 66214 Richmond Hill, Ontario L4B 2M9

For products purchased outside the United States or Canada please contact your local dealer for applicable warranty

information. In Europe you may also contact Bushnell at: Bushnell Germany GmbH

European Service Centre

Mathias-Brüggen-Str. 80

D-50827 Köln

GERMANY

Tél: +49 221 995568-0

Fax: +49 221 995568-20

This warranty gives you specific legal rights.

You may have other rights which vary from country to country.

Tabla de contenidos

Idiomas:

Otros manuales de Monóculo de Bushnell

Bushnell

Bushnell NIGHT VISION 26-2429 Manual de usuario

Bushnell

Bushnell 191144 Manual de usuario

Bushnell

Bushnell Night Vision 26-0100 Manual de usuario

Bushnell

Bushnell Night Vision 26-0100 Manual de usuario

Bushnell

Bushnell Imageview Spotting Scope Manual de usuario

Bushnell

Bushnell AR142BK Manual de usuario

Bushnell

Bushnell 26-2013 Manual de usuario

Bushnell

Bushnell Night Vision 26-2024 Manual de usuario

Bushnell

Bushnell Night Vision 26-0224W Manual de usuario

Bushnell

Bushnell 06-1729/03-01 Manual de usuario

Bushnell

Bushnell Night Vision 26-2042 Manual de usuario

Bushnell

Bushnell 26-0300 Manual de usuario

Bushnell

Bushnell 260332 Manual de usuario

Bushnell

Bushnell Night Vision 260224 Manual de usuario

Bushnell

Bushnell Legend Ultra HD Manual de usuario

Bushnell

Bushnell 180825 Manual de usuario

Bushnell

Bushnell 26-4202 Manual de usuario

Bushnell

Bushnell Night Vision 26-0100 Manual de usuario

Bushnell

Bushnell 26-0300 Manual de usuario

Bushnell

Bushnell 5 X 20 GOLF SCOPE Manual de usuario

Bushnell

Bushnell ImageView 11-8000 Manual de usuario

Bushnell

Bushnell Equinox 260330 Manual de usuario

Bushnell

Bushnell 26-0200 Manual de usuario

Bushnell

Bushnell Equinox Z 260130 Manual de usuario

Manuales populares de Monóculo de otras marcas

Zeiss

Zeiss Victory 8 x 26 T* PRF Manual de usuario

ATN

ATN PS14-3A Manual de usuario

Pulsar

Pulsar 71011 Manual de usuario

PHOTONIS

PHOTONIS TacFusion Manual de usuario

Opticron

Opticron Imagic IS Guía de instalación

Night Vision

Night Vision NOXM50 Manual de usuario

ATN

ATN Night Vision Spotting Scope Night Storm-HPT Manual de usuario

ATN

ATN Night vision Monocular MO-4 Manual de usuario

Leica

Leica Monovid 8x20 Manual de usuario

StellaX

StellaX ZoomX X-003 Manual de usuario

AGM

AGM ASP-MICRO TM160i Manual de usuario

Zeiss

Zeiss DTI 6/20 Manual de usuario

Dali

Dali S25 Series Manual de usuario

Zhumell

Zhumell WATERPROOF ZOOM MONOCULAR 10-25X42 Manual de usuario

Levenhuk

Levenhuk Fatum Z1000 Manual de usuario

ATN

ATN 8x20 Silver Eye Manual de usuario

Vortex

Vortex Solo 36 mm Manual de usuario

Night Owl

Night Owl Night Scope NOXM50-DG Manual de usuario