EN Terminal Clamp AKL-8-W
RC-Junky English Conversion 2
Function
The AKL- -W terminal clamp was specially designed for the modules of the SFR (sound
speed controller) and UFR (speed controller) series to allow an easy connection of
LEDs, relays, smoke generators and other consumers to the switching outputs.
As a special feature, the AKL- -W terminal has eight slots for series resistors to simplify
the connection for LEDs.
Included in the delivery of the AKL- -W are eight resistors each with the values:
0 Ohms (only 1 Black ring),
150 Ohms (Brown, Green, Brown)
330 Ohms (Oran e, Oran e, Brown)
6 0 Ohms (Blue, Gray, Brown).
The negative switching outputs 1 - or 9 – 16 of SFR and UFR modules can be
connected directly via the spring-loaded terminals of the clamp. The common positive
pole is located at terminal 9 and 10. The positive pole is supplied from the internal
positive pole of the supply voltage (battery +) connection.
For example, at the SFR-1 the terminal clamp can be plugged into the slots X3 or X4.
At the UFR-1230, the terminal clamp is plugged into X5. The outer brown cable must
point to the center of the board, and the black to the edge of the board.
The terminal can now be used for an easy wiring of the model lighting.
Technical specifications
Sound speed controller SFR series:
Terminal 1 to : switching outputs 1 - or 9 - 16
of the sound speed controller (minus - switching)
Terminal 9 to 10: positive + pole of the supply
terminal
UFR speed controller series:
Terminal 1 to : switching outputs 1 - of the
Speed controller (minus - switching)
Terminal 9 to 10: positive + pole of the supply
tension
10-pin Ribbon cable, 20cm long, directly pluggable
to the SFR and UFR modules
3 x 36 x 17 mm
