7. Press the MEM/TIME (9) to confirm the time.
Note:
Make sure the hour is set so that AM or PM is correctly displayed. If the PM INDICATOR (22) is
showing on the display, the displayed time is “PM”. If the AM INDICATOR (22) is showing on the
display, the time displayed is “AM”.
RADIO OPERATION
1. Insert the earbuds into the EARPHONE JACK (12) and press and hold the POWER/BAND BUTTON
(1) to turn on the radio.
2. Press the POWER/BAND BUTTON (1) repeatedly to select AM or FM.
3. Press and hold the TUNER UP BUTTON (7)/TUNER DOWN BUTTON (6) to search next/previous
available station. If reception is poor, try manual tuning to fine-tune the station. Press the
TUNER UP BUTTON (7)/TUNER DOWN BUTTON (6) briefly to manually tune through the
frequency band.
4. Adjust the VOLUME UP/VOLUME DOWN BUTTONS (5 and 4) to obtain the desired sound level.
5. Press the BASS BUTTON (3) to enhance the bass effect of the music being played. Press the BASS
BUTTON (3) again to turn the effect off.
6. Press and hold the POWER/BAND BUTTON (1) to turn off the Armband Radio when you have
finished listening. The radio will display the time.
TIPS FOR BEST RECEPTION
FM The FM radio uses the cord from the earbuds as the antenna. Unwrap and extend the cord
for best reception. The FM STEREO INDICATOR will show on the display when receiving a
stereo broadcast and signal is strong enough.
AM The AM antenna is located inside the cabinet of the unit. If AM reception is weak, change
the position of the radio until the internal antenna picks up the strongest signal.
SETTING THE RADIO STATION PRESETS
The Armband Radio allows you to store up to 10 FM station and 10 AM stations for easy recall at
any time.
1. In the FM or AM mode, tune to the radio station you want to store in memory by using the
TUNER UP BUTTON (7) / TUNER DOWN BUTTON (6).
2. Press Store/Alarm Button (8). The MEMORY INDICATOR (20) and the PRESET CHANNEL NUMBER
(21) will be flashing on display.
3. To change the preset channel number location, press the TUNER UP BUTTON (7) / TUNER
DOWN BUTTON (6) to step through the preset locations (1-10).
4. To confirm the preset location, press the STORE/ALARM BUTTON (8).
5. To store up to 10 FM and 10 AM station presets, repeat steps 1 to 4 above.
RECALLING THE PRESET RADIO STATIONS
1. Set the armband radio to FM or AM mode.
2. Press the MEMORY/TIME button (9) repeatedly to select the desired preset station.
