BTC BCO5232IB Manual de usuario
DDS Combo Drive
52x/32x/52x/16x
Dual Digital Storage
7 in 1 card reader compatibility
User’s Manual
CAUTION
CLASS 3B VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN.
AVOID DIRECT EXPOSURE TO BEAM.
VORSICHT
KLASSE 3B SICHTBARE UND UNSICHTBARE LASERSTRAHLUNG WENN
GEOFFNET. NICHT IN DEN STRAHL SEHEN.
ATTENTION
RADIATION DU FAISCEAU LASER VISIBLES ET INVISIBLES DE CLASSE 3B
EN CAS D'OUVERTURE. EVITER TOUTE EXPOSITION AUX RAYONS.
Copyright Statement
It is a criminal offence, under applicable copyright laws, to make
unauthorised copies of copyright-protected material, including computer
programs, films, broadcasts and sound recordings. This equipment
should not be used for such purposes.
CLASS 1 LASER PRODUCT
APPAREIL A LASER DE CLASSE 1
LASER KLASSE 1
LUOKAN 1 LASERLAITE
PRODUIT LASER
CATEGORIE 1
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FOR EUROPE
“The drive is in conformity with the EMC directive and low-voltage directive.”
Table of Contents
INTRODUCTION 1
SYSTEM REQUIREMENTS 2
PACKAGE CONTENTS 2
INSTALLATION 3
HOST INTERFACE CONNECTIONS 3
HARDWARE INSTALLATION 4
SOFTWARE INSTALLATION 6
DVD REGION CODE 7
OPERATION & CONNECTION 9
FRONT PANEL 9
REAR VIEW 11
TECHNICAL DATA 13
DDS Combo Drive
1
INTRODUCTION
Welcome to a multimedia world of CD-ReWritable technology, DVD-ROM
capabilities and, memory card compatibility!
This compact and high-performance Combo Drive frees up precious bay
space and presents you as an IDE Combo (CD-RW+DVD ROM) Drive and
a USB-connected card reader. It reads CDs of all types at maximum 52X
speed, and DVD-ROMs at maximum 16X speed. For the writing ability, it
writes to CD-Rs at up to 52X speed, and to CD-RWs at up to 32X speed.
Other than that, the built-in 7 in 1 card reader which offers read-write ability
of 7 memory card types simplifies the process of exchanging data between
digital cameras, voice recorders, PDAs, MP3s… and your computer.
With this multi-functional solution and the bundled software package, you
can view, archive, or write files/photos/video/music directly from the drive
and enjoy the fascinating digital and DVD entertainment on your desktop.
Here are some important features:
♦ Easy installation with Combo drive of EIDE and card reader of
USB 2.0 interface (on board connection)
♦ 8X, 16X, 24X, 32X, 40X, 48X and 52X writing speed on CD-R
media
♦ 4X, 10X, 12X, 16X, 24X and 32X writing speed on CD-RW media
♦ Adopts “MTKSuperLink” to prevent Buffer Underrun
♦ Supports writing modes of TAO, DAO, SAO and packet writing
♦ Supports MultiRead function
♦ Smooth DVD playback of high resolution
♦ Convenient connection with A-Type USB Extension Port on the
front panel
DDS Combo Drive
2
♦ Four-slot integration of the card reader works with CompactFlash,
MicroDrive, Memory Stick, Memory Stick Pro, MultiMediaCard,
Secure Digital, and SmartMedia
System Requirements
For IBM compatible PCs, the system requirements recommended are as
follows:
♦ Pentium II, Celeron 400MHz or above with at least 64MB of
memory
♦ Fast and sufficient hard disk space (minimum 200MB for
installation, 1GB or more is recommended.)
♦ IDE host interface supporting ATAPI MMC command & USB host
interface (if you don’t have USB on-board connection)
♦ Microsoft Windows 98SE/2000/ME/XP
Package Contents
The package contains the following items:
♦ DDS Combo Drive
♦ Audio cable
♦ Application software discs x 2
♦ Quick Installation Guide
DDS Combo Drive
3
INSTALLATION
Host Interface Connections
Most current motherboard models have two IDE ports (primary and
secondary), which can connect two IDE cables. Two IDE cables allow you
to connect up to four devices, but it is recommended that you separate IDE
ports for your hard disk and your Combo Drive. This will ensure that your
hard disk’s performance and speed won’t be affected by having the drive
on the same cable.
Jumper Setting
On the rear panel of this drive, you will find three pairs of jumpers: CS
(CSEL), SL (Slave) and MA (Master). Use the jumper cap to set the device
to CS, SL or MA mode corresponding to your PC configuration. If you
connect only one device on the IDE cable, you can set the jumper as
“MASTER” or “SLAVE”.
Cable Select
Slave
Master
If you connect two devices on the same cable, set different jumper for each
device (one as “MASTER”, and the other one as “SLAVE”). The same rule
applies to the connection of having your hard disk and another device on
the same cable.
DDS Combo Drive
4
Master
Cable Select
Slave
Jumper
The system might not detect the drive if there is conflict or mistake with the
jumper setting.
Hardware Installation
1. Turn off the power to your computer system.
2. Disconnect the power cord and all cables from the back of your
computer, and then remove the cover of the computer.
3. Insert the drive into one of the vacant 5.25" drive bays and secure it
to your PC with all four mounting screws.
4. Connect one end of the 40-pin IDE cable to the IDE connector of this
drive and the other end to the IDE port on your motherboard. Also,
connect the power supply cable to the back of the drive.
Digital
Audio Output
Audio Out IDE Cable
USB Cable
Power In
Make sure to align and connect the red-edge of the IDE Cable to Pin 1 on
the drive.
DDS Combo Drive
5
5. If you have a sound card that can be connected to the drive, you can
also connect the drive (as Audio-Out) and the sound card (as Audio-
in) with a 4-pin audio cable.
If your motherboard is integrated with built-in sound system, plug the
4-pin audio cable into the CD-IN connector on the motherboard as
Audio-in.
6. Connect the USB cable at the back of the drive to the USB header
on the computer’s motherboard. The red wire of the cable needs to
be plugged into Pin 1 on the board.
This drive supports USB 2.0 and if you connect to USB 1.1 connector,
only transfer rate of USB 1.1 will be available.
USB Header
2 / 7
White/D-
Braided Shield Ground
Error-Proof Pin
Black/Ground
Green/D+
5
10
4 / 9
3 / 8
Mother
Board
Signal
Red/Vcc
Pin#
1 / 6
IDE
Red Wire
Error-Proof Pin
USB
Red Wire
If the connection is correct, the lower right LED on the front panel will
light green.
7. Re-attach the cover of the computer, and reconnect the power cord
and all cables to the computer.
DDS Combo Drive
6
Software Installation
Burning Software
The bundled recording software gives you the complete solution for making
audio/data CDs. With the user-friendly interface, it guides you through the
creation and backup of files/photos/video/music from your computer to a
recordable compact disc. Combining of the card reader capabilities, no
matter you are a novice or an experienced user; you can enrich your digital
life with this best recording tool.
DVD Playback Software
The DVD playback software comes with leading video and audio
technologies to deliver the highest sound and visual effect possible on the
PC. Meanwhile, it offers feature-rich navigation controls for an interactive
and tailored DVD movie viewing experience. You can enjoy the wide range
of educational and entertaining DVD titles with theater quality.
Windows Environment
1. Insert the application CD and the installation program will run
automatically. Then follow the on-screen procedures.
Or
2. Run:\setup.exe on the application CD.
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Unidad de DVD de BTC
BTC
BTC BCO4816IA Manual de usuario
BTC
BTC BCO4816UI Manual de usuario
BTC
BTC BCO 5216UI Manual de usuario
BTC
BTC BCO4816IM Manual de usuario
BTC
BTC DRW1108UB Manual de usuario
BTC
BTC BDV 316E Manual de usuario
BTC
BTC BCO5232IM Manual de usuario
BTC
BTC BCO2408SU Manual de usuario
BTC
BTC BCO5232UI Manual de usuario
BTC
BTC BCO5216IB Manual de usuario
