Page
GMX –INSTRUCTIONS FOR USE
** New battery may be partially charged, fully charge before use
** Ensure spray switch connected inside control box (see maint-page 2)
1) Ensure power turned off on both pump isolator switch (on control panel) and
spray switch (on handle bar).
2) Unplug and remove 2 x connectors (top of paint tank). Remove paint tank (using
front and rear recesses) by lifting out back first, then the front.
3) Make up paint mix (using paint concentrate and water) –using only BOWCOM
paints. Pour into tank through integral basket filter.
4) Replace paint tank lid and place onto GMX machine, re-connecting both plug-in
connectors (ensure matching sides-colour coded).
5) When closing bonnet with connectors attached to tank, carefully push surplus
hose down back of tank to avoid restricting bonnet closure.
6) Fill cleaning bottle with tap water (located on top of control panel).
7) Ensure direction tap is set to Paint and recycle tap is set to spray.
8) The machine is now ready to mark a line.
9) Set the spray limit plates to the required line width. Ensure that the spray gun is
set high enough for the paint spray to hit the limit plates.
NB. To locate the spray head inside the frame –use the right-hand stub
(from behind machine)
To locate the spray-head outside the frame –use the left-hand stub
(from behind machine)
NB. For offset (left or right side) spray marking –use the extended spray bar
(optional extra).
10) Turn on the pump isolator switch (located on control panel) –observe the volt
meter reading (12 volts). If too low, place battery on charge.*
11) To activate pump, use the button located on the handle bar. This can be used in
the locked-on position or Hold-position (using a light finger touch).
NB. The push button spray switch is positioned on the right side of the handle,
this can be moved to the left side if required.
12) To clean the machine: Turn off pump. Turn the paint/water tap to water (located
next to the water bottle inside control box).
