BeLine 1000 Series Manual de usuario
BeLine
1000/1100/RF1500 Series
Cardlock Installation Guide
BeLine
Main (818)357-5980
www.belinelocks.com www.cardlockusa.com
www.innlockcompany.com www.innlockco.com
Unpacking the Cardlock
The Cardlock is packed with the following items:
EXTERIOR LOCK BODY (QUANTITY =1)
INTERIOR LOCK BODY (QUANTITY =1)
LOCK BODY SCREWS (QUANTITY =4)
MORTISE (QUANTITY =1)
SQUARE MORTISE DRIVE (QUANTITY =2)
SQUARE THUMBTURN DRIVE (QUANTITY =1)
CYLINDER CAP AND KEY SET (QUANTITY =1)
CYLINDER, KEYS AND CYLINDER CAP
BATTERY TRAY (QUANTITY =1) FOR GENERAL OR PUBLIC ENTRANCE
LOCKS, LITHIUM AA BATTERIES ARE RECOMMENDED.
BATTERIES NOT INCLUDED
STRIKE SET
STRIKE CUP (QUANTITY =1)
STRIKE PLATE (QUANTITY =1)
STRIKE WOOD SCREWS (QUANTITY =2)
MORTISE FACE PLATE (QUATITY =1)
MORTISE FACE PLATE SCREWS (QUANTITY =2)
CARD READER (QUANTITY =1)
ATTACHED TO INTERIOR LOCK BODY
Template for Routing a Door
BeLine strongly suggests that the installer purchase a metal template guide from
BeLine for the door cutout process.
For the actual mechanical dimensions for cutting the door refer to the document,
Cardlock 1000 1100 1500 Template
Available for download at www.cardlockusa.com, www.belinelocks.com,
www.innlockcompany.com or www.innlockco.com
A Recommended Tool for Carpenters:
•Mortise Jig
Step 1. Insert the Mortise and drive in wood screws
Step 2. Hand screw the Cylinder into the Mortise
When then key is inserted into the Cylinder and turned to unlock, the arm of the
Cylinder needs enough room to rotate. When
A tight fit will result in a Cylinder over screwed into the Mortise.
KEY NOT TURNED
KEY TURNED
Note: The Cylinder must be in the orientation shown above to allow the locking screw to
secure the Cylinder (shown in Step 3.).
Step 3. Securing the Cylinder
Use a philips screwdriver to turn this screw.
Turning the screw will extend it into the outer edge of the
cylinder.
Step 4. Insert the Square Mortise Drive into the exterior side of the Mortise
Step 5. Position Exterior Lock Body on Door
Note: For easy slip on of the Exterior Lock Body the square shaft that was previously
inserted into the Mortise must be aligned with the lever.
Step 6. Route and connect the mortise cable to the Card Reader
Step 7. Mount the Battery Tray
The battery tray will slide into the door lock through the bottom
Step 8. Route and connect the Battery Tray cable into the Card Reader
Step 9. Insert the Square Thumbturn Drive into the Mortise
Step 10. Mount Interior Door Lock Body and lightly screw in Lock Body
Screws
Step 11. Attach Mortise Edge Faceplate
Este manual sirve para los siguientes modelos
2
