DIGIMIC
SMic133D
Quick Guide
3
Auf der Alten Burg 6
53639 Königswinter
sales@braehler-systems.com
www.braehler-systems.com
05.1950 230202 V1.0 BRÄ LER Systems is constantly improving its products and therefore reserves the right to make technical changes without notice
Headphones
You can listen to the audio signal in two ways - via the integrated speaker or via headphones. Connect the
headphones and adjust the volume. To do this, tap the volume control on your screen and use your finger to
"drag" the volume louder and softer.
The SMic123W starts with a default volume. The set volume is displayed on the screen.
The volume of the speaker is controlled centrally.
Voice channels can only be received via headphones. If no headphones are connected, you will hear
the original channel (floor) via loudspeakers.
Microphone
Plug in the microphone. Note the notch on the microphone plug and the Minicon jack. Screw the microphone
tight to lock it in place.
Press the microphone button on the touchscreen display to switch the microphone on. Press the microphone
button again to turn the microphone off.
The SMic units operate in different mode settings. These are determined by the operator of the conference.
After pressing the microphone button, you have the following options.
Key and ring light up red: The microphone is open. You can speak to the remaining participants.
Button and ring remain off: The maximum number of speakers has been reached - you must try to turn on
your microphone again at a later time.
Key flashes red: The maximum number of speakers has been reached. You must wait (request to speak). Your
microphone will be automatically activated as soon as it is your turn to speak.
Volume control
Minicon socket
