Boston Acoustics VR-MC Manual de usuario
VR-MC
Lynnfield VR™Series
Home Theater
Center Channel Speaker
2
Specifications
Frequency Response (±3dB) 65–20,000Hz
Recommended Amplifier Power 15–150 watts
Nominal Impedance 8 ohms
Sensitivity [1 watt (2.83v) at 1m] 89dB
Bass Unit 51⁄4" (135mm) copolymer
Passive Radiator 51⁄4" (135mm) copolymer
Tweeter 1" (25mm) dome with AMD
Crossover Frequency 3,000Hz
Dimensions (HxWxD) 61⁄4x 191⁄2x 63⁄4" (159 x 495 x 171mm)
Weight 14 lbs (6.5kg)
Finish Charcoal grey grille cloth with
cherry or black ash wood veneer sides
and solid cherry or black ash wood top
Description
The Lynnfield VR-MC center channel speaker delivers the wide-range response, high power-handling, high
efficiency and placement flexibility required by the finest home theater systems. Its wide and even dispersion
ensures that the sound will remain consistent and uniform for listeners throughout the room, assuring that
everyone has the “best seat.”
Placement
Place the center channel speaker
above or below the television
monitor, as close as possible to
the center of the screen. It is not
necessary to angle the speaker to
face the listeners. The speaker
is magnetically shielded with
MagnaGuard®and will not affect
the television’s picture. Use the
four self-adhesive rubber feet
(provided) to protect the TV’s
finish and reduce vibration.
Connection
WARNING: To prevent an electrical shock hazard, always switch off the amplifier or receiver when making
connections to the speaker.
We recommend 18-gauge, or thicker, wire for runs up to 25 feet (8m) and 16-gauge, or thicker, wire for longer
runs. Separate the first few inches of the wire conductors. Strip off 1⁄2inch (12mm) of insulation from the ends
of each speaker wire to expose the two conductors and tightly twist the wire strands.
Boston Boston
Boston
volume
0
1
2
3
4
5
6
7
8
9
10
11
12
crossoverHz crossover polarity
50 150
80 120 set none 0°180 °
Boston
3
Setting Up Your Home Theater System
Volume levels: To obtain the best home theater effect, match the sound levels of each speaker. Home
theater systems include a test signal that simplifies this level matching. Refer to the instructions provided
with your surround sound electronics.
Distance adjustment: Digital surround sound electronics permits the listener to adjust the relative timing of
the center channel sound. This adjustment affects the quality of the front image of the system. Refer to the
instructions provided with your surround sound electronics.
Bass management—speaker selection: Surround sound electronics provides adjustments or menus that
permit the listener to direct bass signals to specific channels for the best effect. Generally, with all surround
systems, the center channel mode should be set to SMALL. This setting will divert low bass to the front left
and right speakers (which typically have greater bass capability than the center speaker) and will result in
the greatest total system bass output. Also, if your system includes separate subwoofers, the SMALL setting
ensures that the subwoofers will receive the most bass under all conditions.
Bass management—crossover frequency selection: Some surround sound electronics provides a choice
of crossover frequencies (the frequency below which bass is diverted to the left, right, or subwoofer speak-
ers). If a choice is provided, 80Hz will give the best overall results.
Systems with Dolby®Pro Logic®only: On older systems with Dolby Pro Logic only, use the NORMAL or
SMALL settings for the center speaker. The PHANTOM setting, which presumes you do not have a center
channel speaker, should not be used.
Maintenance
Care and cleaning: The VR-MC features a solid wood top and real wood veneer back and sides. Therefore,
treat it as you would any fine piece of furniture. Avoid harsh chemicals and ammonia-based cleaners and
only use furniture polish or oil soap when necessary.
IMPORTANT: Typically, one side of the wire is smooth. Connect this side to the –(black)
connection. The other side has a rib or stripe. Connect this to the +(red) connection.
Connect the speaker to the center front terminals of your surround sound receiver
or amplifier.
IMPORTANT: Be sure to connect +to +(red) and –to –(black).
Using the five-way binding posts: The binding posts permit easy connection to banana
plugs, spade lugs and bare wire. The metal surfaces are plated with 24K gold to prevent
corrosion. Insert the wire in the hole and tighten.
surround sound receiver/amplifier
left
front center
front right
front
center channel speaker
Boston, Boston Acoustics, and MagnaGuard are registered
trademarks and Lynnfield VR is a trademark of Boston Acoustics, Inc.
Dolby Pro Logic is a registered trademark of Dolby Laboratories
Licensing Corporation.
Specifications subject to change without notice.
© 2000 Boston Acoustics, Inc.
042-001188-0
Listening Levels and Power-Handling
The power recommendation for the speaker assumes you will operate the amplifier in a way that will
not produce distortion. Even rugged systems like the VR-MC can be damaged by an amplifier if it is
producing distortion.
If you hear a harsh, gritty noise, turn down the volume. Prolonged or repeated operation of your speaker
with a distorted signal from the amplifier can cause damage that is not covered by the warranty.
Limited Warranty
For five years from the date of purchase, Boston Acoustics will repair for the original owner any defect in
materials or workmanship that occurs in normal use of the speaker, without charge for parts and labor.
Your responsibilities are to use the system according to the instructions supplied, to provide safe and secure
transportation to an authorized Boston Acoustics service representative, and to present proof of purchase in
the form of your sales slip when requesting service.
Excluded from this warranty is damage that results from abuse, misuse, accidents, shipping, or repairs or
modifications by anyone other than an authorized Boston Acoustics service representative.
This warranty is void if the serial number has been removed or defaced.
This warranty gives you specific legal rights, and you may also have other rights that vary from state to state.
If Service Seems Necessary
First, contact the dealer from whom you purchased the speakers. If that is not possible, write to:
Boston Acoustics, Inc. 300 Jubilee Drive Peabody, MA 01960 U.S.A.
We will promptly advise you of what action to take. If it is necessary to return your speaker to the factory,
please ship it prepaid. After it has been repaired, we will return it freight prepaid in the U.S.A. and Canada.
300 Jubilee Drive
Peabody, MA 01960 USA
978-538-5000
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Oradores de Boston Acoustics
Boston Acoustics
Boston Acoustics VR-MX Manual de usuario
Boston Acoustics
Boston Acoustics HSi 475T2 Manual de usuario
Boston Acoustics
Boston Acoustics 351 361 381 Manual de usuario
Boston Acoustics
Boston Acoustics SPZ50 Manual de usuario
Boston Acoustics
Boston Acoustics CS 275 Manual de usuario
Boston Acoustics
Boston Acoustics TVee 30 Manual del propietario
Boston Acoustics
Boston Acoustics Neo Type-S Manual de usuario
Boston Acoustics
Boston Acoustics VS Series Manual de usuario
Boston Acoustics
Boston Acoustics VSi 555W2 Manual de usuario
Boston Acoustics
Boston Acoustics 5.1 Home Theater Speakers Manual del propietario
Boston Acoustics
Boston Acoustics BA Classic 8 Manual de usuario
Boston Acoustics
Boston Acoustics S95 Manual de usuario
Boston Acoustics
Boston Acoustics P4FL Instrucciones de uso
Boston Acoustics
Boston Acoustics CRC Manual de usuario
Boston Acoustics
Boston Acoustics TVee One Manual de usuario
Boston Acoustics
Boston Acoustics HSi H460T2 Guía de referencia
Boston Acoustics
Boston Acoustics BT2 Guía del usuario
Boston Acoustics
Boston Acoustics DSi250 Manual de usuario
Boston Acoustics
Boston Acoustics CS2310 Manual de usuario
Boston Acoustics
Boston Acoustics Designer Series DX Pro Manual de usuario
