DGF109A/DFG104A 802.11abgn/AC 2T2R with BT4.2 miniPCle Card User Manual
______________________________________________________________________________________________
Bointec DGF109A/DGF104A User Manual Page 7 of 17
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
15.21
You are cautioned that changes or modifications not expressly approved by the part responsible for
compliance could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator
and your body.
Contents
1Packing List.............................................................................................................................. 9
2Customer Service ....................................................................................................................9
3Safety and Warranty .............................................................................................................. 10
4Introduction............................................................................................................................ 11
4.1Product overview ................................................................................................................ 11
4.2 Reference Documents ........................................................................................................12
5Mechanical Specification ......................................................................................................12
5.1 Main Module ........................................................................................................................ 12
6Software Installation ..............................................................................................................12
6.1 Driver installation under Windows systems ..................................................................... 13
