01
Thank you for purchasing a BlueSpot product, you can find further information on our range at
www.BlueSpot.uk.com.Please ensure that you are using the product correctly and that all guidance
and cautions are followed in accordance with the instructions. Please retain these instructions for
future reference.
GeneraL Information
Please make sure that you read these instructions carefully in order to avoid injury when using the COB
light. Follow all health and safety rules and regulations. If in doubt and available please contact a more
knowledgeable source.
DO NOT use if damaged.
• BE AWARE this product is not waterproof.
• BE AWARE it is not possible to change the light source.
• ALWAYS check the light for any damage before use. Check for damage to the cable, lens or light
casing. If light is damaged do not use as this may cause damage to property or cause injury.
• ALWAYS inspect the USB cable for wear or damage before using the light. Ensure all the connec-
tions are secure.
• ALWAYS dress appropriately and wear the correct PPE equipment if required.
• ALWAYS ensure the light is disconnected from the power source when not in use.
• ALWAYS ensure the light has been turned off and disconnected from the power supply before
performing any maintenance or storing.
• Allow the light to cool down fully before cleaning or performing any maintenance.
• Before storing the light ensure that it has cooled down completely and is dry. Store the light in a
cool dry area that is out of reach of children.
• Position the light where it is not likely to be knocked or cause a hazard while working.
• Maintain the lamp in good and clean condition for best and safest performance.
• Keep the work area clean and uncluttered.
• Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
• Keep children and unauthorised persons away from the work area.
• DO NOT use the light if the glass shield on the front has been broken or has been removed.
Safe use
