Britax Steelcraft Agile SH908 Manual de usuario

• Do not allow children to stand on the seat.

• Do not hang bags or goods from the handle as this could cause

the stroller to tip over.

• To prevent the risk of the stroller catching fire, do not park it near an

exposed heat source such as a radiator, an open fire or a barbecue,

etc.

• Do not run while using this product.

• Always lock swivel wheels when on rough surfaces as this will help

eliminate wheel wobble.

• Always raise the leg support (where fitted) to its highest position

when transporting a baby. This will reduce the risk of the baby

falling out through the front of the stroller if not correctly

harnessed.

• It is unsafe to use accessories other than those tested and approved

by Britax. For maximum safety only use accessories designed for this

stroller.

• Do not place more than 4kg in the basket or 1kg in the Canopy

Pocket (if supplied)

• The maximum weight of the child using this product is not to

exceed 17kg for the Stroller or 9kg for the Infant Carrier.

FOR WARNINGS ON ACCESSORIES - REFER TO THEIR INDIVIDUAL

SECTIONS IN THIS BOOK. THE MAXIMUM WEIGHT VARIES FOR EACH

ACCESSORY.

NOTES

04 29

IMPORTANT

The upright positions are not suitable for use with children less

than six months old. The lowest recline position should be used

to transport babies, and the backrest can be adjusted to a more

upright position as the child grows older and is able to support

its head without assistance.

SAFETY WARNING

The sun is very strong. DO NOT LEAVE YOUR CHILD EXPOSED TO THE

SUN.The canopy or hood on this product will not give your child

total protection from the harmful rays of the sun.

PARTS LIST NOTES

PARTS LIST

A 1 x Stroller Frame, Seat & Basket

B 1 x Canopy

C 2 x Rear Wheels

D 2 x Front Wheels

E2 x Infant Carrier Adaptors

14. TO RELEASE THE INFANT CARRIER (Cont)

C Lift and remove the Infant Carrier away from the stroller.

D To remove the adaptors, press the red lever in on the inside of

the adaptor and pull the adaptor up.

Red lever

Adaptors

ASSEMBLED STROLLER - PARTS LIST

Handle

Tether Strap

Shoulder pads

Harness

Basket

Front leg tube

Rear leg tube

Sure Lock release button

Canopy

Front canopy tube

Upper seat

Inner seat

Folding strap

Front wheel

release button

Front wheel

swivel lock

Leg rest

Lower seat

Canopy window cover

Canopy window

Canopy back flap zipper

14. TO RELEASE THE INFANT CARRIER

A To remove the Infant Carrier, squeeze both handle latches in to

release the locks.The indicator will now be RED.

B Continue to rotate the handle forward until it returns to the

upright position. Release the latches,the indicator should now

be GREEN.

Handle latch

Indicator

Handle latch

01. TO OPEN THE STROLLER

Storage

latch

A Release the storage latch (1) located on the rear leg.

Open the frame as shown by the arrows (2) until you hear a‘click’

which indicates the frame is fully opened and locked.Push down

on the stroller handle to confirm that frame is locked.

02. TO ASSEMBLE AND REMOVE THE FRONT SWIVEL WHEELS

A To assemble the front swivel wheels,take each swivel wheel

assembly and insert and push it into each of the wheel mouldings

until you hear a‘click’ which indicates the wheel is locked in.

Check each wheel is fully locked by pulling against it.

B To remove the front swivel wheels, locate and press in the red

button on top of the wheel moulding.

26 07

13. TO INSTALL THE INFANT CARRIER (Cont)

E Squeeze and release the handle latches.Then with one hand

holding the front of the Infant Carrier, push the Infant Carrier

handle all the way down until you hear it lock into the adaptors.

The handle indicator should now be GREEN and the Infant Carrier

should be locked into the adaptors. If the indicator is RED the

Infant Carrier handle is not in the locked position, repeat step D.

IMPORTANT: Ensure that the Infant Carrier is locked into place by

pulling up on both sides. Do not use the Infant Carrier if it is not

correctly installed.

Please Note:The Infant carrier has been fitted with a hood when

using the stroller.The hood can also be used in the car. Refer to

the Infant Carrier instructions regarding placing and securing

your baby in the Infant Carrier.

08 25

03. TO FIT AND REMOVE THE REAR WHEELS

04. TO USE THE SWIVEL WHEELS

A To fit the rear wheels, insert each wheel axle into the moulding

and push in until locked.You should hear a ‘click’ which indicates

the wheel has locked in. Pull on the wheel to make sure it is

engaged. Repeat the process if not locked in.

B To remove the wheels, pull the metal latch downwards on the

underneath of the brake moulding to release the wheel, and then

pull the wheel off.

A Press the swivel lock down to lock the swivel wheels.

Push the swivel wheel lock up to allow the wheels to swivel.

Note: Always lock the swivel wheels when using the stroller on

rough surfaces as it will minimise wheel wobble.

Metal Latch

C Lower the Infant Carrier into the adaptors.Press down firmly on

both sides.

D The Infant Carrier now needs to be locked securely into the

adaptors. Squeeze in and hold the latches on either side of the

handle, rotate the handle backwards.The GREEN indicator will

now turn to RED.

05. TO ATTACH AND USE THE CANOPY

A1 To attach the canopy, insert the canopy mouldings into the frame

mouldings until they connect together.The back flap of the

canopy can be attached to the main canopy with the zipper

attachment.

24 09

A2 Attach the snaps located on the straps on the sides of the canopy

to the top of the handle tubes,then fold the strap up under the

canopy back flap and secure strap with hook and loop to the

underneath of the canopy.

13. TO INSTALL THE INFANT CARRIER (Sold Separately)

A Stand in front of the stroller and pull the fabric back from the sides

of the stroller to expose the stroller hinge.Take one Infant Carrier

adaptor at a time and insert the adaptor into the stroller hinge as

shown. Push on the adaptor until you hear a‘click which indicates

the adaptor has locked in. Pull up on each adaptor to check they

have fully locked in.

B Face the feet end of the Infant Carrier towards the stroller

backrest.With the Infant Carrier handle in the upright position

locate the Infant Carrier handle mouldings over the adaptors on

either side. Notice the indicator is GREEN.

Adaptor

Indicator

Adaptor

Please Note: Fit adaptors standing in front of the stroller. Infant

Carrier adaptors are marked Left & Right for correct fitting.

10 23

05. TO ATTACH AND USE THE CANOPY (Cont) 12. TO FOLD THE STROLLER (Cont)

A3 Attach the hook square on the inside of the canopy backflap to

the loop strip on the side of the stroller.

A4 Attach the hook strip on the inside edge of the canopy to the loop

strip on the side of the stroller.

13. TO INSTALL THE INFANT CARRIER (Sold Separately)

• THE STEELCRAFT INFANT CARRIER IS THE ONLY INFANT CARRIER

DESIGNED TO FIT THIS STROLLER.

• THE INFANT CARRIER MUST BE CORRECTLY FITTED AND

LOCKED ONTO THE STROLLER.

• THE INFANT CARRIER MUST ONLY BE USED IN THE REARWARD

FACING POSITION, FITTED TO THE STROLLER FACING TOWARD

THE STROLLER HANDLE.

• SECURE THE CHILD IN THE HARNESS AT ALL TIMES.

• DO NOT LEAVE THE CHILD IN THE INFANT CARRIER FOR

EXTENDED PERIODS.

• THE INFANT CARRIER IS DESIGNED TO PROVIDE MOBILITY

OUTSIDE OF THE CAR BUT IT SHOULD NOT BE USED INSTEAD OF

AN APPROPRIATE COT.

• THE INFANT CARRIER MUST BE REMOVED FROM THE FRAME

BEFORE FOLDING.

• THE MAXIMUM WEIGHT OF THE CHILD USING THIS PRODUCT

IS NOT TO EXCEED 9kg.

Please Note: These Instructions are for installing and removing

the Infant Carrier on the stroller only.

For installing and and proper care of the Infant Carrier in the

car please follow the Instruction book that is included with the

Infant Carrier.

Tabla de contenidos

Otros manuales de Paseante de Britax

Britax

Britax Steelcraft Zapo Manual de usuario

Britax

Britax B-Ready Manual de usuario

Britax

Britax Affinity Manual de usuario

Britax

Britax BABY-SAFE PLUS II Manual de usuario

Britax

Britax B-DUAL - Manual de usuario

Britax

Britax Affinity Manual de usuario

Britax

Britax B-Ready Manual de usuario

Britax

Britax B-Smart Manual de usuario

Britax

Britax Verve Manual de usuario

Britax

Britax Chaperone Stroller Manual de usuario

Britax

Britax ACCLAIM - SERIES S400 Manual de usuario

Britax

Britax Steelcraft STROLL LITE LX5012 Series Manual de usuario

Britax

Britax B-Ready Manual de usuario

Britax

Britax Brook Manual de usuario

Britax

Britax B-Ready Manual de usuario

Britax

Britax BRITAX GO Manual de usuario

Britax

Britax ORION Manual de usuario

Britax

Britax STRIDER 4 Manual de usuario

Britax

Britax PREVIEW Manual de usuario

Britax

Britax Steelcraft Sprint Manual de usuario

Britax

Britax STRIDER PLUS - ANNEXE 534 Manual de usuario

Britax

Britax Flexx Manual de usuario

Britax

Britax romer STRIDER M Manual de usuario

Britax

Britax Strider Compact Manual de usuario

Manuales populares de Paseante de otras marcas

Hauck

Hauck Priya Trioset Manual de usuario

CHILDHOME

CHILDHOME CWQDN Manual de usuario

Dreamer Design

Dreamer Design Rebound GST Manual de usuario

Graco

Graco 7427 Manual de usuario

Comfort

Comfort COMPASS Manual de usuario

OBaby

OBaby Aura Manual de usuario

Tutek

Tutek Tirso Manual de usuario

Babify

Babify Dual Plus Manual de usuario

Graco

Graco Stroller Manual de usuario

Special Tomato

Special Tomato Jogger Manual de usuario

Chicco

Chicco CORTINA TOGETHER TWO-PASSENGER STROLLER Manual de usuario

Otto Bock

Otto Bock Kimba neo Manual de usuario

Milly Mally

Milly Mally ROYAL Guía de inicio rápido

Hauck

Hauck DUETT 3 PRAM Manual de usuario

BOB

BOB DUALLIE Manual de usuario

Nuna

Nuna Pepp Manual de usuario

Graco

Graco VERB Manual de usuario

Silver Cross

Silver Cross Jet Manual de usuario