Using your BIBO
Initial connection to an electrical supply
Once your BIBO has been plugged in to a power supply, the screen will initially display the BIBO logo; this means it is
operating correctly. Select your preferred language and then follow the instructions on the screen, adding hot and cold
water to the respective tanks. (Once the tanks are full, water will flow from the outlet at the front of the dispenser.)
After turning your BIBO on for the first time we suggest you dispense at least 2 litres of water using both the hot &
cold keys.
Before using your BIBO for the first time
Important: When using a new or freshly cleaned BIBO for the first time, it’s important that water is flowing from both the
hot and cold outlets when the keys are touched, before you switch on the hot water tank. If you are self-installing your
BIBO, please see the appendix “Self-installation instructions” at the back of this manual
Once you have flushed 2 litres of water through the system, turn the hot tank on using the switch at back of the machine
(see page 4 of this guide for its location). A prompt will appear to check the hot tank is full of water. The hot tank will
then begin to heat up and the hot water temperature bar will be active on the screen. When first used, the hot tank will
take approximately 5 minutes to get up to maximum temperature. The cold tank takes approximately 15 minutes to get
to minimum temperature.
Performance tip: Depending on your local water pressure it may be necessary to reduce the flow of water into your
BIBO to control the rate at which the water is dispensed particularly from the hot tank. If the flow from the hot tap is too
fast this may reduce the number of consecutive cups of very hot water available in one go. The flow can be adjusted by
partly closing the tap on the connector used to connect to your water supply.
1.
4.
2.
5.
3.
6.
