CV/Trigger Inputs to MIDI OUT
Transmuter has eight CV/trigger inputs which are converted into MIDI messages and
sent via the MIDI OUT TRS output.
Inputs 1 to 6 are analog and can detect and transform CV between 0-5v. Input
voltages below 0v will be clipped to 0v and voltages above 5v will be clipped to 5v.
Analog inputs can be used for velocity sensitive NOTE ON messages , Continuous
Controller messages, After Touch messages etc.
Trigger signals can for example be run through a VCA before connection to
Transmuter to allow the trigger signal/level to be modifed and affect the velocity of
the MIDI notes generated. This allows the introduction of dynamics which can
greatly enhance musicallity.
The analog inputs can also function as digital inputs (Program Change, Clock,
Transport etc) if CV functionality is not required.
Inputs 7 & 8 are digital and can only send Note On, Program Change, Clock and
Transport messages.
MIDI IN to CV/Trigger Outputs
Transmuter has eight CV/trigger outputs which are controlled from MIDI messages
supplied to the MIDI IN TRS input.
Outputs 1 and 2 have an accompanying CV output and can be used to convert MIDI
note velocity, continuous controller (Pitchbend, Mod Wheel etc), Aftertouch etc into
a CV signal between 0 and 5v.
Oututs 3 to 8 are digital only and can only be used for trigger/gate signal generation
for MIDI Note On, Clock and Transport (Start/Stop/Continue) messages.
Outputs can be set to Gate or Trigger with configurable pulse length (1ms, 2ms, 5ms,
10ms or 50ms).
