10 BLACKRIDGE 1HP AIR INFLATOR BLACKRIDGE 1HP AIR INFLATOR 11
Important
This air inflator is fitted with a sealed electrical connection plug
that is compatible with the mains power supply for Australia
/ New Zealand and meets the requirements of Australian
Standards. This air inflator must be connected to a supply
voltage that is equal to that stated on the rating label. If the
mains power connection plug or power cord becomes damaged
it must be replaced with a complete assembly that is identical to
the original, and this must be replaced by an authorised service
facility. Always follow the Australian / New Zealand requirements
for connection to the mains supply. If in doubt always consult a
qualified electrician.
Do not attempt to modify the air inflator, guards or the
supplied accessories in any way.
Domestic air inflators are designed for intermittent operation.
Ideally a 50% duty cycle. (Meaning: 30 seconds ON motor
pumping and 30 seconds OFF, motor not pumping). Simply
put, when the motor is pumping, the attached air tool can not
be used. Only use the attached air tool while the air inflator is
not pumping.
Stop using the attached tool as soon as the air inflator starts
pumping.
Fully assemble air inflator before use.
Never run this air inflator without the air filter and rubber
stopper(s) being correctly fitted.
Never use an extension cord with this air inflator always use a
longer air hose.
Never connect to a generator which does not produce
sufficient power, at least 3000W and has pure sine wave
power output.
Domestic air inflators are not designed for industrial /
commercial applications.
Domestic air inflators are not designed for continuous running.
Always follow duty cycle - 50%.
Avoid touching the pump area as it can become very hot and
may burn.
Ensure that the air inflator is disconnected from the mains
supply when not in use, before servicing, lubricating, making
changes and when changing attachments such as air hoses /
tools.
Always use the correct type of tool for the operation to be
carried out.
Never use the air inflator if any part of the unit is damaged.
Always have the air inflator serviced by an authorised service
facility.
Always wear safety eye, ear and respiratory protection when
operating the air inflator.
Allow the tank to completely fill before using the air inflator.
If the air inflator makes an unfamiliar sound or vibrates
excessively, switch the air inflator ‘OFF’ immediately and
disconnect from the mains power supply. Investigate the
possible cause or consult your authorised service facility.
Always move the air inflator using the handle.
Always use the air inflator on stable ground.
This air inflator is designed to compress normal air. Never use
to compress any other type(s) of gases.
Never direct the jet of air or other liquids / gases towards your
body, other persons or animals.
Never direct the jet of air or other liquids / gases towards this
air inflator.
This air inflator is not suitable for pharmaceutical, food or
sanitary purposes.
This air inflator is not to be used to for filling scuba or oxygen
air bottles or tanks.
Always follow the instructions relating to the tools attached to
this air inflator.
SPECIFIC SAFETY
INSTRUCTIONS
WARNING! DO NOT USE THE AIR INFLATOR IN
AREAS WHERE THERE IS A RISK OF EXPLOSION
OR FIRE FROM COMBUSTIBLE MATERIALS.
THE SPARKS GENERATED FROM CERTAIN
TOOLS ATTACHED TO AIR INFLATOR CAN
IGNITE COMBUSTIBLE MATERIALS AS WELL
AS FLAMMABLE LIQUIDS, PAINT, VARNISH,
PETROL, FLAMMABLE GASES AND DUST OF
AN EXPLOSIVE NATURE. AS A PRECAUTION IT
IS RECOMMENDED THAT YOU CONSULT AN
EXPERT ON A SUITABLE FIRE EXTINGUISHER
AND ITS USE.
