Biketronics Titan II Manual de usuario
Page 1 of 2
Remove fairing and existing Harley speakers.
Place grills on adapter with cloth-side facing towards rider.
Begin by positioning clutch-side adapter as shown.
DO NOT OVERTIGHTEN SCREWS
Clutch-side adapter shown
Outside Edge of Fairing
Step One: Mounting Adapter to Fairing
Titan II 7.1” Speaker
Installation Guide
BT7P1
ElectraGlide fairing
1996 to Present
Specifi cations:
Coaxial 180mm (7.1”)
2 way - 20mm tweeter, 180mm woofer
4 ohm impedance
Effi ciency - 92.6 dB/SPL
Frequency range - 45-22kHz
100 Watts RMS power, 200 Watts peak
Integrated crossover
Kit Contents:
(2) 7.1” Speakers
(2) Speaker Adapters
(6) #10x⅞” Screws
(8) #6x¾” Screws
(2) Cloth-Covered Grills
Position adapter
so the “missing”
screw hole on the
adapter is on the
inside-bottom.
Brake-side will be
the mirror image
of this photo.
Use new #10x⅞” screws in these three holes
BIKETRONICS
Page 2 of 2
Begin by positioning speakers with terminals facing inward.
DO NOT OVERTIGHTEN SCREWS
Step Two: Mounting Speaker to Adapter
Use new #6x¾” screws to secure speaker to adapter
Loosen bolt to aid in positioning of aluminum
bracket. Tighten bolt after speaker is installed.
Attach positive and
negative terminal
leads to speaker.
Use chart at bottom
of page.
Position end tab of horizontal aluminum
bracket below screw head as shown.
1996 to Present Harley wire colors for fairing speaker connections
Brake Side Speaker Terminal Polarity Clutch Side
Harley
Grey/red Positive (+) Red Harley
White/orange
Harley
Light Green/black Negative (-) Black Harley
Light Green/white
Updated 02.05.2013
Contact Biketronics if you require assistance
Toll Free: 800-735-2419
International: 208-875-2645
E-Mail: [email protected]
Web: biketronics.com
Tabla de contenidos
