Legal Notices
This document is published in association with the products of BeamReach Networks Incorporated.
Due to ongoing product development and improvements, BeamReach Networks makes no
representations or warranties with respect to the accuracy or completeness of this document and
reserves the right to make changes without notice.
Patents
Products and technologies described herein include those covered by one or more U.S. patents
owned by BeamReach Networks Incorporated.
Copyrights
© 2003 BeamReach Networks Incorporated. All rights reserved. No part of this document may be
copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-
readable form without prior written consent from BeamReach Networks Incorporated.
Printed in the United States of America.
Trademarks
BeamPlex and Adaptive MultiBeam OFDM are trademarks of BeamReach Networks Incorporated.
All other brand names are trademarks of their respective holders.
Revision History
Document number 1106333-02
Revision Status Revision Level Date System Release
Pre-Production Rev 1 April 2003 1.1
Production Rev 2 Sept 2003 1.3
Production Rev 3 Nov 2003 1.3
Compliance
FCC certification – FCC title 47: Part 15 (Class B); Part 27 (WCS bands A and B)
UL 60950
Warning
This device is a radio frequency transmitter. It is
required to comply with FCC RF exposure
requirements for transmitting devices. A minimum
separation distance of 8 inches (20 cm) or more
must be maintained between the antenna and all
persons during device operations to ensure
compliance with the FCC's rules for Radio Frequency
Exposure. If this minimum distance cannot be
maintained, exposure to RF levels that exceed the
FCC's limits may result. This equipment must not be
co-located with any other transmitting antenna.
What this Warning means ...
The Federal Communications Commission (FCC) requires this
warning for electronic devices that transmit radio signals.
The transmit side of the BRU-150 antenna is that surface that
faces the window. The side that faces into the room is shielded
and will not transmit signals.
When selecting a window to attach the antenna, make sure it is
not a location where people may be outside the window and
within 8 inches of the antenna. Normally this is not a problem,
but you should keep this in mind when choosing the antenna
location.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and the receiver.
– Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
– Consult the dealer or an experienced radio / TV technician for help.
Any changes or modifications to this equipment that are not approved by
BeamReach Networks could void your authority to operate the equipment if
such changes or modifications affect the regulatory compliance specified in
Appendix B of document 1106333-01.
Regulatory Notices for Manufacturers and Installers
