Unlock
1. Press the button once, the status green LED is flashing
2. Press the sensor with your finger (At this moment, If your
fingerprint has been identified, quickly unlock, accompanied by a
beep sound)
Lock
1. SDGF-001 has been unlocked
2. Press the button once (at this moment, SDGF-001 immediately
locks up, accompanied by 2 beep sounds)
Register fingerprint
1. Unlock the SDGF-001 to get the authorized of registration.
2. When the green led is still lit, press and hold the button
continuously until the red and green LED interactive flash and
heard a beep sound.
3. Now, release the button and start to press your finger onto the
fingerprint sensor for scanning your fingerprint, remove your finger
when you hear a beep sound and the green LED lights on once.
4. Repeat step 3 ( for the same finger) until you hear a long beep
sound, completely register your fingerprint (pay attention: To
generate an effective fingerprint registration, must complete 7
times scans)
5. The green and red LED will interactive flash again to allow you to
repeat step3~4 to register another finger or Press the button once
to stop the registration.
Clear fingerprint
1. Unlock the SDGF-001 to get the authorized of registration.
2. When the green led is still lit, press and hold the button
continuously until the red and green LED interactive flash and
heard a beep sound then release the button.
3. Press and hold the button again until you hear a long beep sound
(at this moment, all fingerprints have been cleared)
