5/ 7
Getting started
First
•Install lastest Silicon Labs CP2102 USB to UART bridge VCP Driver.
http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx
•Install and launch the Cleanflight Configurator tool.
https://chrome.google.com/webstore/detail/cleanflight-configurator/enacoimjcgeinfnnnpajinjgmka
hmfgb
•Connect flight controller to computer via USB cable.
•Select the correct COM port if it is not automatically detected.
•Click connect, verify that communication is established.
Basic configuration
•Calibrate sensors
•Configure ports. Default setting: UART2 used for GPS and UART3 used for serial RX.
•Enable features. We recommend that you enable ONESHOT125.
•Configure receiver mode. Default setting: RX_Serial and SBUS.
•Configure voltage monitoring. Voltage Scale must be 110.
•Configure current sensor. Scale must be about 380.
•Configure RSSI if you using a receiver with RSSI output.
•Configure other features. You can open SERVO_TILT if you connect a cam-stab servo to the frame.
Default setting: LED_STRIP / BLACKBOX.
•Configure receiver, set channel mapping.
•Learn about flight modes and configure channels/switches to activate them as required.
•Learn how to arm/disarm.
•Configure LED strip. Default setting:
led 0 15,4::I:0
led 1 15,1::A:0
led 2 12,2::F:0
led 3 12,5::I:0
led 4 9,6::IT:0
led 5 9,3::WFT:0
led 6 6,3::WFT:0
led 7 6,6::IT:0
led 8 3,5::I:0
led 9 3,2::F:0
led 10 0,1::A:0
led 11 0,4::I:0
led 12 0,0:::0
led 13 0,0:::0
led 14 0,0:::0
led 15 0,0:::0
led 16 0,0:::0
