BPS Freedom 50WSolar Panel
- 5 -
The Freedom 50W Solar Panel allows you to safely and efficiently charge
your favorite external baeries (like the Freedom CPAP Baery) and other
small portable electronics (like cell phones and tablets) that operate from
13.2V or less using the power of the sun.
- 2 -
INTRODUCTION
OPTIMAL CHARGING CONDITIONS
direct sunlight with the solar panels angled toward the sun between
30° to 50° from the horizontal (flat)
move the panels throughout the day to follow the movement of the sun
no clouds
no shade covering any of the solar panels
no hanging branches or other obstrucons to direct sunlight
no dirt or debris on the solar panels
FREEDOM CPAP BATTERY CHARGING: DUAL BATTERIES
Charge mes will always vary based on the amount of power the Freedom
50W Solar Panel is able to collect from the sun, which depends upon the
amount of direct sunlight that hits the solar cells, as well as the charging
requirements of the external baery or portable electronic device.
In opmal charging condions the Freedom 50W Solar Panel can charge the
Freedom CPAP Baery in approximately 4 hours if the baery is completely
discharged. Two baeries may be charged simultaneously but please note
that charge mes are per baery.
Charging a device via the DC OUT port while charging another device in the
USB OUT port at the same me will increase charge mes for both devices.
CHARGE TIMES
Unfold the Freedom 50W Solar Panel and angle it toward direct sunlight.
Open the inside flap pocket of the solar panel and remove the output
cable and set of ten (10) universal connector ps.
Plug either end of the output cable into the DC OUT port of the voltage
controller box that is built into the inside flap pocket of the solar panel.
Plug the other end of output cable into the connector p labeled “C”.
The leer “C” is embossed on the plasc poron of the p and there is a white ring
around the top metal poron of the p.
Plug the output cable with the “C” connector p aached into the DC
power pigtail cord that was included with the Freedom CPAP Baery Kit.
Plug the DC power pigtail cord into the DC IN ports of both baeries
to begin the charging process.
VOLTAGE CONTROLLER
BOX DC OUT PORT
DC POWER
PIGTAIL CORD
LLER
R
OUTPUT CABLE
“C” CONNECTOR TIP
INSIDE FLAP
POCKET
DC IN PORTS
