BRAYER BR4953 Manual de usuario
Instruction manual
Инструкция по эксплуатации
Fan BR4953
Вентилятор BR4953
brayer.ru
СОДЕРЖАНИЕ
EN......................................................................................................................................3
DE....................................................................................................................................11
RU ...................................................................................................................................20
KZ....................................................................................................................................29
3
EN
FAN BR4953
The fan is intended for articial ventilation of the
room.
DESCRIPTION
1. Base
2. Pole
3. Control panel
4. Front grid
5. Blades
6. Carrying handle
7. Power cord
8. Motor unit fastening screw
Control panel
9. On/O button « »
10. Timer on icon « »
11. Night mode icon « »
12. «Natural wind» airow type icon « »
13. Display
14. Timer numeric symbols/airow speed icons
15. Fan body oscillation on/o button « »
16. On/o button « »
17. Airow speed selection button « »
18. Remote control
EN
19. On/O button « »
20. Airow speed selection button « »
21. Airow type selection button « »
22. Timer on/o button « »
23. Fan body oscillation on/o button « »
24. Battery holder
4 EN
pic. 1 pic. 2
ВКЛ/ВЫКЛ СКОРОСТЬ
ОБДУВ
ТАЙМЕР
ПОВОРОТ
1
2
3
4
5
6
7
8
9
10
11
12
13
14
151617
18
19 20
21
22
23
24
5
EN
SAFETY MEASURES AND OPERATION
RECOMMENDATIONS
Read the operation manual carefully before using
the fan; after reading, keep it for future reference.
• Use the unit for its intended purpose only, as it is
stated in this manual.
• Mishandling the unit can lead to its breakage and
cause harm to the user or damage to the user’s
property, which is not covered by warranty.
ow from the fan for a long period of time, especially
for children and the elderly.
• Do not use the power cord as a carrying handle for
the fan.
• Do not wind the power cord around the fan body.
• Provide that the power cord does not contact with hot
surfaces and sharp furniture edges.
• Protect the unit from impacts, falling, vibrations and
other mechanical stress.
• Avoid blocking the air inlet grid of the fan with foreign
objects, do not cover the unit during the operation.
• Do not use the unit in places where inammable
liquids are used or aerosols are sprayed, do not use
the unit in the places where such liquids are stored.
• Do not use the unit near heating appliances, heat
sources or open ame.
• Do not use the unit outdoors, in bathrooms or in
places with high humidity.
• Do not use the unit in proximity to the kitchen sink,
near swimming pools or other containers lled with
water.
• If the unit is dropped into water, unplug it
immediately, and only then you can take the unit out
of water. Apply to the authorized service center for
testing or repairing the unit.
• Do not touch the unit body, the power cord and the
power plug with wet hands.
• It is not recommended to use the unit during lightning
storms.
ATTENTION! A lithium battery is used in the remote
control. To avoid danger, do not allow children to play
with the battery. If your child swallowed a battery,
immediately see your doctor.
• Make sure that the operating voltage of the unit
indicated on the label corresponds to your home
mains voltage.
• Place the fan vertically on a at dry moisture- and
heat-resistant surface, do not place it horizontally and
do not turn it over.
• Do not place the fan on soft surfaces, such as
carpets with high pile, sofas or beds.
• Do not place the fan near curtains and do not direct it
to house plants.
• Do not use the fan in a limited space, for example, in
built-in cabinets or wall niches.
• It is not recommended to stay in the zone of the air
6
EN
• Do not block the airow channel and do not insert
any foreign objects into the channel.
• Never leave the unit connected to the mains
unattended.
• Unplug the unit after usage or before cleaning.
• Switch the fan o and unplug the power cord plug
from the mains socket.
• When unplugging the unit, hold the power plug and
carefully remove it from the mains socket, do not pull
the power cord, as this can lead to its damage or
cause a short circuit.
• Do not immerse the unit into water or any other
liquids.
• If water droplets fall on the fan body, switch it o and
disconnect the power plug from the mains before
touching the unit, then wipe the fan body with a dry
cloth.
• For child safety reasons do not leave polyethylene
bags used as packaging unattended.
ATTENTION!
Do not allow children to play with polyethylene bags
or packaging lm. Danger of suocation!
• Be especially careful if children or disabled persons
are near the operating unit.
• During the unit operation and breaks between
operation cycles, place the unit out of reach of
children.
• The unit is not intended for usage by physically or
mentally disabled persons (including children) or by
persons lacking experience or knowledge if they are
not under supervision of a person who is responsible
for their safety or if they are not instructed by this
person on the usage of the unit.
• From time to time check the power cord integrity.
• If the power cord is damaged, it should be replaced
by the manufacturer, a maintenance service or
similar qualied personnel to avoid danger.
• Do not repair the unit by yourself. Do not
disassemble the unit by yourself, if any malfunction
is detected, and after the unit was dropped, unplug it
and apply to the service center.
• To avoid damages, transport the unit in the original
package.
• Keep the unit in a dry cool place out of reach of
children and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, DO NOT USE THE UNIT FOR COMMERCIAL
• The unit is not intended for usage by children.
• Do not leave children unattended to prevent using
the unit as a toy.
• Do not allow children to touch the operating surface,
the unit body, the power cord or the power plug
during operation of the unit.
7
EN
OR LABORATORY PURPOSES.
BEFORE THE FIRST USE
After the unit’s transportation or storage at negative
temperature, unpack it and wait for at least 3 hours
before using it.
• Unpack the unit and remove all the packaging
materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the unit for damages, in case of damage do
not plug it into the mains.
• Make sure that specied specications of power
supply voltage of the unit correspond to the
specications of your mains. When using the unit in
the mains with 60 Hz frequency, the unit does not
need any additional settings.
• Wipe the fan body with a slightly damp cloth and then
wipe it dry.
FAN ASSEMBLY (g. 1)
• Using a screwdriver (not included in the delivery
package), screw out the fastening screw from the
bottom of the pole (2) by rotating it counterclockwise.
• Place the pole (2) into the base (1), tighten up the
fastening screw by rotating it clockwise.
• Screw out the screw (8) by rotating it
counterclockwise.
• Place the motor unit on the pole (2), tighten up the
screw (8) by rotating it clockwise, make sure that the
motor unit is securely fastened to the pole (2).
Remote control (18)
ATTENTION! A lithium battery is used in the remote
control. To avoid danger, do not allow children to play
with the battery. If your child has swallowed a battery,
immediately see a doctor.
Battery installation/replacing (pic. 2)
• Press on the clamp and remove the battery holder
(24) from the remote
• control (18) body, insert a CR2025 battery (supplied
with the unit) into the holder, strictly following the
polarity.
• Install the battery holder (24) into the remote control
(18).
Notes:
- if there is an isolation insert in the battery holder
(24), remove the insert;
- replace the battery in time;
- do not recharge the lithium battery;
- remove the battery if you are not planning to use
the unit for a long time;
- remove the used battery from the remote control
(18) and dispose of it.
8
EN
• When you use the remote control, direct it to the front
part of the fan body.
• The distance between the remote control and the fan
should not exceed 5 m, the coverage angle should
be up to 30 degrees.
• Avoid exposing the receiver to direct sunlight,
otherwise false activation of control commands is
possible.
USING THE FAN
• Place the fan base (1) on a at, dry and steady
surface.
• Do not place the fanon soft surfaces, such as carpets
with high pile, sofas or beds.
• Plug the power cord into the mains socket, the on/o
button indicator (9) will light up.
Switching the fan on/o and selecting the airow
speed
• To switch the fan on, press the button (9) « » on
the control panel (3) or the button (19) « » on the
remote control (18), you will hear a sound signal, and
the fan will switch on at low airow speed, the symbol
(14) « » will light up on the display (13).
• Pressing the button (17) « » on the control panel
(3) or the button (20) « » on the remote control (18)
you can select the airow speed, the symbols (14)
«F1, F2, F3» will appear on the display.
• To switch the fan o, press the button (9) « » on
the control panel or the button (3) « » on the remote
control (18). The fan will be switched o.
Fan operation time timer
• To set the operating time of the fan, press the button
(16) « » on the control panel (3) or the button (22)
«» on the remote control (18), you will hear a sound
signal and the digital symbols (14) on the display
(13) will show the timer operation time «0:0» and the
symbol (10) « » will appear.
• Press again the buttons (16 or 22) to set the timer
operation time. Timer operation time can be set from 1
hour to 15 hours with 1 hour setting step.
• To switch o the timer, repeatedly press button (16 or
22) until the « » icon (10) on the display (13) goes
out.
Switching the fan body oscillation on/o
• To switch the fan body oscillation on, press the button
(15) « » on the control panel (3) or the button (23)
«» on the remote control (18), the display (3) will
show the symbol (18) « », to switch the oscillation
o, press again the button (15) « » on the control
panel (3) or button (23) « » on the remote control
9
EN
(18).
Note: you can change the direction of the airow in
the vertical plane, the angle of change in the airow
direction is about 70 ° and is set manually.
Selecting the airow type
Note: - it is possible to change the airow type only by
pressing the « » button (21) on the remote control
(18).
• Press the button (21) « » on the remote control
(18) to select the type of airow, the display (13) will
show the symbol (12) «Natural wind» « », press
the button (21) « » again to switch the night mode
on, the display (13) will show the symbol (11) « »,
to switch the night mode off, press the button (21)
«» again, the symbol (11) « » on the display
(13) will go out.
• To switch the fan o, press the button (9) « » on
the control panel (3) or the button (19) « » on the
remote control (18). The fan will be switched o.
Note: - in case no button is pressed on the control
panel (3) or on the remote control (18), the display
illumination (13) will go out after 60 seconds.
• Carry the fan by the handle (6).
CLEANING AND MAINTENANCE
• Before cleaning the fan, switch it o and unplug it.
• Wipe the fan body with a slightly damp cloth and then
wipe it dry.
• Do not use liquid detergents, abrasive cleaners and
any solvents to clean the fan.
• To avoid the risk of electric shock provide that no
water or other liquid gets into the fan body.
• To clean the air inlet grid (6), use a vacuum cleaner
with a corresponding attachment.
• You can use a vacuum cleaner with a corresponding
attachment to clean the air inlet grid and the front
grid (4).
STORAGE
• After cleaning put the fan away for storage in a dry
cool place away from children and disabled persons.
• Before using the fan next time, it is recommended to
check the unit operability and integrity of the power
cord isolation and the power cord plug.
DELIVERY SET
Fan — 1 pc.
Instruction manual — 1 pc.
Remote control — 1 pc.
3 V - «CR2025» — Batterie (mitgeliefert)
10
EN
TECHNICAL SPECIFICATIONS
• Power supply: 220-240 V, ~ 50/60 Hz
• Rated input power: 50 W
• «CR2025» battery (included in the delivery package)
RECYCLING
To prevent possible damage to the
environment or harm to the health of people
by uncontrolled waste disposal, after service
life expiration of the unit or the batteries (if
included), do not discard them with usual
household waste, deliver the unit and the
batteries to specialized centers for further recycling.
The waste generated during the disposal of the unit
is subject to mandatory collection and consequent
disposal in the prescribed manner.
For further information about recycling of this product
apply to a local municipal administration, a disposal
service or to the shop where you purchased this
product.
The manufacturer reserves the right to change the
appearance, design and specications not aecting
general operation principles of the unit, without prior
notice.
The unit operating life is 3 years
The manufacturing date is specied in the serial
number.
In case of any malfunctions promptly apply to the
authorized service center.
Tabla de contenidos
Idiomas:
Otros manuales de Admirador de BRAYER
BRAYER
BRAYER BR4958BK Manual de usuario
BRAYER
BRAYER BR4961WH Manual de usuario
BRAYER
BRAYER BR4974 Manual de usuario
BRAYER
BRAYER BR4955 Manual de usuario
BRAYER
BRAYER BR4975 Manual de usuario
BRAYER
BRAYER BR4956 Manual de usuario
BRAYER
BRAYER BR4961BK Manual de usuario
BRAYER
BRAYER BR4960 Manual de usuario
BRAYER
BRAYER BR4952 Manual de usuario
BRAYER
BRAYER BR4954 Manual de usuario
