Safety information
Important safety instructions
This document contains important instructions and warnings that must be followed when
installing and maintaining the EV Charger.
Read this entire mandatory document before installing or using the EV charger.
This device should be supervised when used around children.
The BCP series EV Charger must be grounded through a permanent wiring system or an
equipment grounding conductor.
Do not touch the EV Charger’s end terminals with sharp metallic objects, such as wire, tools, or
needles.
Use the EV Charger only within the specified operating parameters.
Stop using and do not use the EV Charger if it is defective, appears cracked, frayed, broken,
or otherwise damaged, or fails to operate, or continue operation.
Do not forcefully fold or apply pressure to any part of the EV Charger or damage it with sharp
objects.
Never spray water or any other liquid directly at the wall mounted EV Charger. Never spray
any liquid onto the charger handle or submerge the charger handle in liquid. Store the
charger handle above the ground to prevent unnecessary exposure to contamination or
moisture.
Do not attempt to disassemble, repair, tamper with, or modify the EV Charger. The EV
Charger is not user serviceable. Contact us for any repairs or modification.
Do not install or use the EV Charger near flammable, explosive, harsh, or combustible
materials, chemicals, or vapors.
Transporting the EV Charger, handle with care. Do not subject it to strong force or impact or
pull, twist, tangle, drag, or step on the EV Charger, to prevent damage to it or any
components.
Warning
Safety information
Use of the EV Charger may affect or impair the operation of any medical or implantable
electronic devices, such as an implantable cardiac pacemaker or an implantable cardioverter
defibrillator. Check with your electronic device manufacturer concerning the effects that
charging may have on such electronic devices before using the EV Charger.
Do not insert foreign objects into any part of the EV Charger.
Cautions
That cord extension sets are not allowed to be used.
Incorrect installation and testing of the EV Charger could potentially damage either the
vehicle's Battery and/or the EV Charger itself. Any resulting damage is excluded from New
Vehicle Limited Warranty and the EV Charger Limited Warranty.
Do not operate the EV Charger in temperatures outside its operating range of -25℃ to +55℃.
Do not use private power generators as a power source for charging.
That adaptors or conversion adapters are not addowed to be used.
Notes
Ensure that the EV Charger's charging cable is positioned so it will not bestepped on, driven
over, tripped on, or subjected to damage or stress.
Be careful not to damage the circuit board when removing the power entry knock-out.
Do not use cleaning solvents to clean any of the EV Charger's components. The outside of the
EV Charger, the charging cable, and the connector end of the charging cable should be
periodically wiped with a clean dry cloth to remove accumulation of dirt and dust.
P-01 P-02
●
●
●
