Baby Trend Double Snap N Go Manual de usuario

Model # 1305TW

Infant car seats not included

Convenience through innovation and thoughtful design

Instruction Manual

11.09

Please read all instructions BEFORE assembly and USE of product.

KEEP INSTRUCTIONS FOR FUTURE REFERENCE.

Double Snap N Go®

Double Snap N Go ®

Double Snap N Go®

WARNING: Please follow all of these instructions to ensure the

safety of your children. Keep these instructions forfuture reference.

WARNING: Failure to follow these instructions could result in

serious injury ordeath. Avoid serious injury from falling or sliding out.

Always use the infant car seat harness and insure that the child and

infant car seat are properly positioned according to these instructions.

WARNING: Never leave child unattended.

WARNING: Care must betaken when folding and unfolding the

product to prevent ﬁnger entrapment.

To Contact us:

Baby Trend, Inc.

1607 S. Campus Ave.

Ontario, CA 91761

Parts Hotline:

1-800-328-7363

8:00 a.m. and 4:30 p.m. Paciﬁc Standard Time

• This product is designed for two infant car seats and two infants.

NEVER use this product with one infant car seat only.

• Purses, shopping bags, parcels, diaper bags or accessory items may change the balance of the stroller and cause

hazardous unstable conditions.

• The maximum weight that can be carried in the storage basket is 10 lbs. The maximum weight for the parent tray is 3 lbs.

• Be certain the stroller is fully erect and latched in the open position before allowing a child near the stroller.

• Excessive weight may cause a hazardous unstable condition to exist. DO NOT EXCEED 80 lbs TOTAL.

• For use with two (2) children weighing no more than 30 pounds each, or a total weight of no more 80 pounds combined.

Exceeding 90 lbs will cause excessive wear and stress on the stroller and may cause a hazardous, unstable condition to

exist.

• NEVER use the stroller on stairways or escalators.

• NEVER allow your stroller to be used as a toy.

• To clean, use only mild household soap and warm water with a sponge or cloth.

• Check your stroller often for loose screws, worn parts, torn material or stitching. Replace or repair parts as needed.

• Discontinue use of stroller should it malfunction or become damaged. Please contact our customer service Parts Hotline

to arrange for repair or to obtain replacement parts.

Please: If you experience any difﬁculty with the use of our product or have a question regarding these instruc-

tions, please contact our Customer Service Department at 1-800-328-7363 between the hours of 8:00am and

4:30pm Paciﬁc Standard Time or visit us at www.babytrend.com. Please do not return the product to the store

as once it is returned it cannot be re-sold and the materials and energy used to make it are wasted.

Rear Axle

Parent Tray

Stroller

Front Wheels (x2)

PARTS

ASSEMBLING

TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE

INSTRUCTIONS CAREFULLY AND RETAIN THEM FOR FUTURE REFERENCE.

ASSEMBLY:

1. Remove stroller from box. NOTE: The front wheels, rear wheels, parent tray, and support bars specific to

your infant car seats need to be installed prior to use.

2. To attach the front wheels, unfold stroller and lean backwards so that it rests on the handle and rear frame

tubes with the front wheel tubes pointing upward. (Fig. 1) Position the front wheel assembly over the front tube

so that the large hole in the swivel assembly will slide onto the front tube. Carefully push the wheel assembly

until it locks onto the front leg. Tug on the wheel assembly to ensure that it is securely attached to the stroller.

(Fig. 2)

3. Lean the stroller forward to rest on the front wheels. To attach the rear wheels, position the rear axle and

wheel assembly so that the brake levers are facing the rear of the stroller. (Fig. 3.1) Press the rear wheel

assembly onto the rear frame tubes, being careful that the push buttons on the forward side of each rear tube

engage the hole on the forward side of each rear wheel housing. (Fig. 3.2) Tug on the rear wheel assembly to

ensure that it is securely attached to the stroller and firmly locked into place.

DO NOT use the stroller if the wheels are not locked into place, but rather contact our customer service

department immediately at 1-800-328-7363, between the hours of 8:00am and 4:30pm PST, for assistance.

Fig. 2

Fig. 1

Fig. 3

Push onto

bayonet

Line up the frame tubes

with the axle assembly

slide onto frame tubes

at the same time

Push down until axle

housing snaps into place

Axle housing is secure when

the metal tab locks axle

housing into place

1” Bar (x 2)

Flat Bar

BRAKES:

Fig. 6

Fig. 5

Fig. 4

Fig. A

• To engage brakes, apply light downward pressure to the brake lever

located on each rear wheel. The stroller may require slight forward or

rearward movement in order to line up the teeth on the brake with the

each wheel brake cluster. (Fig. 4) Check that the stroller will not move

and that the brakes are properly applied. To release, gently lift up on the

brake lever.

TO FOLD STROLLER:

DO NOT allow children near stroller while folding.

• The front section should be folded back to reduce the folded size of the

stroller. To fold the front frame, slide the plastic fittings forward then lift

upward on the frame. Rotate the front frame backwards, and rest on the

rear portion of the frame. (Fig. 8a & 8b)

• To fold the stroller slide the red small trigger on the top of the handle to the

left with your thumb, then squeeze the red large trigger while pushing

forward on the handle. (Fig. 5) Once the stroller begins to fold, release the

triggers and pull backward on the front of the frame until stroller is

folded. Secure the stroller in the folded position by latching the fold latch.

The fold latch is located on the right side of the stroller at the intersec-

tion of the handle and the rear tube, over the extended rivet located on

the lower frame tube. (Fig. 6)

WARNING:

DO NOT place hot liquids

in the parent tray. Hot liquids can burn your child.

Do not place more than 3 pounds in the tray as it may

cause a hazardous unstable condition to exist.

To attach the parent tray, position the tray so that the hinges for the

storage compartment are facing foward. Snap the parent tray to the

stand at the top of the frame. Check that the tray is securely latched in

place. Please see ﬁgure A.

WARNING:

ALWAY S USE the Infant

Car Seat harness to avoid serious injury from falling

or sliding out.

WARNING:

ALWAYS SET brakes when

the stroller is not being pushed so that the stroller will

not roll away. Never leave stroller unattended on a hill

or incline as the stroller may slide down the hill.

TO UNFOLDSTROLLER:

DO NOT allow children near stroller while unfolding.

1. Release the folding latch located on the right side.

2. Lift up on the stroller handle with both hands making sure the

stroller frame is erect and locks in the open position. (Fig. 7)

The stroller has spring-loaded latches on both sides of the

frame. Test that both latches are fully engaged prior to placing

your child in the stroller.

3. Extend the front frame by rotating it forward. (Fig. 8b). Slide the

two plastic fittings forward and then back so both latch securely

onto the front tubes of the stroller frame. (Fig. 8a)

TO ATTACH AN INFANT CAR SEAT:

1. Place car seats onto snap bars with stroller open and locked in

place. (Fig. 9) Please refer to the chart on next page for snap bars’

positions. (Fig. 12) NOTE: Some brands of infant car seats will

lock onto the snap bar, and some brands may simply rest on the

bar, you must ALWAYS use the safety belt to secure every car

seat that is placed on the Snap-N-Go.

2. Strap the safety belt over the carseat and connect the buckles

together. Tighten the strap so the car seat fits snug and can’t

move. (Fig. 10) NOTE: Some car seats have slots for the safety

belt to slide through, if you have a car seat with these slots

please feed the safety belt through each slot and secure. (Fig. 11)

WARNING:

Avoid serious injury

from falling, ALWAYS use the safety belt to

secure both of FRONT and REAR car seats.

WARNING:

When loading, car seat

in REAR position first, then 2nd car seat in

FRONT position. When unloading, remove

FRONT car seat first then REAR car seat second.

Fig. 7

Fig. 9

Fig. 8a

Fig. 8b

Fig. 10 Fig. 11 5

If you experience any difficulty with the use of our product or have a question regarding these

instructions, please contact our Customer Service Department at 1-800-328-7363 between the hours of

8:00 am and 4:30 pm (PST) or visit us online at www.babytrend.com. Please do not return to the store

as once it is returned it cannot be resold and the materials and energy used to make it are wasted.

8945

1” Bar (x 2)Flat Bar (x 1)

CAR SEAT

BABY TREND

BRITAX

CHICCO

EVENFLO

GRACO

PEG PEREGO

1” Bar Downwards

USE SAFETY BELTS TO SECURE CAR SEAT, NO SNAP BAR REQUIRE.

1” Bar Upwards

1” Bar Downwards

Hole “B”

Hole “C”

Hole “B”

Hole “C”

Hole “A”

Top Flip Bars

1” Bar Upwards

Top Flip Bars

1” Bar Upwards

Flat Bar

FRONT BAR LOCATION REAR BAR LOCATION

Hole “E”

Hole “D”

Fig. 12

SNAP BAR POSITION CHART

Flip Bars

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Paseante de Baby Trend

Baby Trend

Baby Trend ST04 Manual de usuario

Baby Trend

Baby Trend 7311 Manual de usuario

Baby Trend

Baby Trend Expedition ELX Manual de usuario

Baby Trend

Baby Trend XCEL-R8 PLUS JG94 B Series Manual de usuario

Baby Trend

Baby Trend Muv Tango Pro Travel Manual de usuario

Baby Trend

Baby Trend Skyview TS89C04B Manual de usuario

Baby Trend

Baby Trend Navigator DX60 Manual de usuario

Baby Trend

Baby Trend Mini Nursery Center PY02 A Series Manual de usuario

Baby Trend

Baby Trend Quick Step JG94C15M Manual de usuario

Baby Trend

Baby Trend WK14 C Series Manual de usuario

Baby Trend

Baby Trend TJ79 Manual de usuario

Baby Trend

Baby Trend Quick Step JG94 M Series Manual de usuario

Baby Trend

Baby Trend Sit N' Stand SS27 B Series Manual de usuario

Baby Trend

Baby Trend Safari 1866CT Manual de usuario

Baby Trend

Baby Trend EZ Ride Plus Travel System Manual de usuario

Baby Trend

Baby Trend Tri-Fold ST49A Manual de usuario

Baby Trend

Baby Trend Expedition DLX Jogger Travel System JC75... Manual de usuario

Baby Trend

Baby Trend Simply Smart PY75 A Series Manual de usuario

Baby Trend

Baby Trend TS42 A Series Manual de usuario

Baby Trend

Baby Trend TS12 D Series Manual de usuario

Baby Trend

Baby Trend Trendsport Traveler laurel oak Manual de usuario

Baby Trend

Baby Trend TS43 C Series Manual de usuario

Baby Trend

Baby Trend Stride Sport Manual de usuario

Baby Trend

Baby Trend Expedition Double Manual de usuario

Manuales populares de Paseante de otras marcas

Hauck

Hauck Priya Trioset Manual de usuario

CHILDHOME

CHILDHOME CWQDN Manual de usuario

Dreamer Design

Dreamer Design Rebound GST Manual de usuario

Britax

Britax STEELCRAFT AGILE Manual de usuario

Graco

Graco 7427 Manual de usuario

Comfort

Comfort COMPASS Manual de usuario

OBaby

OBaby Aura Manual de usuario

Tutek

Tutek Tirso Manual de usuario

Babify

Babify Dual Plus Manual de usuario

Graco

Graco Stroller Manual de usuario

Special Tomato

Special Tomato Jogger Manual de usuario

Chicco

Chicco CORTINA TOGETHER TWO-PASSENGER STROLLER Manual de usuario

Otto Bock

Otto Bock Kimba neo Manual de usuario

Milly Mally

Milly Mally ROYAL Guía de inicio rápido

Hauck

Hauck DUETT 3 PRAM Manual de usuario

BOB

BOB DUALLIE Manual de usuario

Nuna

Nuna Pepp Manual de usuario

Britax

Britax B2 Manual de usuario