Maintenance
Berridge roll formers require minimum maintenance. To insure the
highest quality product and maximum machine life, the following
routine preventive maintenance is required. Keep the machine DRY,
CLEAN, AND DIRT-FREE. This is a precision piece of equipment. Keep
a Maintenance Log.
1. Remove lexan (plexiglass) panels from both sides. Clean the stainless
steel rolls with mineral spirits. Do not spray lubricant on the lexan
panels.
2. Clean the lexan side panels with glass cleaner (Windex or equivalent)
and the aluminum frame with liquid household cleaner. This will
remove lubricant and dirt from the frame.
3. The uncoiler and casters may be lubricated with a good grease.
Lubricate the upper and lower bearing on the uncoiler. Do not apply
grease to the drive gears on No. 1 station as any dirt, paper, etc. on
the coil will collect on the grease.
4. The drive chain may be lubricated with any good quality spray-on
chain lubricant.
5. Main drive gear box:
Grove Right Angle: Uses a 90 weight gear oil
Eurodrive Vertical Inline: Uses SPO-244 by Lubriplate or equal
Rexnord Vertical or Dodge Quantis Vertical: Does not require
lubricant
6. The table can be cleaned with any liquid household cleaner. Touch-
up as needed with Glidden “Bolt Green” paint.
7. Check tightness of all mounting bolts and screws regularly,
especially after each time the machine has been in transit.
BERRIDGE
MANUFACTURING
COMPANY
2201 Rudeloff Road
Seguin, TX 78155
Sales: (800) 669-0009
Roll Former Dept: (830) 303-0811
Fax: (830) 303-0530
www.berridge.com
