PLEASE READ CAREFULLY THROUGH THIS MANUAL BEFORE USING
THE PRODUCT, OBSERVING ALL SAFETY INFORMATION, WARNINGS.
1. WARNING
• This product is intended for installation
by a qualified service person.
• Disconnect power at the service breaker
before installing or servicing.
•Failure to properly ground unit could
result in severe electrical shock.
• All units must be supplied with a 3-wire
connection. The ground wire must be
connected to the dryer’s backplate.
2. NOTE
Do not install dryer over washbasin.
If the power supply cord is damaged, it
must be replaced by the manufacturer
or its service agent or a similar qualified
person in order to avoid a hazard. Means
for disconnection must be incorporated
in the fixed wiring in accordance with the
current wiring regulations.
3. SPECIFICATION
Voltage:
220V-240V 50/60Hz, 6A, 1350W (Hot) / 2.4A, 550W (Cold)
110V-120V, 60Hz, 12A, 1350W (Hot) / 4.8A, 550W (Cold)
Air Temperature: 45°C (D=10cm, Room Temperature=25°C)
Air Velocity: 60M/S
Air Flow: 140M³/H
Drying Time: 10 - 12 Seconds
Sensor Range: 5-15CM
Protection Level: IPX1
Electric Isolation: CLASS 1
Brush Motor: 25000RPM
Noise(at 1M): 74dB
Cabinet Material: Stainless Steel 304
240MM
176MM
268MM
Heating
Heating
Motor
Motor
Power
Relay Transformer
Power
Motor
Blue
White
White
Brown
Heat Element
HOT/COLD Switch
<Customize> Blue LED Light
<Customize>
Earthing
L
N
E
Yellow
Blue
Brown
Terminal
Block
220 - 230V 50/60Hz
OR 110 - 120V 60Hz
Hand Dryer Main Circuit Board
Program Board
Sensor Board
Turn clockwise to
increase sensor range
4. INSTALLATION
5. OPERATION
• No-touch operation.
• There is a blue LED light to guide user
to the air flow.
• Turn off heat element switch inside
hand dryer to get cold air only.
• Shake excess water from hands.
• Place hands under the outlet to start
operation.
• Rub hands lightly and rapidly.
• Stops automatically after hands are
removed.
1. Installation must be carried out in
accordance with the current edition
of the local wiring regulations code
having jurisdiction. Installation should
be performed only by a qualified
electrician.
2. Place template against wall at
desired height (see mounting height
recommendations) and mark locations
of 4 mounting holes Dia. 8mm (5/16”).
3. Remove and retain 2 side security hex
cover screws and cover. Then mount
the hand dryer base on the wall.
4. Before replacing the cover, there is
an option to run the dryer HEATER
ON (1350 Watts) or HEATER OFF (550
Watts). The switch is clearly marked.
5. Connect the hand dryer plug to the
power supply.
A. Connect the live wire (Coloured
Brown or Red) to the terminal block
marked “L”.
B. Connect the neutral wire (Coloured
Black or Blue) to the terminal block
marked “N”.
C. Connect the ground wire (Coloured
Green or Yellow) to the terminal block
marked “E”.
