BARTON TOOLS HHB-150B Manual de usuario
HHB-150B
HYDRAULIC PUMP
POWER：5.5KW
WORKING PRESSURE ： Low pre ure 20bar High pre ure
700bar
OIL CAPACITY ：15L
G.W.：48.2KGS
In truction manual
Product de cription:
1. Be matched with hydraulic tools through a quick coupler
2. Fast oil inlet within Two-stage high and low pressure,easy operation
and convenience oil return。
3. Built-in safety device, when the pressure reaches 70M a, the safety
valve will automatically release, so as to avoid damage。
4. Configure manual four-way control valve to realize double-circuit
operation。
Operation:
1、Add gasoline (not fill too much, just to the middle position of the
scale) and 15# hydraulic oil into the oil tank, turn the reversing switch to
the middle, and press the red switch on the gasoline engine in the O
direction；
2、Match with hydraulic tool with quick coupler；
2、Start the gasoline engine by pulling the handle and pulling the rope；
3、After running for 1-2 minutes, turn the transfer switch to the right for
oil output, the middle for empty load of gasoline engine, and the left for
oil output；
4、The oil pump should be stopped when the oil temperature rises ≥ 70
C and reused after self-cooling.；
5、After use, press the red switch to turn off the gasoline engine in the-
direction；
6、After use, clean the quick connector and screw on the dust cap, then
clean the tool and put it in the storage box。
Attention:
1.Change hydraulic oil L-HV15 each year 。
2. The overflow safety valve of the pump has been adjusted before
leaving the factory, and it is not allowed to adjust the pressure in order to
avoid damage beyond the rated pressure.
3. If it is not used for a long time and the oil pressure is unstable, this
product can automatically adjust the oil pressure to normal. Operation
method: put the transfer switch in the middle position and run idle for a
period of time, and the oil pressure will be automatically adjusted.
4. If the pump cannot output pressure without any other faults, the
treatment method is to fill up the hydraulic oil.。
5. If the pump cannot output pressure when the hydraulic oil is sufficient:
There are sundries inside the pump body that can not be completely
sealed, and the treatment method is to clean the inside。
Www.barton-tools.com
Manuales populares de Bomba de agua de otras marcas
Sykes AmeriPumps
Sykes AmeriPumps GP100M Guía de solución de problemas
DUROMAX
DUROMAX XP WX Series Manual de usuario
BRINKMANN PUMPS
BRINKMANN PUMPS SBF550 Manual de usuario
Franklin Electric
Franklin Electric IPS Manual de usuario
Xylem
Xylem e-1532 Series Manual de usuario
Milton Roy
Milton Roy PRIMEROYAL Manual de usuario