Buffalo PL-05H Series Manual de usuario
User Manual
Powerline 500AV Adapter
Powerline 500AV Adapter Starter Kit
PL-05H Series
www.bualotech.com
English
PL-05H Series User Manual 1
Contents
Chapter 1 - Product Overview .........................................3
Features .................................................................................. 3
Hardware Overview ................................................................. 3
Front Panel LEDs ........................................................................... 3
Bottom ............................................................................................ 4
Side ................................................................................................ 5
Back Side ....................................................................................... 5
Chapter 2 - Installation .....................................................6
Maximizing the Performance of Your PLC devices ................. 6
Starter Kit Installation Procedure ............................................ 6
Extender Kit Installation Procedure ......................................... 9
Chapter 3 - Troubleshooting ............................................12
Cannot connect to the Internet over a wired connection. ........ 12
If the PLC devices are reset, they are disconnected from
the network. ............................................................................. 12
Other Tips ................................................................................ 13
Chapter 4 - TCP/IP Settings .............................................14
Windows 8 ............................................................................... 14
Windows 7 ............................................................................... 15
Windows Vista ......................................................................... 16
Windows XP ............................................................................ 17
Mac OS ................................................................................... 18
12
PL-05H Series User Manual 3
Chapter 1 - Product Overview
Features
Supports Homeplug AV 500
High-speed home network via household electrical wiring with transmission rates of up to 500
Mbps.
Gigabit Ethernet
This unit supports gigabit Ethernet, allowing transmission rates of up to a billion bits per second.
Hardware Overview
Front Panel LEDs
1Power LED (Green)
Indicates the status of the power and PLC.
On : Power is on.
Blinking : PLC connection in progress.
2 blinks : PLC connection failed.
PLC connection timeout.
Either hold down the PLC button for 1 to 3 seconds, or wait for about 30
minutes for the indicator (green) to turn on.
O : Power is o.
3
PL-05H Series User Manual 4
Chapter 1 Product Overview
Bottom
3LAN Port Connect your computer, hub, or other Ethernet devices to these ports.
This port supports 10 Mbps, 100 Mbps, and 1000 Mbps connections.
2PLC LED (Green)
Indicates the PLC status.
On : PLC connected.
O : PLC is disabled.
4
5
6
Chapter 1 Product Overview
PL-05H Series User Manual 5
Side
4PLC Button
Hold down
for 1 to 3 seconds:
This starts the PLC connection process or cancels the connection process.
If the Power LED indicates that the PLC connection has failed, the Power
LED stops blinking.
Hold down
for 10 seconds:
This disconnects the PLC connection.
5Reset Button
To reset all settings, hold down this button until the amber power LED ashes (about 3
seconds). Power must be on.
Back Side
6Factory Default Settings This sticker shows the MAC address and Device Password.
Room 1 Room 2
Powerline
PLC device
(Starter kit)
modem or router
Internet
TV
(with an Ethernet interface) computer
PLC device
(Starter kit)
PL-05H Series User Manual 6
Chapter 2 - Installation
Starter Kit Installation Procedure
To congure the Starter Kit, follow the procedure below.
Maximizing the Performance of Your PLC devices
For best performance, plan the location of your PLC devices:
Use an electrical outlet that is not controlled by a wall switch to avoid someone unknowingly
turning off the power to the outlet.
Don’t plug in PLC devices to a power strip, extension cord, or surge protector as this might
prevent them from working correctly or reduce the network performance.
· Avoid plugging PLC devices into electrical outlets located near an appliance that uses a lot of
power, such as a washer, dryer, or refrigerator. This could potentially prevent the PLC devices
from working correctly, or reduce network performance.
Room 1
Room 2
modem or router
Internet
PLC device
PLC device
Chapter 2 Installation
PL-05H Series User Manual 7
5Bring the other PLC device to the location where you want to
install it and connect it to the power outlet.
1Check that connection to the Internet is possible without using the PLC devices. Then, turn
o the modem or router.
2
3
4
Connect one end of the LAN cable to the modem or
router, and connect the other end to the LAN port of the
PLC device.
Turn on the modem or router.
Connect the PLC device to the power outlet.
Once the PLC device is turned on, check that the LEDs appear as shown below:
Power Green LED on.
PLC O
For LED locations, refer to chapter 1.
Room 2
PLC device
PL-05H Series User Manual 8
Chapter 2 Installation
6Check that the LEDs appear as shown below when the power is turned on.
Power Green LED on.
PLC Green LED on.
For LED locations, refer to chapter 1.
Note: If the PLC LED does not turn on even after waiting one minute, install near the rst PLC device that
was installed in step 3.
7
Connect the LAN port to your computer or TV
with a LAN cable.
8Start your browser. If the home screen is displayed, setup for the second PLC device is
complete.
Note: If the home screen is not displayed, check that the PLC device and computer are connected correctly.
Room 1 Room 2 Room 3
Powerline Powerline
Room 3
Room 3
modem or router
Internet
computer
PLC device
(Extender kit)
PLC device
(Starter kit)
PLC device
(Starter kit)
TV
(with an Ethernet interface)
TV
(with an Ethernet interface)
PLC device
(Extender kit)
PLC device
(Extender kit)
PLC button
Chapter 2 Installation
PL-05H Series User Manual 9
Extender Kit Installation Procedure
To congure the Extender Kit, follow the procedure below.
1Bring the PLC device to the location where you want to install it and
connect it to the power outlet.
2Hold down the PLC button of the PLC device over 10
seconds when the PLC device power is turned on.
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Adaptador de Buffalo
Buffalo
Buffalo Buffalo AirStation WLI-CB-G54HP Manual de usuario
Buffalo
Buffalo AirStation WLI-CB-G54L Manual de usuario
Buffalo
Buffalo AirStation WLI-CB-G54S Manual de usuario
Buffalo
Buffalo AirStation WI-U2-433DM Manual de usuario
Buffalo
Buffalo AirStation WLI-U2-KG125S Manual de usuario
Buffalo
Buffalo AirStation WLI-CB-G54S Manual de usuario
Buffalo
Buffalo AirStation Nfiniti WLI-U2-G300N Manual de usuario
Buffalo
Buffalo AirStation WLI-CB-G54L Manual de usuario
Buffalo
Buffalo AirStation WLI-CB-G54S Manual de usuario
Buffalo
Buffalo AirStation WLI-U2-SG54HG Manual de usuario
Buffalo
Buffalo AirStation Mimo WLI-CB-G108 Manual de usuario
Buffalo
Buffalo AirStation Nfiniti WLI-CB-AG300NH Manual de usuario
Buffalo
Buffalo WLI-CB-G54 Manual de usuario
Buffalo
Buffalo AirStation Manual de usuario
Buffalo
Buffalo WLI-UC-GNHP Manual de usuario
Buffalo
Buffalo AirStation Dual A&G WLI-CB-AG108HP Manual de usuario
Buffalo
Buffalo AirStation WLI-CB-B11 Manual de usuario
Buffalo
Buffalo AirStation G54 Hoja de especificaciones
Buffalo
Buffalo AIRSTATION WLI2-USB2-G54 Manual de usuario
Buffalo
Buffalo AirStation WLI-U2-KG125S Manual de usuario
