Rewind and Fast Forward
When a tape has been completely played or re-
eorded, press the stop button to stop the recorder.
To return the tape to the original supply reel, press
the rewind button. To advance the tape rapidly, press
the forward button. Be sure to take up any slack tape
before operating either of these controls to prevent
breaking the tape since it travels at a high rate of
speed in these modes of operation.
CAUTI 0N: Always stop the recorder complete-
ly when going from rewind or forward to
another mode.
Program lndicator
This permits the logging of material as it is
DISASSEMBLY
To Remove Recorder from Case
l. Remove the two reel spindles held in place by
Philtips head machine screws.
2. Remove the control knobs.
Remove the top plate (6) secured in place by 4
Phillips head rnachine screws.
Remove the plastic carrying handle.
Place the recorder ln an upright position and
remove the two plastic feet at the back of the
case.
6. Remove the bottom grille.
?. Remove thetwo Phillips headscrews accessible
through the openings in the metal plastic handle
channel support.
8. Carefully lift the recorder from the case.
To Remove the tape Transport Mechanism
1. Disconnect the drive motor (80).
ADJUSTMENTS
Pressure Roller
1. Connect an inch-ounce scale to the end of pres-
sure roller lever assembly (37).
2. Pull pressure roller free of capstan.
3. If reading is less than 16 in-o2., bend the long
spring to increase the pressure.
Take Up Tension
l. Place an empty 7" reel on the take-up splndle.
2. Attach a short loop of string to the outside edge
of the reel.
3. Connect agramscale with aminimum readingof
60 grams to the string.
Page 4
recorded, or relocating previously logged material.
The indicator should be set at "000" at start of the
tape, then any desired point on the tape can be logged
or relocated.
Public Address
To use there,ggrder asa publicaddress system,
plug a microphone..into the microphone input jack and
turnthe poweron. Remove alltape from therecorder.
Set the monitor switch to the monitor position. De-
press the record button and lock it in place by de-
pressing the play button.
Keep the microphone well away fromthe speak-
ers to prevent acoustic feed-back squeal.
I NSTRUCTI ONS
2. Remove the input and output jacks, function se-
lector switch, and monitor switch.
3. Disconnect the head leads.
4. Remove the six self-tapping screws holding
transport to the speaker mounting plates.
5. Carefully lift thetransport mechanism from the
speaker mounting plates.
To Remove the Amplif ier
l. Disconnect all plug-in leads.
2. Disconnect the slide switch wire link from the
slide switch.
3. Unsolder the leads to the muting switch.
4. Remove the volume and tone control locking
nuts.
5. Remove the self-tapping screws and washers
along thetop and bottom edgeof the printed cir-
cuit board.
6. Carefully remove the amplilier assembly.
HoId the scale parallel to the recorder and at a
right angle to the take-up spindle.
Depress the play button and note the reading.
ff the reading is over or below 60 grams, re-
move themechanism from thecase asdescribed
under "Disassembly In gtructions".
Remove the mechanism plate held in place by
six Phillips head sheet metal screws.
8. Disengage the counter drive belt (65) from
clutch pulley (?l).
Remove the clutch pulley (71).
Slip the tension spring (69) and felt lining (67)
off the take-up spindle.
3.
4.
5.
4.
5.
6.
7.
9.
10.
