BANWOOD Classic Manual de usuario
www.banwood.com
CLASSIC
The box
WHAT’S IN
Tools
Allen key (x2)
· 6mm
· 5mm/screw driver
Spanner (x2)
· 13/15mm
· 8/10mm
A. Assembled alloy frame
&rear wheel
B. Handlebar set
C. Tools
D. Front mudguard
E. Front wicker basket
F. Pedal
G. Bell
H. Saddle with seat post
I. Front wheel
J. Training wheels
Before assembled
A
E
J
B
D
F
H
G
I
C
After assembled
Helmet Warning Information
Your Bike
WARNING:
ALWAYS WEAR YOUR
HELMET WHEN RIDING
THIS PRODUCT!
•Helmet should sit level on your head and low on your fore-
head. Exposed forehead can result in serious injury.
• Adjust the strap sliders below the ear on both sides.
• Buckle the chin strap. Adjust strap until it is snug.
• Nomorethantwongersshouldtbetweenthestrapand
your chin.
• Aproperttinghelmetshouldbecomfortableandnotrock
foward/backward or side to side.
Warning and Safety Information
Your Bike
Meanings of Warnings:
This symbols is important. See the word “CAUTION” or “WARNING” which follows it.
The word “CAUTION” is before mechanical instructions. If you do not obey these instruc-
tions, mechanical damage or failure of a part of the bicycle can occur.
The word “WARNING” is before personal safety instructions. If you do not obey these
instructions, injury to the rider or the others can occur.
•CHOCKING HAZARD. Small parts. Not for children under 3 years.
•Adult assembly is required.
•Handlebar hand grip or tube end plugs should be replaced if damaged as bare tubes have
been known to cause injury. All products with capped handlebar ends should be checked
regularly to ensure that adequate protection for the ends of the handlebars are in place.
•Replacements forks must have the same rake and tube inner diameter as the original
product.
•Do not add a motor to the product.
•Do not tow or push the product.
•Do not modify the product.
•Replace worn or broken parts immediately.
•If anything does not operate properly, discontinue use.
NOTE on HANDBRAKES:
In Australia/New Zealand/China:
•Left Brake Lever controls the Rear Brake
•Right Brake Lever controls the Front Brake
Most other countries:
•Left Brake Lever controls the Front Brake
•Right Brake Lever controls the Rear Brake
NOTE: The brake cables for front and rear brakes shall be positioned on the right or left
brake lever according to the legislation or custom and practice of the country in which
the bicycle is sold.
Fitting the Rider to the Bicycle
To determinate the correct size of bicycle for the rider:
• Straddle the assemble bicycle with feet shoulder width apart
andatontheground.
• There must be at least 1 inch (2.5 cm) of clearance 1
between the highest part of the top tube 2and the crotch
oftheriderwithtiresproperlyinated.
• The minimum leg-length for the rider is the highest
part of the top tube plus one inch 3.
1
3
2
The Owner’s Responsibility
WARNING: This bicycle is made to be ridden by one rider at a time for general
transportation and recreational use. It is not made to withstand the abuse of stunting and jumping.
If the bicycle was purchased unassembled, it is the owner’s responsibility to follow all assembly and
adjustment instructions exactly as written in this manual, and any “Special instructions” supplied
and to maked sure all fasteners and components are securely tightened.
NOTE: Periodically check that all fasteners and components are securely tightened.
If the bicycle was purchased assembled, it is the owner’s responsibility, before riding the bicycle for
thersttime,tomakesurethebicyclehasbeenassembledandadjustedexactlyaswritteninthis
manual, and any “Special instructions” supplied and to make sure all fasteners and components are
securely tightened.
NOTE:
If product is assembled, please proceed to sections:
•Testing Stem, Handlebar
•Seat Clamp tightness.
General Warning
Your Bike
WARNING: Not intented for use on public roads.
•Always wear a bicycle helmet that meets CPSC safety standars, as well as local safety
standards.
•Always wear shoes.
•Bikes 12in (30cm) and under not intended for use on public roads.
•Avoid riding at night, dusk, dawn and any other time of poor visibility.
•Reectors:
•Foryourownsafety,donotridethebicycleifthereectorsareincorrectlyinstalled,
damaged, or missing.
• Doornotallowthevisibilityofthereectorstobeblockedbyclothingorotherarticles.
Dirtyreectorsdonotworkwell.Cleanthereectors,asnecessary,withsoapandadamp
cloth.
• Use extra caution in wet weather:
•Ride slowly on damp surfaces because the tires will slide more easily.
•Allow increased braking distance in wet weather.
• Avoid these hazards to prevent loss of control or damage to your wheels:
•Be aware of drain grates, soft road edges, gravel or sand, pot holes or ruts, wet leaves,
or uneven paving.
•Cross railroad tracks at a right angle to prevent the loss of control.
•Avoid unsafe actions while riding.
•Do not carry any passengers.
•Do not carry any items or attach anything to your bicycle that could hinder your vision,
hearing, or control.
•Do not ride with both hands off the handlebar.
Maximum rider/bike weight for this product is as follows
Bike
Size
Rider Rider + Bike Rider + Bike+Basket
kg lbs kg lbs kg lbs
12 27 60 35.3 78 35.45 78
14 27 60 35.7 79 35.85 79
16 27 60 36.6 81 36.76 81
18 34 75 44.5 98 44.66 99
Introduction to Assembly
Assembly
This Owner’s Manual is made for several different bicycles:
•Some illustrations may vary slightly from the actual product.
•Follow instructions completely.
•If the bicycle has any parts that are not described in this manual, look for separate “Spe-
cial Instructions” that are supplied with the bicycle.
•Modelsmayhavedifferentaccessoryitemssuchasbags,baskets,reectors,cupholders,
racks, etc.
•All features, componets and accessories are not included on all models.
•Usetheindexpagetolocatespecicsectionsofthismanual.
•Please read through this entire manual before beginning assembly or maintenance.
•Ifyouarenotcondentwithassemblingthisunit,refertoalocalbikeshop.
WARNING: Keep small parts away from children during assembly.
Do not dispose of the carton and packaging until you complete the assembly of the bicycle.
This can prevent accidentally discarding parts of the bicycle.
NOTE: All of the directions (right, left, front, rear, etc.) in this manual are as seen by the rider
while seated on the bicycle.
Step 1Stem Installation
Loosen the bolt on the top of the stem to allow movement of the stem end.
Insert the stem into the headset and make sure the headset is over the safety line
of the stem. Using the provided Allen key, fasten the bolt on the top of the stem.
WARNING: To prevent steering system damage
and possible loss of control, the “MIN-IN” (minimum insertion)
mark Aon the stem must be below the top of the Locknut B.
WARNING: Do not over-tighten the stem bolt. Over
tightering the stem bolt can damage the steering system and cause loss of
control.
A
B
Testing Stem and Handlebar Tightness
Testing Stem and Handlebar Tightness
To test the tightness of the stem:
•Straddle the front the wheel between your legs.
•Try to turn the front wheel by turning the handlebar.
•If the handlebar and stem turn without turning the front wheel, realign the stem with the wheel
and tighten the stem bolt(s) tighter than before (about 1/2 revolution only at a time).
•Do this test again, until the handlebar and stem do not turn without turning the front wheel.
To test the tightness of the handlebar clamp:
•Hold the bicycle stationary and try to move the ends of the handlebar up and down or forward
and back.
WARNING: Do not exceed 100 lbs (45kg) force.
•If the handlebar moves, loosen the bolt(s) of the handlebar clamp.
•Put the handlebar in the correct positon and tighten the bolt(s) of the handlebar clamp tighter
than before.
•If the handlebar clamp has more than one bolt, tighten the bolts equally.
•Do this test again, until the handlebar does not move in the handlebar clamp.
Step2Front mudguard Installation
• Taking out the screw by spanner
10mm.
• Install the mudguard,then put
back the screw and x it.
• Take out the screws on fork
dropouts by screw driver.
• Place mudguard supports on fork
dropouts.
• Put back the screws and use
screw driver to x.
How to assemble the front mudguard?
Otros manuales para Classic
1
Este manual sirve para los siguientes modelos
3
Tabla de contenidos
Otros manuales de Bicicleta de BANWOOD
