Page 3
______________________________________________________________________________
Step 2 Adjusting the direction of rotation(Only if the direction of rotation is not correct)
Only possible i no end positions are set, otherwise irst option B (Delete end positions), a ter that, Step 2.
▲+▼ until 1x
OK
Press UP and DOWN button The direction of rotation of
Simultaneously, until the product moves. the motor is OK.
_______________________________________________________________________________
Step 3 Setting the end limits
1. Set the desired top position.
▲+ STOP 2x
OK
Use the OPERATING- buttons to Press UP and STOP simultaneously, The desired top
move the product to the desired top position. until the product moves 2x and beeps 3x. position is set.
1. Set the desired bottom position.
STOP+▼ 2x
OK
Use the OPERATING- buttons to move Press DOWN and STOP simultaneously, The desired bottom
the product to the desired bottom position. until the product moves 2x and beeps 3x. position is set.
_______________________________________________________________________________
Step 4 Setting the desired third limit position (If desired)
1x P2 1x
1x STOP 1x
1x STOP 2x
OK
Set the desired Press 1x P2. Press 1x STOP button. Press 1x STOP button.
Third limit The product moves 1x The product moves 1x The product moves 2x up
position. up and down and beeps. up and down and beeps. and down and beeps 3x for confirmation.
Press and hold STOP or 3 seconds to move to the set limit position.
______________________________________________________________________________
Additional settings
____________________________________________________________________________
Option A Adjusting the top position
If adjustment is not possible go to Option B then to Step 3.
STOP +▲ until
STOP +▲ until 2x
Go to the already Press at the same time Go to the new Press at the same time
set top position, STOP and UP until the top position. STOP and UP button, until
motor moves and beeps 1x. the motor 2x moves and 3x beeps.
