4
- When the signal is received, pressing [PTT] will talk on the
current channel, Release [PTT] will be continues to scan
after 5 sec.
- When scanning, pressing [P2] or Press and hold [P1] will
stop scanning and return to the original channel.
- When the signal is received, pressing [P2] or Press and
hold [P1] will stop scanning and stay in the current channel.
Dual Watch Scan
Press and hold [P2] about 2 sec to start Dual Watch Scan
function. The LCD show and indicates Dual
Watch Scan in progress.
*In the Dual Watch Scan, press [P2] will stop the Dual Watch
Scan and return to the original channel.
CTCSS / DCS setting
1. Press [P1] to select the CTCSS /
DCS Sub-Tone code for the current
channel. If the current channel not
setting CTCSS / DCS the LCD will be
show:
- CTCSS: LCD will show Ct xx,
xx=01~ud, detailed like CTCSS code
table.
- DCS: LCD will show dn xx or dI xx,
xx=01~99, :00~:04 and ud, detailed
like DCS code table.
2. Press [P1] once, the LCD will show "▼" and original RX
Sub-Tone code (-- -- / Ctxx / dn xx / dI xx), then press [▲] or
[▼] to select the new RX Sub-Tone code that you wanted.
After selecting, press [P1] again, the LCD will show "▲" and
now TX Sub-Tone code, then press [▲] or [▼] to select the
new TX Sub-Tone code. After setting finished, press [P1],
[PTT], [P2] or [CH] once to jump out of the Sub-Tone code
setting mode and save your setting.
