Bosch Photobeam 5000 Instrucciones de funcionamiento

Photobeam 5000

ISC-FPB1-W60QF, ISC-FPB1-W120QF, ISC-FPB1-W200QF

en Installation and Operation Guide

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

3 Photobeam 5000 Table of Contents | en

Table of contents

1 Introduction 4

1.1 About documentation 4

1.2 Bosch Security Systems, Inc 4

2 System overview 5

2.1 Features 5

2.2 Photobeam overview 6

2.3 Console overview 7

2.4 Transmitter/receiver dimensions 8

3 Installation 9

3.1 Beam spread 9

3.2 Pole mount installation 10

3.3 Wall mount installation 12

4 Wiring 13

4.1 Terminal strip overview 13

4.2 Wiring distance 14

4.3 Wiring routes 14

5 Special features 16

5.1 Selectable beams 16

5.2 Selectable AND/OR Gate 16

5.3 Level LED 16

5.4 EDC (Environmental Discrimination Circuit) 16

5.5 Beam interruption time 17

5.6 Beam power control 17

5.7 High Density 18

6 Setup 21

7 Installing multiple sets (stacking) 25

7.1 Group selection 25

7.2 Channel selection 27

7.3 Synchro wiring 29

7.4 Stacking examples 30

7.4.1 Single stacking 30

7.4.2 Double stack 30

7.4.3 Triple stack 31

7.4.4 Quadruple stack 32

8 Optical alignment 35

8.1 Level LED – alignment of the Upper Beam 35

8.2 Level LED - alignment of the Lower Beam 35

8.3 Volt meter alignment 36

9 Operational check 38

10 Troubleshooting 39

10.1 Additional information 39

11 Certifications 40

12 Specifications 41

Bosch Security Systems, Inc. Installation and Operation Guide 2016.02 | 03 | F.01U.303.478

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

4 en | Introduction Photobeam 5000

1 Introduction

This document contains information that a trained installer needs to install the Photobeam

5000 quad-beam photoelectric detector contained inside the packaging.

1.1 About documentation

This document is the intellectual property of Bosch Security Systems, Inc. and is protected by

Trademarks

All hardware and software product names used in this document are likely to be registered

trademarks and must be treated accordingly.

1.2 Bosch Security Systems, Inc

Use the serial number located on the product label and refer to the Bosch Security Systems,

Inc. website at http://www.boschsecurity.com/datecodes/.

Manufacturing date information is contained in digit no 1 – 3: DDD.

2016.02 | 03 | F.01U.303.478 Installation and Operation Guide Bosch Security Systems, Inc.

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

5 Photobeam 5000 System overview | en

2 System overview

The ISC-FPB1-W60QF, ISC-FPB1-W120QF, and ISC-FPB1-W200QF are quad-beam

photoelectric detectors designed for indoor and outdoor applications. Consisting of a

separate transmitter and receiver, an alarm is activated when a person passes through the

beams. Combination of features and adjustable parameters allow for better catch

performance, lower false alarm rates, and reduced effects of environmental disturbances.

2.1 Features

For stable operation, the detectors are equipped with the following feautres:

100% Sensitivity Allowance

Maintains stable operation even if 99% of beam energy is cut, for example by rain, fog, frost,

and so on.

Quad Beam Detection

Fewer false alarms caused by birds and other small animals because all four beams must be

blocked simultaneously to cause an alarm.

Beam Power Control

Select the appropriate beam intensity relative to the detection range to minimize reflection on

nearby walls and cross-talk with other detectors.

Beam Interruption Time Control

Use to change the beam interruption time to best fit the application.

Bosch Security Systems, Inc. Installation and Operation Guide 2016.02 | 03 | F.01U.303.478

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

2.2

6 en | System overview Photobeam 5000

Photobeam overview

Figure 2.1: Photobeam components overview

Callout ーDescription Callout ーDescription

1 ー Mounting holes 8 ー Optical alignment

2 ー Mounting plate 9 ー Vertical adjustment

3 ー Device securing screws 10 ー Horizontal adjustment

4 ー Wire entry 11 ー Console

5 ー Wiring terminals 12 ー Cover

6 ー Detector 13 ー Cover securing screws

7 ー Optical module

2016.02 | 03 | F.01U.303.478 Installation and Operation Guide Bosch Security Systems, Inc.

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

2.3

7 Photobeam 5000 System overview | en

Console overview

Figure 2.2: Console components overview

Callout ーDescription Callout ーDescription

1 ー Transmitter console 6 ー Status indicators

2 ー Power indicator 7 ーSensitivity control

3 ー Function switches 8 ーALIGNMENT CHECK TERMINALS

4 ー BEAM POWER CONTROL 9 ーHIGH DENSITY terminals

5 ーReceiver console

Bosch Security Systems, Inc. Installation and Operation Guide 2016.02 | 03 | F.01U.303.478

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

2.4

8 en | System overview Photobeam 5000

Transmitter/receiver dimensions

103 mm (4.0 in)

19.3 mm

(0.75 in)

398 mm (15.66 in)

244 mm (9.60 in)

96 mm (3.77 in)

77.1 mm

(3.03 in)

337.7 mm (13.29 in)

56 mm

(2.20 in)

220 mm (8.66 in)

39 mm

(1.5 in)

39.7 mm

(1.56 in)

Figure 2.3: Transmitter/receiver dimensions

Callout ﹘Description Callout ﹘Description

1 ー Knockout wire entrance 3 ー Center of the Upper Beam

2 ー Center of the Lower Beam 4 ー Wire entrance

2016.02 | 03 | F.01U.303.478 Installation and Operation Guide Bosch Security Systems, Inc.

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

9 Photobeam 5000 Installation | en

3 Installation

Prior to installing the devices, please review the installation considerations below:

– Install in an area that is clear of objects

– Install the transmitter/receiver within the maximum protection range of the model

– Do not install:

– Receivers into intense sources of light (for example, rising and setting sun)

– On movable surfaces subject to vibrations

– Detectors where immersion to water, corrosive liquids, or exposure to high levels of

dust can occur

– Detectors in close proximity to strong electromagnetic noises

– Do not use detectors with other photobeam detectors or receivers

– Do not disassemble or modify this detector

– Do not install while the power is on

– Avoid extreme temperature and humidity ranges as defined in the products specifications

– Avoid installing detectors near magnets and/or magnetized materials

– Avoid beam interference between other units when multiple units are installed

– Use the selectable beam’s feature when stacking detectors

3.1 Beam spread

The beam spread angle is ±0.7 °from the transmitter to the receiver. Refer to the diagram and

table below to determine the installation conditions.

Figure 3.1: Beam distance and spread

Callout ﹘Description Callout ﹘Description

1 ー Transmitter 4 ー Receiver

2 ー Horizontal spread (B) 5 ー Distance (A)

3 ー Vertical spread (C)

Bosch Security Systems, Inc. Installation and Operation Guide 2016.02 | 03 | F.01U.303.478

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

3.2

10 en | Installation Photobeam 5000

Distance, horizontal and vertical spread values: (A) / (B) / (C)

Metric Imperial unit

20 m / 0.5 m / 0.8 m 65 ft / 1.6 ft / 2.6 ft

40 m / 1.0 m /1.3 m 13.1 ft / 3.2 ft / 4.2 ft

60 m / 1.5m / 1.8 m 196 ft / 4.9 ft / 5.9 ft

80 m / 2.0 m / 2.2 m 262 ft / 6.5 ft / 7.2 ft

100 m / 2.5 m / 2.7 m 328 ft / 8.2 ft / 8.8 ft

120 m / 3.0 m / 3.2 m 393 ft / 9.8 ft / 10.4 ft

140 m / 3.5 m / 3.7 m 459 ft / 11.4 ft / 12.1 ft

160 m / 4.0 m / 4.2 m 524 ft / 13.1 ft / 13.7 ft

180 m / 4.5 m / 4.7 m 590 ft / 14.7 ft / 15.4 ft

200 m / 5.0 m / 5.2 m 656 ft / 16.4 ft / 17.0 ft

Pole mount installation

Figure 3.2: Pole mounting view

Callout ﹘Description Callout ﹘Description

1 ー Diameter 38.0 – 42.7 mm (1.50 – 1.68 2 ー Back-to-back pole mounting

in)

Attaching the mounting bracket:

1. Choose an appropriate mounting location for the devices. Install the mounting poles with

a clear line-of-sight between the transmitter and receiver.

2. Loosen the transmitter’s cover mounting screw and remove the cover.

3. Loosen the two base mounting screws and remove the mounting plate by sliding it down.

4. Attach the mounting hardware to the mounting plate using the clamping screws. Refer to

the figure below.

2016.02 | 03 | F.01U.303.478 Installation and Operation Guide Bosch Security Systems, Inc.

Available from A1 Security Cameras

www.a1securitycameras.com email: [email protected]

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Sensor de seguridad de Bosch

Bosch

Bosch RF835E Manual de usuario

Bosch

Bosch TriTech+ ISC-PDL1-WA18G Manual de usuario

Bosch

Bosch CRS-WM-TA869 Manual de usuario

Bosch

Bosch FAA-500 Manual de usuario

Bosch

Bosch RF940E Series Manual de usuario

Bosch

Bosch TriTech Manual de usuario

Bosch

Bosch ISC-BDL2-WP12 Manual de usuario

Bosch

Bosch ISC-PDL1-WC30G Manual de usuario

Bosch

Bosch Multi-Detector DMD4 Instrucciones de montaje

Bosch

Bosch FMC-210-SM-G-R Manual de usuario

Bosch

Bosch ISC-BDL2-WP12 Manual de usuario

Bosch

Bosch Blue Line D1-P Manual de usuario

Bosch

Bosch DS778 Manual de usuario

Bosch

Bosch D-tect 150 Manual de usuario

Bosch

Bosch LTC 2210 Series Manual de usuario

Bosch

Bosch FAA-420-RI-ROW Manual de usuario

Bosch

Bosch AP1-P Manual de usuario

Bosch

Bosch DS820i Series Manual de usuario

Bosch

Bosch DS432i-CHI Manual de usuario

Bosch

Bosch ISM-BLD1 Manual de usuario

Bosch

Bosch D603 Manual de usuario

Bosch

Bosch GMS 120 Professional Manual de usuario

Bosch

Bosch DS940 Manual de usuario

Bosch

Bosch AVIOTEC IPSTARLIGHT 8000 Manual técnico

Manuales populares de Sensor de seguridad de otras marcas

THORLABS

THORLABS PDA10JT Manual de usuario

Waeco

Waeco UV-DETECT Manual de usuario

Intermatic

Intermatic IOS-DSIMF Manual de usuario

urmet domus

urmet domus 1083 Manual de usuario

Siemens

Siemens AZL66 Series Manual de usuario

BTI

BTI Profiline Multi Finder Manual de usuario

Challenger

Challenger SL01 Manual de usuario

DMP Electronics

DMP Electronics 1122INT Manual de usuario

Rielta

Rielta Ladoga MK-RK Manual de usuario

Mirion Technologies

Mirion Technologies ACCURAD PRD Manual de usuario

DBI SALA

DBI SALA EZ Stop Manual del operador

Lamptime

Lamptime ST05C Manual de usuario

Ubiquiti

Ubiquiti MFI-MSC Manual de usuario

Subsite

Subsite 910R Instrucciones de instalación

Satel

Satel OPAL Pro Manual de usuario

Aleph

Aleph XC-1XTEU Manual de usuario

Pima

Pima LARIS QUAD Manual de usuario

Solinst

Solinst 301 Manual de usuario