4
1300 276 642bromichotwater.com
• Read all instructions before installing or using this appliance.
• Installation must be performed by a qualified technician in compliance with AS/NZS 3500.4, Clause G12 of the
NZ Building Code, and all other current national and local regulations.
• Retain this manual for future reference.
• Use this appliance only as described in this manual. Any other use not recommended by the manufacturer may
cause fire, electric shock, injury or death to persons.
• Improper installation, adjustment or alteration and failure to follow the warnings and instructions in this manual
could result in severe personal injury, death or property damage.
• The manufacturer is not responsible for any damage that could happen from improper use. The manufacturer
emphasises that this appliance should be used in a responsible manner and that all procedures, warnings, and
safety instructions contained in this booklet be followed strictly.
• Check the appliance for damage. Do not operate a damaged unit.
• Check for damage to the appliance regularly. If damage to the appliance is suspected, discontinue use
immediately and contact the supplier or qualified person to repair.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
• Keep packaging material out of reach of children.
• Children should be carefully supervised to ensure that they do not play with the appliance.
• Do not attempt to alter the appliance in any manner.
• The hot water system must be installed with the supplied vented tap. No other components are allowed to be
fitted to this hot water system, this includes tempering valves, filters, aerators etc.
• Water with a temperature higher than 40°C has the potential to cause serious burns, particularly in children.
• This appliance is capable of heating water to a temperature of 70°C, and thus CANNOT be installed in sanitary
fixtures used primarily for personal hygiene.
• Do not perform maintenance until the appliance has been turned o and power disconnected.
• Do not operate the appliance with panels, covers or guards removed.
• If the supply cord becomes damaged, it must be replaced by an authorised service agent or similarly qualified
person in order to avoid a hazard.
• If the appliance has not been used, or will not be used for a long period of time, disconnect power supply.
• Heater installation, electrical and hydraulic/plumbing work must be performed by a qualified technician.
• An extension cord must not be used to connect the heater to power.
• Do not install appliance where room temperatures fall below 0°C.
• Install the appliance vertically and near the draw point. Mounting orientation must be according to the heater’s
model (see Section 4.1 and 4.2). Installation and use of the heater in opposite/incorrect orientation will cause
permanent damage to the appliance.
• Do not connect the heater to the electric mains until the tank is filled with water and all water connections are
tight.
• Do not operate the appliance when the water has been emptied from the unit or pipes.
• Equipment has a maximum pressure rating of 600kPa. A Pressure reducing valve must be installed for
applications where supply pressures exceed this rating. Installation of PLVs must be in accordance with
national and local regulations.
2. IMPORTANT NOTES AND WARNINGS
IMPORTANT
