PRE-INSTALLATION CHECKS AND SAFETY PROCEDURES
Unpacking - Inspect the packaging for signs of damage. If damage has occurred, advise the carrier and/or
the suppliers immediately. Unpack the receiver carefully and check that all the items are present and correct
(see checklist on box). If any item is missing contact the supplier.
Retain Packaging - The shipping carton is the safest container in which to transport the unit. Retain
undamaged packaging for possible future use.
IMPORTANT SAFETY PRECAUTIONS
Rea & retain instructions - All relevant safety, installation and operating instructions should be read &
retained before attempting to install, connect or operate the unit.
Water an moisture - Do not expose the internal electronics of this unit to water or dampness.
Power sources - This unit should be operated only from the supplied power supply.
Servicing - Servicing of the unit should only be undertaken by qualified service personnel.
Damage requiring service - Servicing by qualified personnel should be carried out under the following
conditions:
(a) When the power supply cord or plug is damaged;
(b) If liquid has been spilled, or objects have fallen into, the unit;
(c) If the internal electronics of the unit have been exposed to rain or water;
(d) If the unit does not operate normally by following the operating instructions.
(e) If the unit has been dropped or the enclosure is damaged;
Replacement parts - If replacement parts are required, ensure that only replacement parts recommended
by the product manufacturer are used.
Safety check - Upon completion of any service or repairs to the unit, safety checks should be performed to
ensure that the unit is in proper operating condition.
Coax groun ing - If an outside cable system is connected to the unit, be sure the cable system is
grounded.
Pre-installation checks - It is recommended that the unit be bench tested prior to installation on the site.
A here to Safety Stan ar s - All normal safety precautions as laid down by British Standards and the
Health and Safety at Work Act should be observed.
WARNING
TO PREVENT DAN ER OF FIRE OR SHOCK, DO NOT EXPOSE THE INTERNAL COMPONENTS OF
THIS EQUIPMENT TO RAIN OR MOISTURE.
