AXIOMTEK GOT-812 Series Manual de usuario
GOT-812 Series
12.1" XGA/SVGA TFT IP66-rating Touch
Panel Computer
User’s Manual
ii
Disclaimers
This manual has been carefully checked and believed to contain
accurate information. AXIOMTEK Co., Ltd. assumes no responsibility
for any infringements of patents or any third party’s rights, and any
liability arising from such use.
AXIOMTEK does not warrant or assume any legal liability or
responsibility for the accuracy, completeness or usefulness of any
information in this document. AXIOMTEK does not make any
commitment to update the information in this manual.
AXIOMTEK reserves the right to change or revise this document
and/or product at any time without notice.
No part of this document may be reproduced, stored in a retrieval
system, or transmitted, in any form or by any means, electronic,
mechanical, photocopying, recording, or otherwise, without the prior
written permission of AXIOMTEK Co., Ltd.
©Copyright 2011 AXIOMTEK Co., Ltd.
All Rights Reserved
May 2011, Version A4
Printed in Taiwan
iii
Safety Approvals
CE Marking
IEC60945
FCC Class A
FCC Compliance
This equipment has been tested in compliance with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are meant to provide reasonable protection against harmful
interference in a residential installation. If not installed and used in
accordance with proper instructions, this equipment might generate or
radiate radio frequency energy and cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following methods:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment to another outlet of a circuit that
doesn’t connect with the receiver.
4. Consult the dealer or an experienced radio/TV technician for
help.
Shielded interface cables must be used in order to comply with the
emission limits.
NOTE The GOT-812 series is compliant by IEC60945, it
configures with GOT-812, +12VDC power adapter, COM
and USB by Keyboad and Mouse.
iv
Safety Precautions
Before getting started, please read the following important safety
precautions.
1. The GOT-812 Series does not come equipped with an
operating system. An operating system must be loaded first
before installing any software into the computer.
2. Be sure to ground yourself to prevent static charge when
installing the internal components. Use a grounding wrist
strap and place all electronic components in any static-
shielded devices. Most electronic components are sensitive
to static electrical charge.
3. Disconnect the power cord from the GOT-812 Series before
any installation. Be sure both the system and external
devices are turned OFF. A sudden surge of power could ruin
sensitive components that the GOT-812 Series must be
properly grounded.
4. The brightness of the flat panel display will be getting weaker
as a result of frequent usage. However, the operating period
varies depending on the application environment.
5. Turn OFF the system power before cleaning. Clean the
system using a cloth only. Do not spray any liquid cleaner
directly onto the screen. The GOT-812 Series may come
with or w/o a touchscreen. Although the touchscreen is
chemical resistant, it is recommended that you spray the
liquid cleaner on a cloth first before wiping the screen. In
case your system comes without the touchscreen, you must
follow the same procedure and not spray any cleaner on the
flat panel directly.
6. Avoid using sharp objects to operate the touchscreen.
Scratches on the touchscreen may cause malfunction or
internal failure to the touchscreen.
7. The flat panel display is not susceptible to shock or vibration.
When assembling the GOT-812 Series, make sure it is
securely installed.
8. Do not open the system’s back cover. If opening the cover
for maintenance is a must, only a trained technician is
allowed to do so. Integrated circuits on computer boards are
sensitive to static electricity. To avoid damaging chips from
electrostatic discharge, observe the following precautions:
v
zBefore handling a board or integrated circuit, touch an
unpainted portion of the system unit chassis for a few
seconds. This will help to discharge any static
electricity on your body.
zWhen handling boards and components, wear a wrist-
grounding strap, available from most electronic
component stores.
Trademarks Acknowledgments
AXIOMTEK is a trademark of AXIOMTEK Co., Ltd.
IBM, PC/AT, PS/2, VGA are trademarks of International
Business Machines Corporation.
Intel®and Atom™are registered trademarks of Intel Corporation.
MS-DOS, Microsoft C and Quick BASIC are trademarks of Microsoft
Corporation.
VIA is a trademark of VIA Technologies, Inc.
SST is a trademark of Silicon Storage Technology, Inc.
UMC is a trademark of United Microelectronics Corporation.
Other brand names and trademarks are the properties and registered
brands of their respective owners.
vi
Table of Contents
Disclaimers........................................................................ii
Safety Approvals .............................................................iii
Safety Precautions ..........................................................iv
CHAPTER 1 INTRODUCTION......................................... 1
1.1General Description..........................................1
1.2Specifications ...................................................2
1.2.1Main CPU Board........................................................ 2
1.2.2I/O System ................................................................. 3
1.2.3System Specification................................................ 3
1.3Dimensions .......................................................5
1.4I/O Outlets..........................................................7
1.5Package List......................................................8
CHAPTER 2 System Configurations ................................ 9
2.1I/O Pin Assignment...........................................9
2.1.1Serial Port Interface.................................................. 9
2.1.2Ethernet ................................................................... 11
2.2Water-proof Cables.........................................12
2.3Mounting Method............................................15
2.3.2VESA-ARM Mounting ............................................. 15
2.3.3Suspension Mounting ............................................ 16
2.4Keyboard Kit ...................................................19
CHAPTER 3 AMI BIOS SETUP UTILITY ..................... 22
3.1Starting............................................................22
3.2Navigation Keys..............................................22
3.3Main Menu.......................................................23
3.4Advanced Menu..............................................24
3.5PCI PnP Menu .................................................38
3.6Boot Menu.......................................................41
3.7Security Menu .................................................46
3.8Chipset Menu..................................................48
3.9Exit Menu.........................................................53
CHAPTER 4 DRIVERS INSTALLATION..................... 55
vii
4.1System.............................................................55
4.2Touch Screen..................................................56
4.2.1Specification ...................................................56
4.2.2Driver Installation- Windows XP ........................... 56
4.3Embedded O.S................................................60
4.3.1Windows XP Embedded......................................... 60
viii
MEMO
GOT-812 Series User’s Manual
Introduction 1
CHAPTER 1
INTRODUCTION
This chapter contains general information and detailed specifications
of the GOT-812 Series. Chapter 1 includes the following sections:
General Description
Specification
Dimensions
I/O Outlets
Package List
1.1 General Description
The GOT-812 Series is a fan-less and compact-size touch panel
computer, equipped with a 12.1” High brightness TFT LCD display
and low power consumption Intel○RAtomTM N270 1.6GHz processor
with FSB 533MHz. The GOT-812 Series supports Windows®XP,
Windows®7, Windows®CE.NET and Windows®XP embedded. The
panel computer is able to install a CompactFlash™and provided a
Mini card slot for extension such as WIFI. Its excellent ID and friendly
user interface make it a professional yet easy-to-use panel computer.
The GOT-812 Series is an ideal for space-limited applications in
factory automation, machine maker operating systems, building
automation, and more.
zGOT-812 Series: 12.1” TFT XGA/SVGA Fanless Touch
Panel Computer
¾Reliable and Stable Design
GOT-812 Series User’s Manual
Introduction
2
The GOT-812 Series adopts a fanless cooling system and a
CompactFlash™, which makes it suitable for vibration
environments, example for Marine and Crane.
¾Embedded O.S. Supported
The GOT-812 Series not only supports Windows®XP and
Windows®7, but also supports embedded OS, such as
Windows®CE.NET, and Windows®XP embedded. For storage
device, the GOT-815 Series supports CompactFlash™and 2.5”
SSD device.
¾Industrial-grade Product Design
The GOT-812 Series has an incredible design to be used in
different industrial environments.
zThe whole enclasure meets the IP66 standard.
zFor connecting other devices, the GOT-812 Series also features
several interfaces: USB, Ethernet, and RS-232/422/485.
1.2 Specifications
1.2.1 Main CPU Board
zCPU
Intel○RAtomTM N270 1.6GHz processor with FSB 533MHz
onboard
zSystem Chipset
945GSE + ICH7M
zBIOS
America Megatrends BIOS
zSystem Memory
One 200-pin DDR2 SO-DIMM socket
Tabla de contenidos
Otros manuales de Panel táctil de AXIOMTEK
AXIOMTEK
AXIOMTEK GOT-5571TL-621 Manual de usuario
AXIOMTEK
AXIOMTEK GOT318A-ELK-WCD Manual de usuario
AXIOMTEK
AXIOMTEK GOT3217W-845-PCT Manual de usuario
AXIOMTEK
AXIOMTEK GOT3217WL-845-PCT Manual de usuario
AXIOMTEK
AXIOMTEK P1177E-842 Manual de usuario
AXIOMTEK
AXIOMTEK GOT5152T-832 Manual de usuario
AXIOMTEK
AXIOMTEK GOT3187WL-834 Manual de usuario
AXIOMTEK
AXIOMTEK GOT321W-521 Manual de usuario
AXIOMTEK
AXIOMTEK GOT5840T-832 Manual de usuario
AXIOMTEK
AXIOMTEK GOT315WL-845-PCT Manual de usuario
AXIOMTEK
AXIOMTEK PANEL5150-675 Manual de usuario
AXIOMTEK
AXIOMTEK GOT710S-837-R-E3845-24-110VDC Manual de usuario
AXIOMTEK
AXIOMTEK GOT815L-511 Manual de usuario
AXIOMTEK
AXIOMTEK GOT3187W-834-PCT Manual de usuario
AXIOMTEK
AXIOMTEK GOT710-837 Manual de usuario
AXIOMTEK
AXIOMTEK FDK series Manual de usuario
AXIOMTEK
AXIOMTEK MPC175-873 Series Manual de usuario
AXIOMTEK
AXIOMTEK GOT107W-319 Manual de usuario
AXIOMTEK
AXIOMTEK GOT317-502-FR Manual de usuario
AXIOMTEK
AXIOMTEK OPS883 Series Manual de usuario
Manuales populares de Panel táctil de otras marcas
IBASE Technology
IBASE Technology ASTUT-152-RE1S Manual de usuario
YASKAWA
YASKAWA TP 610C Manual de usuario
B&R
B&R Power Panel C Series Manual de usuario
Beijer Electronics
Beijer Electronics X2 control Manual de usuario
TRIDONIC.ATCO
TRIDONIC.ATCO x-touchBOX Manual de usuario
Qomo
Qomo QIT1386 Manual de usuario
