7
Set the Time, Date & Units
Press the “SET” button, located on the back of the display, to enter SET MODE.
Once in set mode, the preference you are currently setting will blink on the display.
To save your adjustments, press the “SET” button again to adjust the next
preference. The preference set order is as follows:
* If you live in an area that observes Daylight Saving Time, DST should be set
to ON,even if it is not currently Daylight Saving Time.
* You will automatically exit SETUP MODE if no buttons are pressed for 5 seconds.
Enter setup mode at any time by pressing the “SET” button.
Display Backlight Settings
This weather station’s color display features three different lighting settings:
High (100%) brightness, Medium (60%) brightness and Low (30%) brightness.
When display is powered with the power adapter, backlight remains on at
100% brightness. Press the button once to dim to 60% brightness; press
again to dim to 30%, press a third time to enter AUTO-DIM mode. “ ” will
appear next to the clock.
Automatically adjusts display brightness based on time of day.
6:00 a.m. - 9:00 p.m. = 100% brightness
9:01 p.m. - 5:59 a.m.= 30% brightness
To adjust the currently selected (flashing) item, press “ ” or “ ” buttons
(Press and HOLD to fast adjust).
1. Clock 12/24
2. DST ON/OFF
3. Clock Hour
4. Clock Minute
5. Calendar Month
6. Calendar Date
7. Calendar Year
8. Temperature Units (ºF or ºC)
9. Barometric Pressure Units: (hPa or inHg)
10. Timer & Zero
(EST, CST, MST, PST, AKT, HAT, NST, AST)
AUTO DIM MODE
From 11 March to 4 November From 5 November to 10 March
7:30 a.m. - 7:00 p.m. = 100% brightness
7:01 p.m. - 7:29 a.m.= 30% brightness
BRAPILOT atomic clocks use a radio-controlled clock (RCC) signal to
synchronize to the correct time broadcast by the National Institute of Standards
and Technology (NIST) Radio Station WWVB, located near Fort Collins,Colorado.
WWVB broadcasts the current time and date with split-second accuracy.
Atomic Clock
Pls note: 1. RCC will synchronize to the correct time automatically at 3:00 every night,
if fails to synchronize at 3:00, the RCC will do next hour, maximum 3 times every day to
synchronize. RCC will NOT synchronize all the time, so it is important to manually set the
time and date after powering.
2. RCC signal will be displayed on the screen when synchronize successfully.
3. RCC signal will NOT be displayed on the screen if fails to synchronize.
