i
COPYRIGHT DECLARATION.................................................. ERROR!BOOKMARK NOT DEFINED.1
COMPLIANCES .......................................................................................................................1
1. Introduction ...............................................................................................................3
2. Getting Started...........................................................................................................3
2.1 Unpacking and Inspection .....................................................................................3
2.2 Equipment Checklist..............................................................................................3
2.3 Printer Parts ..........................................................................................................5
2.3.1 Front View......................................................................................................5
2.3.2 Rear View ......................................................................................................5
3 Setup ...........................................................................................................................6
3.1 Setting Up the Printer............................................................................................6
3.2 Loading Label Stock..............................................................................................7
3.3 Peel-Off Installation Assembly (Option).................................................................9
3.4 Loading Label for Peel-off Mode (Option)............................................................12
3.5 External Label Roll Mount Installation (Option)....................................................14
3.6 Cutter Module Installation (Option)......................................................................15
3.7 Loading Label in Cutter Mode .............................................................................18
3.8 Diagnostic Tool ...................................................................................................19
3.8.1 Start the Diagnostic Tool...............................................................................19
3.8.2 Printer Function (Calibrate sensor, Ethernet setup, RTC setup………) ........20
3.9 Setting Ethernet by Diagnostic Utility (Option).....................................................21
3.9.1 Using USB interface to setup Ethernet interface ..........................................21
3.9.2 Using RS-232 interface to setup Ethernet interface .....................................22
3.9.3 Using Ethernet interface to setup Ethernet interface ....................................23
3.10. Install Memory Card .........................................................................................25
4. Power on Utilities ....................................................................................................27
4.1 Gap/Black Mark Sensor Calibration.....................................................................27
4.2 Gap/Black Mark Calibration, Self-test, Dump Mode ............................................28
4.3 Printer Initialization..............................................................................................31
4.4 Set Black Mark Sensor as Media Sensor and Calibrate the Black Mark Sensor..32
4.5 Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor .......................32
4.6 Skip AUTO.BAS ..................................................................................................32
5. Maintenance.............................................................................................................33
5.1 Cleaning..............................................................................................................33
6. Troubleshooting......................................................................................................35
Contents
