Enclosed Accessory
1. Instruction Manual 2. Water Pipe 3. Ice Shovel (3 sets
How to use
1. Remove all packaging materials and labels. Keep the unit at up-right position while lifting up from
the packaging to avoid causing damage to the compressor of the unit. The tilt angle can not
greater than 45 Degree.
2. Place the Ice Station at up-right position. Keep the unit at least 20CM apart from the wall around
for better ventilation and operation.
3. Wash the Water Tank; Cooling System, Ice Cube Tray; Ice Shovel of the Ice Station with washing
detergent before each use.
4. Open the Lip Cover, fill the Water Tank with drinking water. When adding water, make sure the
water level does not exceed the maximum water level of the Water Tank. If you use the external
Water Pipe for adding water, make sure the Water Pipe is firmly connected with the In Coming
Water Inlet, open the tap and check to ensure no water leaking in the conjunction part before use.
5. External Water Inlet Installation diagram
Water Inlet Connector
Water Pipe
Valve
3 way water connector
6. Plug in the unit to the power outlet, the Power On Indicator will light, indicating that the machine
is in standby status.
7. Control Panel Diagram
Power On Indicator
Indicator of large size of ice cube
Indicator of medium size of ice cube
Indicator of small size of ice cube
Ice Full Indicator
Lack Water Indicator
Power On/Off Button
Select Button ( Ice Cube Size )
8. Press the “Power On/Off” button in the Control Panel to “On” position to start the operation. The
default setting are set for making medium size ice cube. Press the “Select” button for choosing
the size of ice cube, the indicated size of indicator will light accordingly
During the operation, press the “Power On/Off” button to “Off” position to stop the unit from
running.
9. After the unit running for few minutes, the temperature of the unit and water starts dropping, as
the flowing water temperature reach zero degree, the water become frozen, the indicated size will
blink. Ice cubes making are now in progress.
10. When the ice cubes are formed completely, the indicated size will blink more frequently, 36 pieces
of ice cubes will fall into the Ice Cube Tray automatically for each cycle. Once all ice cubes are
shoveled, the ice cube making cycle starts again.
11. When the Ice Cube Tray is full, the “Ice Full” Indicator will blink, the compressor and fan motor will
stop running. Remove the ice cubes from the Ice Cube Tray. The same Ice cube making cycle will
starts again.
12. Keep pressing the “Select” button for 3 seconds, the ice cubes inside the unit are forced to melt.
Duration of ice cubes making
Making large size of ice cube ( around 15-21 Minutes )
Making medium size of ice cube ( around 12-18 Minutes )
Making small size of ice cube ( around 10-15 Minutes )
IceAge Anleitung_e 19.12.2007 15:17 Uhr Seite 4
