BaByliss 7861U Manual de usuario
Model 7861U
JAPANESE STEEL
12 IN 1 MULTI TRIMMER
7861U IB-19/147A.indd 1 7/19/2019 3:05 PM
SAFETY CAUTIONS
• This appliance should only be used as described within this
instruction book. Please retain for reference.
IMPORTANT CHILD SAFETY
WARNING! Polythene bags over the product or packaging
may be dangerous. To avoid danger of suffocation, keep away
from babies and children. These bags are not toys.
IMPORTANT SAFETY
• Do not immerse the appliance in water or other liquids.
• Always inspect the appliance before use for noticeable signs
of damage. Do not use if damaged or if the appliance has
been dropped. In the event of damage contact the Conair
Customer Care Line (refer to ‘UK After Sales Service’ section
for further information).
• Only use the attachments supplied with this appliance.
• Do not leave the appliance unattended when switched on.
• Do not place the appliance on any surface whilst in operation.
• Special care is required when using the appliance close to
the ears, eyes and face.
• This appliance should not be used by adults whose reduced
physical, sensory or mental capabilities, or whose lack of
experience and knowledge, might cause a hazard, unless
they have been correctly instructed to understand the safe
use and hazards involved and are adequately supervised.
• Careful adult supervision is required when this appliance is
used on or near children. Do not use on very young children.
• This appliance should not be used, cleaned or maintained by
children. Keep out of reach of children.
7861U IB-19/147A.indd 2 7/19/2019 3:05 PM
• Always ensure that this appliance is kept out of the reach
of children at all times, particularly during use and whilst
cooling.
• Allow the appliance to cool before storing away.
• This appliance complies with the requirements of Directives
2004/108/EC (Electromagnetic Compatibility) and 2006/95/
EC (Electrical Safety of Domestic Appliances).
• The battery should be removed for safe disposal at the end
of its life.
• When the battery has run down, it should be disposed of at a
recycling centre to safeguard the environment. If the battery
leaks, avoid touching it and dispose of it at a recycling centre.
7861U IB-19/147A.indd 3 7/19/2019 3:05 PM
FEATURES
• Cordless trimmer with 5 interchangeable attachment heads
- Precision trimmer with Japanese Steel cutting blades
- Adjustable comb guide (2mm-14mm)
- Adjustable stubble comb guide (1mm-3.5mm)
- Body Groomer
- 3 x comb guides (3mm, 5mm, 7mm)
- Detail Trimmer
- 2 x Eyebrow comb guides (3mm, 5mm)
- Nose & Ear trimmer
- Foil shaver
• Lithium-ion battery
• 100% Waterproof
• 120 minute run time
• 2 hour charge
• Washable heads
• Storage pouch
INSTRUCTIONS FOR USE
IMPORTANT! Only use the adaptor and attachments supplied with this
appliance. Please note, if the wrong adaptor is used, the blue LED will
blink continuously. Once the wrong adaptor is removed the blue LED will
continue to blink for some time after removal. This is normal.
When charging the appliance the blue LED charging light will ash slowly
and continuously until the battery has fully charged, then the blue LED
charging light will stop ashing but remain on.
7861U IB-19/147A.indd 4 7/19/2019 3:05 PM
Charging the Appliance
• Before using for the rst time, the appliance should be fully charged
continuously for 3 hours. This initial super-charge ensures optimum
power performance to ensure smooth fast trimming every time. Maximum
battery capacity will only be reached after 3 charging and discharging
cycles.
• 2 hours full charge will provide approximately 120 mins use and 20 mins
quick charge will supply 20 mins use.
• Ensure the appliance is switched off.
• Insert the appliance into the charging.
Cordless Operation
• Ensure appliance is charged for a minimum of 30 minutes. The blue LED
charging light will ash when the adaptor is correctly inserted into the
appliance and connected to the mains.
• Once the appliance is fully charged the blue LED charging light will stop
ashing but remain on. Remove the mains cord from the appliance, turn
on and use as required.
Preserving the batteries
• In order to maintain the optimum capacity of the Lithium-ion rechargeable
batteries, the trimmer should be fully discharged and then recharged for
3 hours every 6 months.
• For optimum performance, we recommend you charge the unit for at
least 30 minutes before using the appliance each time. This applies to
whether you are using it with cordless power.
Preparation for Use
• Always inspect the appliance before use for noticeable signs of damage.
Do not use if damaged.
• Ensure the heads are free from hair and debris.
• Ensure the appliance is sufciently charged.
• Use on clean, dry hair that has been combed until tangle-free.
7861U IB-19/147A.indd 5 7/19/2019 3:05 PM
Changing the Heads
• Before changing the heads, ensure the trimmer is switched off.
• To remove the head, twist the pull off (Fig. 1).
• To attach the head, by aligning the markers up, sliding the head on and
twisting the head to lock (Fig. 2).
Comb Guides
7-Position Comb Guide For Precision Trimmer:
• Ensure the appliance is switched off.
• Attach the Precision Trimmer head.
• Align the trimmer with the tracks at the back of the
handle. Slide the trimmer head onto the tracks. Push
down the release mechanism to push it right on to the
handle.
• The comb guide will be set to the shortest length
when the comb guide is fully pressed down.
• With your thumb, push the guide up to the required length (2-14mm).
The comb guide has 7 positions; 2mm, 4mm, 6mm, 8mm, 10mm, 12mm
and 14mm.
• To remove the comb, place your thumb on the back of the attachment
and pull out lock of comb base out of slot then push up.
1. 2.
1. 2.
1. 2.
1. 2.
1. 2.
Remove head
Place head
Place Comb Shaver
Place Comb trimmer
release Comb trimmer
1. 2.
1. 2.
1. 2.
1. 2.
1. 2.
Remove head
Place head
Place Comb Shaver
Place Comb trimmer
release Comb trimmer
(Fig. 1) (Fig. 2)
7861U IB-19/147A.indd 6 7/19/2019 3:05 PM
Stubble comb guide
The taper control with 6-position switch enables super
ne cut adjustment for precision trimming.
• Attach taper control by sliding the head onto the
tracks at the rear of the handle.
• To increase the length by 0.5mm to a cutting length
of 1mm, slide the switch across so the line is lined
up with the desired length ie 1mm, 1.5mm, 2mm,
2.5mm, 3.0mm and 3.5mm.
• To increase the length by a further 0.5mm to a cutting length of 1.5mm,
slide the switch down so both 1 and 2 are visible above the taper control
switch.
1. 2.
1. 2.
1. 2.
1. 2.
1. 2.
Remove head
Place head
Place Comb Shaver
Place Comb trimmer
release Comb trimmer
1. 2.
1. 2.
1. 2.
1. 2.
1. 2.
Remove head
Place head
Place Comb Shaver
Place Comb trimmer
release Comb trimmer
7861U IB-19/147A.indd 7 7/19/2019 3:05 PM
Body Groomer Attachment
• Ensure the appliance is switched off
• Attach the body groomer head by taking off the current head and
snapping the body groomer head into the base of the appliance.
• Attach the comb guide by placing on top of the body groomer head and
pressing down.
• To remove the body groomer comb guide push the comb guide up
• To remove the body groomer attachment place your thumb on the back
of the attachment and push up.
TRIMMING
Precision Trimmer
Using the Precision Trimmer with 7-position comb guide or taper
comb guide
• Attach the 7-position comb guides and select the required length (2-
14mm).
• If you require more than one cutting length, start with the longest length
rst.
• Switch the trimmer on.
• Hold the trimmer with the teeth of the trimmer pointing upwards, yet at
against the skin.
• Move the trimmer upwards and outward through the hair, against the
direction of hair growth.
• The trimmer will work most efciently when cutting through hair at its
own speed.
• Never switch the appliance off whilst in the hair.
• Note: The Precision Trimmer can be used without any comb guides and
will cut roughly to a length of 0.5mm.
To outline using the Precision Trimmer:
• Do not attach a comb guide.
• Hold the trimmer upside down with the blade facing
downwards, yet at against the skin.
• Move the trimmer gently downwards in small strokes
around the edge of the area you wish to outline.
7861U IB-19/147A.indd 8 7/19/2019 3:05 PM
• Having dened the outline, hold the trimmer with the blades pointing
upwards, yet at against the skin and move the trimmer upwards against
the direction of hair growth. This will trim the unwanted hair adjacent to
the outline.
Using the Body Groomer with comb guide:
• Attach the body grooming attachment.
• Add on the comb guide if a longer length is required
• Switch the trimmer on.
• Hold the trimmer at against the skin.
• Move the trimmer upwards and outward through the
hair, against the direction of hair growth.
• Make sure to be particularly careful when trimming
sensitive areas.
• The trimmer will work most efciently when cutting through hair at its
own speed.
• Never switch the appliance off whilst in the hair.
• Note: The Body Groomer can be used without any comb guides and will
cut roughly to a length of 0.1mm.
Foil Shaver
Using the Foil Shaver:
• For an ultra-smooth nish, use the foil shaver
attachment.
• Always ensure the foil is not damaged before each
use.
• Switch the trimmer on.
• Move the shaver gently over the skin, applying
minimal pressure and shaving in the direction of hair growth.
• Make sure to be particularly careful when trimming sensitive areas.
• Never switch the appliance off whilst in the hair.
7861U IB-19/147A.indd 9 7/19/2019 3:05 PM
Nose & Ear Trimmer
Using the Nose & Ear Trimmer:
• For the safe and easy removal of unwanted nose and
ear hair use the rotary trimmer head.
• Switch the trimmer on.
• Insert the trimmer into the nose or ear and gently
move the trimmer in a circular motion.
• Only use the trimmer at the entrance to the ear or nose.
Do not use any deeper, as this could cause injury.
• Never turn the trimmer off whilst in the nose and ear
hair.
Detail Trimmer
Using the Detail Trimmer:
• For accurate tramlines and detailed effects, attach
the Detail Trimmer head.
• Switch the trimmer on.
• Gently move the blade through the area of hair you
wish to trim.
• The trimmer will work most efciently when cutting
through hair at its own speed.
• Never turn the trimmer off whilst in the hair.
CLEANING & MAINTENANCE
To maintain optimum performance, the appliance should be cleaned after
each use:
• Remove the comb guide after use. Rinse under running water and dry
thoroughly before storage or use.
• Remove the trimmer head after use. The heads are washable for easy
cleaning. Rinse under running water and dry thoroughly before storage
or use.
• Do not disassemble the blades.
• For instructions on how to re-attach the head, please refer to ‘‘Changing
the Heads’’ section.
7861U IB-19/147A.indd 10 7/19/2019 3:05 PM
Otros manuales para 7861U
1
Tabla de contenidos
Otros manuales de Recortadora de BaByliss
BaByliss
BaByliss PRO FX7880E Manual de usuario
BaByliss
BaByliss Ladyliss G281E Manual de usuario
BaByliss
BaByliss 7861U Manual de usuario
BaByliss
BaByliss Miniliss G585E Manual de usuario
BaByliss
BaByliss Super Beard 7897U Manual de usuario
BaByliss
BaByliss MT987U Manual de usuario
BaByliss
BaByliss TRIPLE S 7880U Manual de usuario
