4
If BlueChimney is delivered with a remote control, the package will not include a cabled speed
controller.
The transmission signal is encrypted and encoded to prevent other electronic devices from being
affected by the transmitter. The draught in the chimney is regulated either automatically with the built-
in program or manually, if needed. The device will switch off automatically approximately 4 hours after
the last push of a button.
The transmitter and receiver are paired at the factory.
The remote control works both with a fully automated program and with manual
control.
Fully automated transmitter operation:
On start-up/relighting, activate the Start/Boost Obutton with one push before
lighting the fire in the fireplace.
First 20 minutes:
BlueChimney starts by boosting the draught for 20 minutes, in order to prevent
smoke from going into the room during ignition/initial lighting. The speed is
subsequently automatically reduced by one-half.
Next 100 minutes (1 hour and 40 minutes):
BlueChimney runs at half speed, in order to ensure the most economical
combustion and as little pollution as possible from the wood-burning stove.
After an additional 2 hours:
BlueChimney switches off automatically.
Relighting the fire/adding wood:
Push the “Start/Boost” Obutton again before relighting the fire/adding wood to avoid smoke. This way
the automatic system will start a new burning sequence of a total of 4 hours.
Manual operation: Automatic operation can be cancelled at all times, and exhaust can be regulated
by pushing “more draught” , “less draught” or the “Off” button . The BlueChimney switches off
automatically 4 hours after you last pushed a button.
Extended program functions
BlueChimney can run the entire time –15 seconds after the most recent keystroke –if you push the
button and press the “more draught” 2 to 8 seconds later . Then, BlueChimney will starts
“off”
at the highest speed. Use the same buttons to subsequently adjust it to your desired draught. Press
the “Off” button to switch off BlueChimney, which will then go back to normal program the next time
BlueChimney is started.
Pairing with the transmitter or several transmitters (up to 7 transmitters) to govern the same
BlueChimney can be done in the following way: Press the pairing button. The green LED will now flash
quickly (approx. 3 times a second). There are 15 seconds to activate the pairing with a manual
transmitter, whereupon the pairing function will be deactivated, and the LED lamp will flash slowly
again (once a second).
Press the start button of the first manual transmitter once, and it will be paired. The second manual
transmitter can be paired within 15 seconds after the pairing of the first manual transmitter. The third
manual transmitter can be paired within 15 seconds after the pairing of the second manual transmitter.
The sequence is similar with any number of subsequent transmitters. When the green LED stops
flashing 3 times a second and reverts to flashing once a second, the pairing function is complete and
the transmitters can be put into service.
Replacing battery in the remote control:
Use a pointed object to press in the small hole on the back side of the remote control to loosen the
control panel. Pull the black plastic holder out and then insert 2 new batteries –CR 2016 –and press
the control panel back in place.
Note: The transmitter’s range is up to 70 metres. Walls, metal screens, radio signals, etc. can reduce
or disrupt the transmitter’s range.
