SKYLIGHT DEMARCATION KIT
ASSEMBLY INSTRUCTIONS
4064 Peavey Rd. Chaska, MN 55318
THE INFORMATION CONTAINED IN THIS DOCUMENT IS THE SOLE PROPERTY OF BLUEWATER MFG., INC. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN
PERMISSION OF BLUEWATER MFG., INC. IS PROHIBITED.
1. Place the carriage bolts through the angle marker mount.
2. Place the retaining clip onto the carriage bolts.
3. Screw nylock nuts onto carriage bolts.
4. Place the fiberglass stake between the angle marker mount and the retaining clip.
a. Ensure that the bottom of the stake is resting on the angle marker mount.
5. Tighten the nylock nuts onto the carriage bolts until snug.
a. Ensure that the stake does not pull free from the mount housing.
6. If fastening the Skylight Demarcation Kit to a Bluewater Mfg. Skylight Defender continue,
otherwise proceed to page 3 of 3.
7. Remove the nylock nut and the washer from the threaded rod located on the Skylight Defender.
8. Insert the assembled Skylight Demarcation Kit onto the threaded rod.
9. Place the washer onto the threaded rod.
10. Place the nylock nut onto the threaded rod and re-tighten nut to the Skylight Defender frame.
