Blaupunkt IVMR-7002 Hoja de especificaciones
In Car Video
http://www.blaupunkt.com
IVMR-7002 7 607 004 511
Operating and installation instructions
15
DANSK
ENGLISH DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKAESPAÑOL
PORTUGUÊS
DEVICE OVERVIEW
6
<
9; 7
8:
>
A
1 2 3 4 1
5
?
=@
16
DEVICE OVERVIEW
Ceiling-mounted monitor
1Lights on the main unit
2Light switch ON
3Monitor latch
4Vehicle interior lighting switch
5Loudspeaker
6Infrared receiver for IR remote
control IVRC-06
Infrared transmitter for IR
headphones IVHS-01 (accessory)
7Control button
Increase the monitor volume /
navigate in the OSD menu
8Control button
Decrease the monitor volume /
navigate in the OSD menu
9On/off button for the monitor
:Control button MENU
See Instructions / OSD menu.
;Control button CH
Channel selection if the monitor is
connected to a signal controller
IVSC-3302 or IVSC-5502.
<LCD screen
=Signal cable (13 pin)
>System cable (13 pin)
?Adapter cable RCA/jack (13 pin)
@Cable for the interior lighting
(3 pin)
Red = Electrical power supply
(+12V)
White = To the door switch
(Door open = Earth)
Black = Earth
A
AUX
sockets
RedRCA = Audio IN (R)
White RCA = Audio IN (L)
Yellow RCA = Video IN
17
DANSK
ENGLISH DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKAESPAÑOL
PORTUGUÊS
IR remote control
DPOWER
On/off button for the monitor.
ETV/VIDEO
Input selector: switch between
AV1 and AV2.
FVOL • arrow button
Increase the volume for the
selected monitor.
VOL • arrow button
Decrease the volume for the
selected monitor.
GMUTE
Mute the volume of the
loudspeaker inside the monitor.
HCH • arrow button /
Channel selection if the monitor is
connected to a signal controller
IVSC-3302 or IVSC-5502.
Caution:
The way the CH /buttons
function depends on the monitor
selection, which is made using
the signal controller’s remote
control.
IMENU
See Instructions / OSD menu.
JBattery compartment
DEVICE OVERVIEW
D
H
EF G
I
J
18
CONTENTS
Device overview ..................... 15
Ceiling-mounted monitor................ 16
IR remote control ........................... 17
Contents................................. 18
Notes for the user .................. 19
Precautionary measures ................ 19
Safety notices ........................ 20
Supplied parts ........................ 20
Installing the monitor ............. 21
Installing the monitor (mechanical) . 21
Cables .......................................... 22
Operation ............................... 23
Controlling the interior lighting
(monitor) ....................................... 23
Opening the monitor ...................... 23
Adjusting the position of the
monitor .......................................... 24
Closing the monitor ....................... 24
Switching on the monitor ............... 24
OSD menu .................................... 25
IR headphones IVHS-01
(accessory) ................................... 25
Changing the light bulb ................. 26
Changing the battery in the
remote control ............................... 26
Specifcations ......................... 27
IVMR-7002.................................... 27
19
DANSK
ENGLISH DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKAESPAÑOL
PORTUGUÊS
Thank you for choosing a Blaupunkt
product. We hope you enjoy using this
new piece of equipment.
Please read these operating
instructions before using the
equipment for the first time.
The Blaupunkt editors are constantly
working on making the operating
instructions clearer and easier to
understand. However, if you still have
any questions on how to operate the
device, please contact your dealer or
the telephone hotline for your country.
You will find the telephone number
printed at the back of this booklet.
We provide a manufacturer guarantee
for our products bought within the
European Union. You can view the
guarantee conditions at
www.blaupunkt.de or ask for them
directly at:
Blaupunkt GmbH
Hotline
Robert-Bosch-Str. 200
31139 Hildesheim
Germany
We shouldliketopointoutthatthe right
to make a claim under the guarantee
could be forfeited if the device is
changedormodifiedinanywaywithout
the express authorization of the
manufacturer.
Long-termoperationor storageoutside
thespecifictemperaturerangecanlead
to a shortening of the useful life of the
LC display.
NOTES FOR THE USER
Precautionary measures
Pleaseobserve allthewarning notices,
precautionary measures and
maintenance tips contained in these
operating instructions so as to extend
the life of your monitor.
●If you are the driver you must never
use the monitor during the journey
in order to avoid causing a road
accident.
●Do not place the monitor in the
following positions:
1. Positions in which it could
restrict the driver’s view.
2. Positions in which it could
become a danger to safety
(e.g. handbrake, steering wheel,
gearshift lever and airbag).
●Only operate the device with the
recommended voltage supply of
12 V direct current.
●Do not attempt to open or
dismantle the monitor, since you
could suffer an electric shock as a
result.
●If the monitor’s housing is
damaged or broken, take it to your
local specialist dealer or send it in
to our customer service centre.
●Avoid using the monitor in
environments where it is subjected
to dust, dirt or moisture.
●Do not install the monitor in places
where it is subjected to direct
sunlight or extreme temperatures.
20
NOTES FOR THE USER
Note
We recommend that you allow a
specialist workshop to carry out the
installation.
Safety notices
Please observe the following safety
noticesduringinstallationandwhilst
making the connections.
-Disconnect the negative and
positive terminals of the battery.
-When doing so, please observe the
safety notices provided by the
vehicle manufacturer.
-Before drilling the holes necessary
for mounting the equipment and for
laying cables, please make sure
that concealed cables, the fuel tank
and fuel lines cannot be damaged
in the process!
Supplied parts
Themonitorissuppliedwithalltheparts
listed below. Please check that the
rangeofpartssuppliedwithyourdevice
is complete. If one of the listed parts is
missing, please contact your dealer
immediately.
●Monitor (including mounting fixture
and screws)
●Remote control IVRC-06 with
battery
●5 m long 13-pin system cable
(for signal controller IVSC-3302 or
IVSC-5502)
●Connection adapter (13-pin RCA/
jack)
●Operating instructions
SUPPLIED PARTS
21
DANSK
ENGLISH DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKAESPAÑOL
PORTUGUÊS
INSTALLING THE MONITOR
Screws for securing the
ceiling-mounted monitor
Installing the monitor
(mechanical)
Select a suitable position for secure
installation of the monitor:
●The device must not distract the
driver or restrict the driver’s view.
●The ability to enter and get out of
the vehicle must not be impeded.
●The device must not be installed in
such a way that could prevent the
other vehicle components from
functioning properly (e.g. sliding
sunroof).
●Make sure that the device is
installed in a safe and secure
position and that it cannot become
detached in the event of an
emergency stop.
●Do not attach the device merely to
the roof liner.
●If you need to drill additional holes,
make sure you do not drill through
the sheet metal of the vehicle’s
roof.
●Avoid using the monitor over a
longer period of time whilst the
engine is off in order to prevent the
battery from becoming discharged.
Screws for securing the
mounting plate
22
Cables
INSTALLING THE MONITOR
Systemcable
(13 pin)
Cable for the
interior lighting
(3 pin)
Adapter cable
Interior lighting connection (3 pin)
Red = Operating voltage (+12 V)
White = To the door switch
(Door open = Earth)
Black = Earth
To avoid discharging the battery, we
recommend you use a switched
operating voltage (ignition).
Warning notice:Theoperatingvoltage
cable must be protected with at least a
1.5Afuse.
Monitor connection (13 pin)
Connect the system cable (13 pin) >
to a signal controller (IVSC-3302 or
IVSC-5502). (The voltage supply is
provided by these devices. Operating
instructions are supplied with the
devices).
Or
Use the plug-in adapter cable ?to
connect to the 12 V supply voltage and
an external video/DVD device:
Red = ACC+12V
Yellow = +12 V direct current
Black = Earth
Red RCA = Audio IN (R)
White RCA = Audio IN (L)
Yellow RCA = Video IN
Jack (blue) = Infrared loop-through
for connection to the
IR-sensor input of
DVD-ME2 / DVD-ME3.
Attention:To beusedonlyinconjunction
with DVD-MEx series products!
>
Signal cable
(monitor hous-
ing) (13 pin)
?
=@
23
DANSK
ENGLISH DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKAESPAÑOL
PORTUGUÊS
Controlling the interior lighting
(monitor)
There are two switches for the lights:
ON 2and interior lighting 4.
ON :
This button is used to switch the lights
on/off.
Interior lighting :
If activated, the lights only come on
when the vehicle’s doors are opened.
OPERATION
Opening the monitor
➮Pull back the monitor release latch
3to flip down the LCD display.
➮To watch television, lower the
monitor until it is at an angle of
approx. 90°to the monitor’s base
unit.
2 4
3
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Sistema de vídeo para coche de Blaupunkt
Blaupunkt
Blaupunkt COSTA MESA 900 Manual de usuario
Blaupunkt
Blaupunkt HANNOVER 570 DAB Manual de usuario
Blaupunkt
Blaupunkt La Paz 880 Manual de usuario
Blaupunkt
Blaupunkt Jamaica 970 Manual de usuario
Blaupunkt
Blaupunkt New York 750 Manual de usuario
Blaupunkt
Blaupunkt HONG KONG 650 Manual de usuario
Blaupunkt
Blaupunkt IVOD-1022 Manual de usuario
Blaupunkt
Blaupunkt CHICAGO IVDM-7002 Guía del producto
Blaupunkt
Blaupunkt Key Largo 970 Manual de usuario
Blaupunkt
Blaupunkt IVMR 1042P Manual de usuario
Blaupunkt
Blaupunkt San Andres 970 Manual de usuario
Blaupunkt
Blaupunkt ASPEN IVDM-7003 Manual de usuario
Blaupunkt
Blaupunkt Santa Rosa 980 Manual de usuario
Blaupunkt
Blaupunkt TEXAS CITY 800 Manual de usuario
Blaupunkt
Blaupunkt NEW YORK 800 Manual de usuario
Blaupunkt
Blaupunkt Jamaica 970 Manual de usuario
Blaupunkt
Blaupunkt Los Angeles 510 Manual de usuario
Blaupunkt
Blaupunkt IVOD-1002 Manual de usuario
Blaupunkt
Blaupunkt KIMBERLEY 941 Instrucciones de montaje
Blaupunkt
Blaupunkt Ft.Lauderdale 900 Manual de usuario
