Bosch 715ES Manual de usuario

Models: 715ES, C800ES, C920ES, C920ESC, 2400ES, 2700ES

Cleaning and replacing ignition group

Service Bulletin G3-23

Introduction

The ignition group consists of two ignition electrodes and one

ame sensing rod. These components may need to be cleaned

or the entire group replaced if the heater has frequent EC or EA

error codes or fails to produce a spark.

Tools needed:

Phillips head screwdriver

 8mm wrench or small adjustable wrench

Fine steel wool for cleaning

Preparation

1. Unplug water heater and turn off gas to heater using installer

supplied manual shut off valve.

2. Loosen two Phillips head screws located at bottom rear of cover.

(Fig. 1, step 1, pos. 1).

3. Lift front cover upward and remove. (Fig. 1, step 1, pos. 2 & 3)

4. Remove combustion cover by unclipping two upper and two

lower clips securing cover. (Fig. 1, step 2)

Step 1 Step 2

tep

Figure 1

Removing the ignition group

1. Locate ignition group. (Fig. 2, pos. 1).

2. Disconnect two large yellow ignition wires from ignition group.

(Fig. 2, pos. 2)

3. Disconnect small black ame sensor wire from ignition group.

(Fig. 2, pos. 3).

Figure 2

Data subject to change without notice | Printed in the USA | BTC710002310 A | 01.2009 Bosch Thermotechnology Corp.

Service bulletin

18 | G3-23 | 715ES, C800ES, C920ES, C920ESC, 2400ES, 2700ES

Bosch Thermotechnology Corp.

50 Wentworth Avenue

Londonderry, NH 03053

Tel: 1-866-642-3198

Fax: 1-603-584-1681

www.boschhotwater.com

4. Remove two 8mm nuts from ignition group. (Fig. 3, pos. 1).

5. Remove ignition group and gasket from the water heater. Leave

the observation window in place.

Figure 3

Cleaning ignition group

1. If the ignition group gasket is discolored or torn, replace with a

new gasket. (Fig. 4)

2. Using steel wool, gently polish all metal surfaces of the ame

sensor and the ignition electrodes. (Fig. 4)

Figure 4

Gasket

Flame

sensor

Ignition

electrodes

Replacing ignition group

1. Gently place ignition group gasket over left bolt stud for 8mm

nut. The stud will hold the gasket in place.

(Fig. 3, pos. 1)

2. Carefully feed tips of ignition group into heat exchanger ensuring

that the ame sensor rod is on the far left.

3. Ensure a proper seal between the heat exchanger and ignition

group.

4. Replace and tighten two 8mm retaining nuts. (Fig. 3, pos. 1).

5. Reconnect two large ignition wires to the right and center igniter

terminals. (Fig. 2, pos. 2).

6. Reconnect small black ame sensor wire to the left terminal.

(Fig. 2, pos. 3).

7. Ensure that all three wire connections t securely on the

terminals.

8. Replace combustion cover and front cover. (Fig. 1).

9. Plug in water heater‘s power cord and press On/Off button to

"ON". Reset any error that is displayed.

10. Open manual gas shutoff valve.

11. Return water heater to service.

!WARNING

FAILURE TO PROPERLY SEAL THE

IGNITION GROUP WITH GASKET MAY

CREATE A HAZARDOUS CONDITION

CAUSING SEVERE PERSONAL INJURY

OR DEATH.

Otros manuales para 715ES

Este manual sirve para los siguientes modelos

Otros manuales de Calentador de agua de Bosch

Bosch

Bosch C 1210 ESC Manual de referencia

Bosch

Bosch WR400 K T2 Series Manual del propietario

Bosch

Bosch 125B LP Manual de usuario

Bosch

Bosch GWH 715 ES Manual de usuario

Bosch

Bosch Greentherm T9900 SE 160 Manual de usuario

Bosch

Bosch TRONIC 5000C Pro Manual de referencia

Bosch

Bosch TR2000 Series Manual de usuario

Bosch

Bosch BC2600RA Manual de usuario

Bosch

Bosch AquaStar 125FX LP Manual de usuario

Bosch

Bosch HydroPower 10H Manual de usuario

Bosch

Bosch TR1500TOR 5 T Manual de usuario

Bosch

Bosch TR8500 15/18 DESOAB Manual de usuario

Bosch

Bosch GWH 1600 PS Manual de usuario

Bosch

Bosch AquaStar GWH 2700 ES NG Manual de usuario

Bosch

Bosch AQUA STAR 2400E LP Manual de usuario

Bosch

Bosch Tronic 3000T ES 2.5 Documento técnico

Bosch

Bosch Tronic 1000T ES 035-4 M 0 WIV-B Manual de funcionamiento

Bosch

Bosch TR1000 4 T Manual de usuario

Bosch

Bosch AquaStar 125FX LP Manual de usuario

Bosch

Bosch GWH-425-HN-N Manual de usuario

Bosch

Bosch 1000P Manual de usuario

Bosch

Bosch GWH 715 ES Instrucciones de uso

Bosch

Bosch C950ES Manual de referencia

Bosch

Bosch DHW Tank QWST120 O Manual de usuario

Manuales populares de Calentador de agua de otras marcas

Kenmore

Kenmore 153.582400 Manual de usuario

Applimo

Applimo Edel AIR Manual de usuario

STIEBEL ELTRON

STIEBEL ELTRON Eltronom SHU 5 S Manual de usuario

clage

clage E-Mini Series Manual de usuario

Toyotomi

Toyotomi Oil Miser OM-180 Manual de usuario

Bradford White

Bradford White EF Series Manual de usuario

Eccotemp

Eccotemp 40-H Manual de usuario

Dimplex

Dimplex ECSd125-580 Guía

Dux

Dux 32FCR6N Manual de usuario

Toyotomi

Toyotomi Oil Miser OM-148 (Type D) Guía de solución de problemas

Noritz

Noritz N-132M Manual de instrucciones

TESY

TESY GCV7/4S 10047 Hoja de especificaciones

A.O. Smith

A.O. Smith Gphe 50 Manual de usuario

Koryo

Koryo KWHZF15Y Manual de usuario

Pentair

Pentair PSC-14-4-02 Manual de usuario

GE 40M06AAG Instrucciones de montaje

Thermor

Thermor AEROMAX SPLIT 2 Manual de usuario

American Hometec

American Hometec AHQ-B03X Manual de usuario