
USAGE
CLEANING
TROUBLESHOOTING
ADJUSTING ANGLES
1. To adjust the angle of the
Solar Panel, simply rotate it
in a desired direction.
2. Swivel each arm at maximum
60° angle to direct the zapper
where needed. Do not force it
past the 60° angle, as this will
damage the unit.
UV light or
flood light
does not
go on.
Not enough charge. Make sure unit is installed where
it can get maximum sun exposure
for 10 hours.
Unit is turned OFF. Press the ON/OFF switch.
Unit is located near
a strong light source.
Make sure unit is installed away
from any strong light sources,
such as an existing outdoor light.
Unit is placed under
trees.
Move the unit to another
open location.
PROBLEM CAUSE SOLUTION
Solar panel is dirty,
or covered up.
Wipe the solar panel clean and
make sure it is always free of
debris.
TECHNICAL INFORMATION
24SMD+8UV LED, 240LM
Solar panel: 5.5V 310mA
UV wavelength: 395nm
Grid Voltage: 1200V (on a fully charged battery)
Sensor distance: 3-5 meters
Sensor time: 30 seconds
Battery type: Built-in 2 x 1200mAh Lithium battery
Charge Time: approx. 10 hrs
IPX Rating: IP65
Make sure to leave the unit under direct sunlight
for solar charging at least 10 hours. UNIT NEEDS
TO BE FULLY CHARGED BEFORE INITIAL USE.
If there isn’t ample sunlight, it may take longer
for the batteries to charge.
1. Turn the Solar Zapper on by pressing the
ON/OFF button.
2. Once dark outside, the UV light will turn on.
It will attract the insects and draw them to the
zapper grid. The high voltage will kill the insects.
3. The floodlight part of the unit will turn on
automatically (when dark) when it detects motion.
The light will stay on for 30 seconds and then
will go off if no motion has been detected.
4. To turn the flood light and UV light off, press the
ON/OFF button.
5. The Solar Zapper and flood light will turn off during
the day or if unit runs out of battery.
ON/OFF BUTTON
Keep your hands/fingers away from the
zapper grid. Do not use water,
liquids or sprays to clean.
1. Make sure your Solar Zapper is turned OFF.
2. Remove the cover from each of the zapper
arms by twisting the cover off.
3. Shake out dirt and debris or use a small soft
brush (not included) to clean the grid.
4. Place the cover back on, twist it to secure
in place.
QVC UK IBuilding 8, Chiswick Park, 566 Chiswick High Road, London, W4 5XU